參數資料
型號: CD1284
廠商: Intel Corp.
英文描述: IEEE 1284-Compatible Parallel Interface Controller with Two High-Speed Asynchronous Serial Ports
中文描述: 符合IEEE 1284兼容并行接口控制器兩個高速異步串行端口
文件頁數: 56/176頁
文件大小: 2255K
代理商: CD1284
CD1284
IEEE 1284-Compatible Parallel Interface Controller
56
Datasheet
As previously discussed, the send special character command is preemptive to data currently in the
transmit FIFO. The XOFF character is transmitted immediately after the current character and the
character in the Transmitter Holding register are sent (a maximum delay of two character times).
When the CPU is again ready to start receiving characters, the XON character is sent by another
send special character command. At this time, the CD1284 is issued the command to send the
character programmed in SCHR1.
Send special character commands override any flow-control by a remote of the CD1284. For
example, even if the CD1284 transmitter is shut off by the remote, it can still send flow control
characters.
The current state of the flow-control condition is always made available to the CPU through the
CCSR. In addition to the enabled/disabled status of the receiver and transmitter, the CCSR displays
the flow-control status.
Two bits in the CCSR pertain to receiver flow control, RxFloff and RxFlon. Whenever the CPU
issues the send special character 2 (send XOFF) command, the CD1284 sets the RxFloff bit,
indicating a request for the remote to stop transmission.
When the CPU issues the send special character 1 (send XON) command, RxFlon is set and
RxFloff reset. RxFlon remains set until the first character is received after XON is transmitted.
Table 15
shows the bit encoding for RxFloff and RxFlon.
RxFloff and RxFlon are cleared whenever the receiver is disabled or enabled, regardless of the
state of flow control when the disable/enable occurred.
Note:
Regardless of the current state of RxFloff, the CD1284 continues to receive characters. If the
remote ignores or is slow to respond to the XOFF character, there an overrun condition can occur.
5.6.2.1
Transmitter In-Band Flow Control
The CD1284 can automatically flow control its own transmitter when it receives the XON and
XOFF characters, as programmed in SCHR1 and SCHR2. There are control bits in COR2 and
COR3 to enable or disable various aspects of automatic flow control.
Special-character detection must be enabled through the SCD12 bit (COR3[4]) for flow-control
characters to be acted upon. When SCD12 is set, the CD1284 scans received characters for a match
with one of the special characters programmed in SCHR1
SCHR2.
Table 15. CCSR[6:5] Encoding
RxFloff
RxFlon
Encoded Status
0
0
Transmission resumes, the receiver is
enabled/disabled, or receiver is in the
default reset state.
0
1
XON is sent, but transmission has not
restarted.
1
0
XOFF was sent.
1
1
Not used.
相關PDF資料
PDF描述
CD13002 NPN SILICON PLANAR EPITAXIAL, HIGH VOLTAGE FAST SWITCHING POWER TRANSISTOR
CD14538 CMOS DUAL PRECISION MONOSTABLE MULTIVIBRATOR
CD14538BMS CMOS Dual Precision Monostable Multivibrator
CD15B-15MB CD105B
CD105B CD105B
相關代理商/技術參數
參數描述
CD-12AFFM-QL8D01 功能描述:MIDDLE 制造商:amphenol ltw 系列:* 零件狀態:在售 標準包裝:10
CD-12AFFM-QR8D01 功能描述:MIDDLE 制造商:amphenol ltw 系列:* 零件狀態:在售 標準包裝:10
CD-12AMMM-QL8D01 功能描述:MIDDLE 制造商:amphenol ltw 系列:* 零件狀態:在售 標準包裝:10
CD-12BFFA-LL7001 功能描述:MIDDLE 制造商:amphenol ltw 系列:* 零件狀態:在售 標準包裝:10
CD-12BFFA-QL8SP0 功能描述:CONN PLUG FMALE 12POS CRIMP 制造商:amphenol ltw 系列:X-Lok 包裝:散裝 零件狀態:在售 連接器類型:插頭,母型插口 針腳數:12(數據) 外殼尺寸 - 插件:C 外殼尺寸,MIL:- 安裝類型:自由懸掛 端接:壓接 緊固類型:推挽式 朝向:帶標記 侵入防護:IP68 - 防塵,防水 外殼材料,鍍層:聚酰胺(PA),尼龍,玻璃纖維增強型 觸頭鍍層:金 特性:后殼,應力消除 電壓 - 額定:- 額定電流:5A 觸頭鍍層厚度:- 工作溫度:-20°C ~ 80°C 標準包裝:1