- 您現在的位置：買賣IC網 > PDF目錄379851 > CDK8920A (Cirrus Logic, Inc.) CRYSTAL LAN ISA PLUG-AND-PLAY ETHERNET CONTROLLER PDF資料下載
參數資料
| 型號： | CDK8920A |
| 廠商： | Cirrus Logic, Inc. |
| 英文描述： | CRYSTAL LAN ISA PLUG-AND-PLAY ETHERNET CONTROLLER |
| 中文描述： | 水晶藍的ISA即插即用，即插即用以太網控制器 |
| 文件頁數： | 83/144頁 |
| 文件大?。?/td> | 1229K |
| 代理商： | CDK8920A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁當前第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁
4.11.4
Basic Memory Mode Receive
Memory Mode receive operations occur in the
following order (interrupts used to signal the
presence of a valid receive frame):
1.A frame is received by the CS8920A, trigger-
ing an enabled interrupt.
2.The host reads the Interrupt Status Queue
(memory base + 0120h) and is informed of the
receive frame.
3.The host reads RxStatus (memory base +
0400h) to learn the status of the receive frame.
4.The host reads RxLength (memory base +
0402h) to learn the frame’s length.
5.The host reads the frame data by executing re-
petitive memory-to-memory move instructions
(REP MOVS) from memory base + 0404h to
transfer the entire frame from CS8920A mem-
ory to host memory.
For a more detailed description of receive, see
Section 5.2.
4.11.5
Polling the CS8920A in Memory Mode
If interrupts are not used, the host can poll the
CS8920A to check if receive frames are present
and if memory space is available for transmit.
However, this is beyond the scope of this data
sheet.
4.12
I/O Space Operation
In I/O Mode, PacketPage memory is accessed
through eight 16-bit I/O ports that are mapped
into 16 contiguous I/O locations in the host sys-
tem’s I/O space. I/O Mode is the default
configuration for the CS8920A and is always en-
abled. On power up, the default value of the I/O
base address is set at 300h. (Note that 300h is
typically assigned to LAN peripherals). The I/O
base address may be changed to any available
XXX0h location, either by loading configuration
data from the EEPROM, or during system setup.
Table 4.5 shows the CS8920A I/O Mode map-
ping:
Receive/Transmit Data Ports 0 and 1
These two ports are used when transferring trans-
mit data to the CS8920A and receive data from
the CS8920A. Port 0 is used for 16-bit opera-
tions and Ports 0 and 1 are used for 32-bit
operations (lower-order word in Port 0).
TxCMD Port
The host writes the Transmit Command
(TxCMD) to this port at the start of each trans-
mit operation. The Transmit Command tells the
CS8920A that the host has a frame to be trans-
mitted as well as how that frame should be
transmitted. This port is mapped into PacketPage
base + 0144h. See Register 9 in Section 4.4 for
more information.
TxLength Port
The length of the frame to be transmitted is writ-
ten here immediately after the Transmit
Offset
0000h Read/Write Receive/Transmit Data (Port 0)
0002h Read/Write Receive/Transmit Data (Port 1)
0004h
Write-only
TxCMD (Transmit Command)
0006h
Write-only
TxLength (Transmit Length)
0008h
Read-only
Interrupt Status Queue
000Ah Read/Write
000Ch Read/Write
PacketPage Data (Port 0)
000Eh Read/Write
PacketPage Data (Port 1)
Type
Description
PacketPage Pointer
Table 4.5. I/O Mode Mapping
CS8920A
DS238PP2
83
相關PDF資料 |
PDF描述 |
|---|---|
| CDL13005 | NPN PLASTIC POWER TRANSISTOR |
| CDLL4150-1 | SWITCHING DIODE |
| CDLL4567A | Single Schmitt-Trigger Inverter 5-SOT-23 -40 to 85 |
| CDLL4568 | TEMPERATURE COMPENSATED ZENER REFERENCE DIODES |
| CDLL4568A | Single Schmitt-Trigger Inverter 5-SC70 -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CDKEIL | 功能描述:開發軟件 Devel Software and Documention CD RoHS:否 制造商:Atollic Inc. 產品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors |
| CDKEIL-US | 功能描述:開發軟件 DEVELOPMENT SOFTWARE AND DOCUMENTATION CD RoHS:否 制造商:Atollic Inc. 產品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors |
| CDKWM1804-S-1 | 功能描述:WM1804 - Audio, Audio Processing Evaluation Board 制造商:cirrus logic inc. 系列:- 零件狀態:有效 主要用途:音頻，音頻處理 嵌入式:- 使用的 IC/零件:WM1804 主要屬性:- 輔助屬性:- 所含物品:板 標準包裝:1 |
| CDKWM1811A-S-1 | 功能描述:WM1811A - Audio, CODEC Evaluation Board 制造商:cirrus logic inc. 系列:- 零件狀態:有效 主要用途:音頻編解碼器 嵌入式:- 使用的 IC/零件:WM1811A 主要屬性:- 輔助屬性:- 所含物品:板 標準包裝:1 |
| CDKWM5102-S-1 | 功能描述:WM5102 - Audio, CODEC Evaluation Board 制造商:cirrus logic inc. 系列:- 零件狀態:有效 主要用途:音頻編解碼器 嵌入式:- 使用的 IC/零件:WM5102 主要屬性:- 輔助屬性:- 所含物品:板 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。