- 您現在的位置：買賣IC網 > PDF目錄379851 > CDK8920A (Cirrus Logic, Inc.) CRYSTAL LAN ISA PLUG-AND-PLAY ETHERNET CONTROLLER PDF資料下載
參數資料
| 型號： | CDK8920A |
| 廠商： | Cirrus Logic, Inc. |
| 英文描述： | CRYSTAL LAN ISA PLUG-AND-PLAY ETHERNET CONTROLLER |
| 中文描述： | 水晶藍的ISA即插即用，即插即用以太網控制器 |
| 文件頁數： | 37/144頁 |
| 文件大?。?/td> | 1229K |
| 代理商： | CDK8920A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁當前第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁
the CS8920A automatically corrects a reversal. If
the PolarityDis bit is set, the CS8920A does not
correct a reversal. The PolarityOK bit and the
PolarityDis bit are independent.
To detect a reversed pair, the receiver examines
received link pulses and the End-of-Frame
(EOF) sequence of incoming packets. If it de-
tects at least one reversed link pulse and at least
four frames in a row with negative polarity after
the EOF, the receive pair is considered reversed.
Any data received before the correction of the
reversal is ignored.
Collision Detection
If half-duplex operation is selected (Register 1D,
Bit E, ForceFDX), the CS8920A detects a
10BASE-T collision whenever the receiver and
transmitter are active simultaneously. When a
collision is present, the Collision Detection cir-
cuit informs the MAC by asserting the internal
Collision signal (see section 3.11 for collision
handling).
3.13
Attachment Unit Interface (AUI)
The CS8920A Attachment Unit Interface (AUI)
provides a direct interface to external 10BASE2,
10BASE5, and 10BASE-FL Ethernet transceiv-
ers. It is fully compliant with Section 7 of the
Ethernet standard (ISO/IEC 8802-3), and as
such, is capable of driving a full 50-meter AUI
cable.
The AUI consists of three pairs of signals: Data
Out (DO+/DO-), Data In (DI+/DI-), and Colli-
sion In (CI+/CI-). To select the AUI, the host
should set the AUI bit (Register 13, LineCTL,
Bit 8). The AUI can also be selected automat-
ically as described in the previous section.
Figure 3.12 provides a block diagram of the
AUI. (For a connection diagram, see section
12.0).
AUI Transmitter
The AUI transmitter is a differential driver de-
signed to drive a 78 ohm cable. It accepts data
from the ENDEC and transmits it directly on the
DO+/DO- pins. After transmission has started,
the CS8920A expects to see the packet "looped-
back" (or echoed) to the receiver, causing the
Carrier Sense signal to be asserted. This Carrier
Sense presence indicates that the transmit signal
is getting through to the transceiver. If the Car-
rier Sense signal remains de-asserted throughout
the transmission, or if the Carrier Sense signal is
de-asserted before the end of the transmission,
there is a Loss-of-Carrier error and the Loss-of-
CRS bit (Register 8, TxEvent, Bit 6) is set.
AUI Receiver
The AUI receiver is a differential pair circuit that
connects directly to the DI+/DI- pins. It is de-
signed to distinguish between transient noise
pulses and incoming Ethernet packets. Incoming
packets with proper amplitude and pulse width
are passed on to the ENDEC section, while un-
wanted noise is rejected.
Collision Detection
The AUI collision circuit is a differential pair re-
ceiver that detects the presence of collision
signals on the CI+/CI- pins. The collision signal
is generated by an external Ethernet transceiver
whenever a collision is detected on the Ethernet
DI+
DI-
DO+
DO-
ENDEC
CI+
CI-
Collision
Detect
AUICol (to MAC)
AUIRX
AUISQL
AUITX
AUI
-
+
-
+
Figure 3.12. AUI
CS8920A
DS238PP2
37
相關PDF資料 |
PDF描述 |
|---|---|
| CDL13005 | NPN PLASTIC POWER TRANSISTOR |
| CDLL4150-1 | SWITCHING DIODE |
| CDLL4567A | Single Schmitt-Trigger Inverter 5-SOT-23 -40 to 85 |
| CDLL4568 | TEMPERATURE COMPENSATED ZENER REFERENCE DIODES |
| CDLL4568A | Single Schmitt-Trigger Inverter 5-SC70 -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CDKEIL | 功能描述:開發軟件 Devel Software and Documention CD RoHS:否 制造商:Atollic Inc. 產品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors |
| CDKEIL-US | 功能描述:開發軟件 DEVELOPMENT SOFTWARE AND DOCUMENTATION CD RoHS:否 制造商:Atollic Inc. 產品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors |
| CDKWM1804-S-1 | 功能描述:WM1804 - Audio, Audio Processing Evaluation Board 制造商:cirrus logic inc. 系列:- 零件狀態:有效 主要用途:音頻，音頻處理 嵌入式:- 使用的 IC/零件:WM1804 主要屬性:- 輔助屬性:- 所含物品:板 標準包裝:1 |
| CDKWM1811A-S-1 | 功能描述:WM1811A - Audio, CODEC Evaluation Board 制造商:cirrus logic inc. 系列:- 零件狀態:有效 主要用途:音頻編解碼器 嵌入式:- 使用的 IC/零件:WM1811A 主要屬性:- 輔助屬性:- 所含物品:板 標準包裝:1 |
| CDKWM5102-S-1 | 功能描述:WM5102 - Audio, CODEC Evaluation Board 制造商:cirrus logic inc. 系列:- 零件狀態:有效 主要用途:音頻編解碼器 嵌入式:- 使用的 IC/零件:WM5102 主要屬性:- 輔助屬性:- 所含物品:板 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。