- 您現在的位置：買賣IC網 > PDF目錄379851 > CDK8920A (Cirrus Logic, Inc.) CRYSTAL LAN ISA PLUG-AND-PLAY ETHERNET CONTROLLER PDF資料下載
參數資料
| 型號： | CDK8920A |
| 廠商： | Cirrus Logic, Inc. |
| 英文描述： | CRYSTAL LAN ISA PLUG-AND-PLAY ETHERNET CONTROLLER |
| 中文描述： | 水晶藍的ISA即插即用，即插即用以太網控制器 |
| 文件頁數： | 118/144頁 |
| 文件大小： | 1229K |
| 代理商： | CDK8920A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁當前第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁
The ISA bus transitions from powered up to
powered down. When the ISA bus is being
powered down and is decaying to ground, the
ISA reset signal may be asserted. At this
time, the CS8920A will reset. Therefore, be-
fore powering down the ISA bus, the
CS8920A EEPROM should be configured to
allow the CS8920A to be activated in wait-
ing-for-wakeup-frame state.
Note that a "CTRL-ALT-DEL" does not reset the
ISA bus.
During the RESET state, the CS8920A does an
internal hardware reset, ignores all incoming
frames, and reads the EEPROM, includng the
burned-in IEEE address. During reset, the
CS8920A also shuts off the CS8920A ISA bus
drivers. The drivers remain off until MEMR and
MEMW and IOR have all gone high. Also, the
CS8920A does not allow ISA accesses before
EEPROM initialization.
Based on the state of the ISA bus (powered or
not powered), and based on the state of the
WakeupEN bit as read from the EEPROM, the
CS8920A will exit the RESET state and enter
one of the NORMAL, STANDBY, SUSPEND,
or DROPPING PACKETS states, as shown be-
low.
SUSPEND State
In the SUSPEND state, the ISA bus is powered
down, and the WakeupEN bit is set to 1. Typi-
cally, the CPU and chipset clocks will also be
stopped. In this state, the CS8920A remains
powered, discards all non-wakeup frames, and
shuts off the CS8920A ISA bus drivers.
Upon wakeup frame recognition, the CS8920A
generates a signal on the EWAKE pin that can be
connected by jumper to the system power man-
ager. An EWAKE output signal will be a logic
high for approximately 50 to 55 ms. The system
power manager function can then wake up the
system.
After generating the EWAKE signal, the
CS8920A checks that the ISA bus is still pow-
ered off, and that there is no reset request. If
these conditions are true, the CS8920A returns to
the SUSPEND state. Otherwise, the CS8920A
enters the RESET state. Note that the CS8920A
determines that the ISA bus is powered by look-
ing for MEMR and MEMW and IOR bus signals
being simultaneously low.
In a system with a powered down ISA bus, inter-
rupts must not be enabled (via loading register
17, BusCTL register, bit F from the EEPROM).
STANDBY State
In the STANDBY state, the ISA bus is powered
up, and the CPU is typically operating at a low
clock rate to save power. This state is entered
when either:
the CS8920A is in NORMAL state, and the
software sets WakeupEN bit to 1; or
while in RESET state, the CS8920A detects
that the ISA bus is powered and the Wakeu-
pEN bit is set to 1 by the EEPROM.
In this state, the CS8920A is powered up, looks
for wakeup frame, and discards all other frames.
Upon wakeup frame recognition, the CS8920A
can wake up the CPU using either just the
EWAKE pin, or a combination of the EWAKE
pin and an ISA-bus interrupt.
State Entered
WakeupEN bit
from EEPROM
0
0
ISA bus
NORMAL
DROPPING
PACKET
SUSPEND
STANDBY
powered
not powered
1
1
not powered
powered
CS8920A
118
DS238PP2
相關PDF資料 |
PDF描述 |
|---|---|
| CDL13005 | NPN PLASTIC POWER TRANSISTOR |
| CDLL4150-1 | SWITCHING DIODE |
| CDLL4567A | Single Schmitt-Trigger Inverter 5-SOT-23 -40 to 85 |
| CDLL4568 | TEMPERATURE COMPENSATED ZENER REFERENCE DIODES |
| CDLL4568A | Single Schmitt-Trigger Inverter 5-SC70 -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CDKEIL | 功能描述:開發軟件 Devel Software and Documention CD RoHS:否 制造商:Atollic Inc. 產品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors |
| CDKEIL-US | 功能描述:開發軟件 DEVELOPMENT SOFTWARE AND DOCUMENTATION CD RoHS:否 制造商:Atollic Inc. 產品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors |
| CDKWM1804-S-1 | 功能描述:WM1804 - Audio, Audio Processing Evaluation Board 制造商:cirrus logic inc. 系列:- 零件狀態:有效 主要用途:音頻，音頻處理 嵌入式:- 使用的 IC/零件:WM1804 主要屬性:- 輔助屬性:- 所含物品:板 標準包裝:1 |
| CDKWM1811A-S-1 | 功能描述:WM1811A - Audio, CODEC Evaluation Board 制造商:cirrus logic inc. 系列:- 零件狀態:有效 主要用途:音頻編解碼器 嵌入式:- 使用的 IC/零件:WM1811A 主要屬性:- 輔助屬性:- 所含物品:板 標準包裝:1 |
| CDKWM5102-S-1 | 功能描述:WM5102 - Audio, CODEC Evaluation Board 制造商:cirrus logic inc. 系列:- 零件狀態:有效 主要用途:音頻編解碼器 嵌入式:- 使用的 IC/零件:WM5102 主要屬性:- 輔助屬性:- 所含物品:板 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。