- 您現在的位置：買賣IC網 > PDF目錄1961 > PI7C8154BNAIE (Pericom)IC PCI-PCI BRIDGE ASYNC 304-PBGA PDF資料下載
參數資料
| 型號： | PI7C8154BNAIE |
| 廠商： | Pericom |
| 文件頁數： | 76/114頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PCI-PCI BRIDGE ASYNC 304-PBGA |
| 產品變化通告： | Product Discontinuation Notice 22/Jan/2010 |
| 標準包裝： | 27 |
| 系列： | * |
| 應用： | * |
| 接口： | * |
| 電源電壓： | * |
| 封裝/外殼： | 304-BBGA |
| 供應商設備封裝： | 304-PBGA（31x31） |
| 包裝： | 管件 |
| 安裝類型： | 表面貼裝 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁當前第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁
PI7C8154B
ASYNCHRONOUS 2-PORT
PCI-to-PCI BRIDGE
Advance Information
Page 64 of 114
JUNE 2008 REVISION 1.1
6.2.2
LOCKED TRANSACTION IN UPSTREAM DIRECTION
The bridge ignores upstream lock and transactions. The bridge will pass these transactions as
normal transactions without lock established.
6.3
ENDING EXCLUSIVE ACCESS
After the lock has been acquired on both initiator and target buses, the bridge must maintain the
lock on the target bus for any subsequent locked transactions until the initiator relinquishes the
lock.
The only time a target-retry causes the lock to be relinquished is on the first transaction of a locked
sequence. On subsequent transactions in the sequence, the target retry has no effect on the status of
the lock signal.
An established target lock is maintained until the initiator relinquishes the lock. The bridge does
not know whether the current transaction is the last one in a sequence of locked transactions until
the initiator de-asserts the LOCK# signal at end of the transaction.
When the last locked transaction is a delayed transaction, the bridge has already completed the
transaction on the target bus. In this example, as soon as the bridge detects that the initiator has
relinquished the LOCK# signal by sampling it in the de-asserted state while FRAME# is de-
asserted, the bridge de-asserts the LOCK# signal on the target bus as soon as possible. Because of
this behavior, LOCK# may not be de-asserted until several cycles after the last locked transaction
has been completed on the target bus. As soon as the bridge has de-asserted LOCK# to indicate the
end of a sequence of locked transactions, it resumes forwarding unlocked transactions.
When the last locked transaction is a posted write transaction, the bridge de-asserts LOCK# on the
target bus at the end of the transaction because the lock was relinquished at the end of the write
transaction on the initiator bus.
When the bridge receives a target abort or a master abort in response to a locked delayed
transaction, the bridge returns a target abort or a master abort when the initiator repeats the locked
transaction. The initiator must then de-assert LOCK# at the end of the transaction. The bridge sets
the appropriate status bits, flagging the abnormal target termination condition (see Section 2.11).
Normal forwarding of unlocked posted and delayed transactions is resumed.
When PI7C8154B receives a target abort or a master abort in response to a locked posted write
transaction, PI7C8154B cannot pass back that status to the initiator. PI7C8154B asserts SERR# on
the initiator bus when a target abort or a master abort is received during a locked posted write
transaction, if the SERR# enable bit is set in the command register. Signal SERR# is asserted for
the master abort condition if the master abort mode bit is set in the bridge control register (see
Section 5.4).
7
PCI BUS ARBITRATION
The bridge must arbitrate for use of the primary bus when forwarding upstream transactions. Also,
it must arbitrate for use of the secondary bus when forwarding downstream transactions. The
arbiter for the primary bus resides external to the bridge, typically on the motherboard. For the
相關PDF資料 |
PDF描述 |
|---|---|
| PI7C9X110BNBE | IC PCIE TO PCI REV BRG 160LFBGA |
| PI7C9X130DNDE | IC PCIE-PCIX BRIDGE 1PORT 256BGA |
| PI7C9X20303SLCFDE | IC PCIE PACKET SWITCH 128LQFP |
| PI7C9X20303ULAZPE | IC PCIE PACKET SWITCH 132TQFN |
| PI7C9X20404GPBNBE | IC PCIE PACKET SWITCH 148LFBGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PI7C8154EVB | 功能描述:界面開發工具 64B/66MHz 2 Port PCI Bridge Eval Brd RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| PI7C8154NA-33 | 制造商:PERICOM 功能描述: |
| PI7C81552 | 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:ENHANCED 2-PORT PCI TO PCI BRIDGE INTEL 21152 COMPARISON |
| PI7C81552A | 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:ENHANCED 2-PORT PCI TO PCI BRIDGE INTEL 21152 COMPARISON |
| PI7C9X110 | 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:PCI Express-to-PCI Reversible Bridge |
發布緊急采購，3分鐘左右您將得到回復。