- 您現在的位置：買賣IC網 > PDF目錄1961 > PI7C8154ANAE (Pericom)IC PCI-PCI BRIDGE ASYNC 304-PBGA PDF資料下載
參數資料
| 型號： | PI7C8154ANAE |
| 廠商： | Pericom |
| 文件頁數： | 78/114頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PCI-PCI BRIDGE ASYNC 304-PBGA |
| 標準包裝： | 27 |
| 系列： | * |
| 應用： | * |
| 接口： | * |
| 電源電壓： | * |
| 封裝/外殼： | 304-BBGA |
| 供應商設備封裝： | 304-PBGA（31x31） |
| 包裝： | 管件 |
| 安裝類型： | 表面貼裝 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁當前第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁
PI7C8154A
ASYNCHRONOUS 2-PORT
PCI-to-PCI BRIDGE
Advance Information
Page 66 of 114
DEC 2009 REVISION 1.02
Figure 7-1 SECONDARY ARBITER EXAMPLE
Each bus master, including PI7C8154A, can be configured to be in either the low priority group or
the high priority group by setting the corresponding priority bit in the arbiter-control register. The
arbiter-control register is located at offset 40h. Each master has a corresponding bit. If the bit is set
to 1, the master is assigned to the high priority group. If the bit is set to 0, the master is assigned to
the low priority group. If all the masters are assigned to one group, the algorithm defaults to a
straight rotating priority among all the masters. After reset, all external masters are assigned to the
low priority group, and PI7C8154A is assigned to the high priority group. PI7C8154A receives
highest priority on the target bus every other transaction and priority rotates evenly among the
other masters.
Priorities are re-evaluated every time S_FRAME# is asserted at the start of each new transaction on
the secondary PCI bus. From this point until the time that the next transaction starts, the arbiter
asserts the grant signal corresponding to the highest priority request that is asserted. If a grant for a
particular request is asserted, and a higher priority request subsequently asserts, the arbiter de-
asserts the asserted grant signal and asserts the grant corresponding to the new higher priority
request on the next PCI clock cycle. When priorities are re-evaluated, the highest priority is
assigned to the next highest priority master relative to the master that initiated the previous
transaction. The master that initiated the last transaction now has the lowest priority in its group.
If PI7C8154A detects that an initiator has failed to assert S_FRAME# after 16 cycles of both grant
assertion and a secondary idle bus condition, the arbiter de-asserts the grant.
To prevent bus contention, if the secondary PCI bus is idle, the arbiter never asserts one grant
signal in the same PCI cycle in which it de-asserts another. It de-asserts one grant and asserts the
next grant, no earlier than one PCI clock cycle later. If the secondary PCI bus is busy, that is,
S_FRAME# or S_IRDY# is asserted, the arbiter can be de-asserted one grant and asserted another
grant during the same PCI clock cycle.
7.2.2
PREEMPTION
Preemption can be programmed to be either on or off, with the default to on (offset 4Ch, bit 31=0).
Time-to-preempt can be programmed to 0, 1, 2, 4, 8, 16, 32, or 64 (default is 0) clocks. If the
current master occupies the bus and other masters are waiting, the current master will be preempted
by removing its grant (GNT#) after the next master waits for the time-to-preempt.
m1
m2
m0
m3
m4
m6
m7
m8
B
lpg
m5
lpg:
low priority group
B:
PI7C8154A
Mx:
bus master
相關PDF資料 |
PDF描述 |
|---|---|
| PI7C8154BNAIE | IC PCI-PCI BRIDGE ASYNC 304-PBGA |
| PI7C9X110BNBE | IC PCIE TO PCI REV BRG 160LFBGA |
| PI7C9X130DNDE | IC PCIE-PCIX BRIDGE 1PORT 256BGA |
| PI7C9X20303SLCFDE | IC PCIE PACKET SWITCH 128LQFP |
| PI7C9X20303ULAZPE | IC PCIE PACKET SWITCH 132TQFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PI7C8154ANAE-33 | 功能描述:外圍驅動器與原件 - PCI 64B/66MHz 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| PI7C8154B | 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:2 PORT 64 BIT 66MHZ PCI TO PCI BRIDGE |
| PI7C8154BNA | 制造商:Pericom Semiconductor Corporation 功能描述: |
| PI7C8154BNAE | 功能描述:外圍驅動器與原件 - PCI 64B/66MHz 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| PI7C8154BNAE-80 | 功能描述:外圍驅動器與原件 - PCI 64B/66MHz 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。