Advance Information Page 46 of 114 DEC 2009 REVISION 1.02 Accordingly, if the ISA enable bit is" />
參數資料
型號: PI7C8154ANAE
廠商: Pericom
文件頁數: 56/114頁
文件大?。?/td> 0K
描述: IC PCI-PCI BRIDGE ASYNC 304-PBGA
標準包裝: 27
系列: *
應用: *
接口: *
電源電壓: *
封裝/外殼: 304-BBGA
供應商設備封裝: 304-PBGA(31x31)
包裝: 管件
安裝類型: 表面貼裝
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁當前第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁
PI7C8154A
ASYNCHRONOUS 2-PORT
PCI-to-PCI BRIDGE
Advance Information
Page 46 of 114
DEC 2009 REVISION 1.02
Accordingly, if the ISA enable bit is set, PI7C8154A forwards upstream those I/O transactions
addressing the top 768 bytes of each aligned 1KB block within the first 64KB of I/O space. The
master enable bit in the command configuration register must also be set to enable upstream
forwarding. All other I/O transactions initiated on the secondary bus are forwarded upstream only if
they fall outside the I/O address range.
When the ISA enable bit is set, devices downstream of PI7C8154A can have I/O space mapped
into the first 256 bytes of each 1KB chunk below the 64KB boundary, or anywhere in I/O space
above the 64KB boundary.
3.3
MEMORY ADDRESS DECODING
PI7C8154A has three mechanisms for defining memory address ranges for forwarding of memory
transactions:
Memory-mapped I/O base and limit address registers
Prefetchable memory base and limit address registers
VGA mode
This section describes the first two mechanisms. Section 3.4.1 describes VGA mode. To enable
downstream forwarding of memory transactions, the memory enable bit must be set in the
command register in configuration space. To enable upstream forwarding of memory transactions,
the master-enable bit must be set in the command register. The master-enable bit also allows
upstream forwarding of I/O transactions if it is set.
CAUTION
If any configuration state affecting memory transaction forwarding is changed by a configuration
write operation on the primary bus at the same time that memory transactions are ongoing on the
secondary bus, response to the secondary bus memory transactions is not predictable. Configure
the memory-mapped I/O base and limit address registers, prefetchable memory base and limit
address registers, and VGA mode bit before setting the memory enable and master enable bits, and
change them subsequently only when the primary and secondary PCI buses are idle.
3.3.1
MEMORY-MAPPED I/O BASE AND LIMIT ADDRESS REGISTERS
Memory-mapped I/O is also referred to as non-prefetchable memory. Memory addresses that
cannot automatically be pre-fetched but that can be conditionally pre-fetched based on command
type should be mapped into this space. Read transactions to non-prefetchable space may exhibit
side effects; this space may have non-memory-like behavior. PI7C8154A prefetches in this space
only if the memory read line or memory read multiple commands are used; transactions using the
memory read command are limited to a single data transfer.
The memory-mapped I/O base address and memory-mapped I/O limit address registers define an
address range that PI7C8154A uses to determine when to forward memory commands. PI7C8154A
forwards a memory transaction from the primary to the secondary interface if the transaction
address falls within the memory-mapped I/O address range. PI7C8154A ignores memory
transactions initiated on the secondary interface that fall into this address range. Any transactions
that fall outside this address range are ignored on the primary interface and are forwarded upstream
from the secondary interface (provided that they do not fall into the prefetchable memory range or
are not forwarded downstream by the VGA mechanism).
相關PDF資料
PDF描述
PI7C8154BNAIE IC PCI-PCI BRIDGE ASYNC 304-PBGA
PI7C9X110BNBE IC PCIE TO PCI REV BRG 160LFBGA
PI7C9X130DNDE IC PCIE-PCIX BRIDGE 1PORT 256BGA
PI7C9X20303SLCFDE IC PCIE PACKET SWITCH 128LQFP
PI7C9X20303ULAZPE IC PCIE PACKET SWITCH 132TQFN
相關代理商/技術參數
參數描述
PI7C8154ANAE-33 功能描述:外圍驅動器與原件 - PCI 64B/66MHz 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
PI7C8154B 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:2 PORT 64 BIT 66MHZ PCI TO PCI BRIDGE
PI7C8154BNA 制造商:Pericom Semiconductor Corporation 功能描述:
PI7C8154BNAE 功能描述:外圍驅動器與原件 - PCI 64B/66MHz 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
PI7C8154BNAE-80 功能描述:外圍驅動器與原件 - PCI 64B/66MHz 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray