參數資料
型號： CD1283
廠商： Intel Corp.
英文描述： IEEE 1284-Compatible Parallel Interface
中文描述： 符合IEEE 1284兼容并行接口
文件頁數： 42/94頁
文件大小： 1237K
代理商： CD1283
CD1283
—
IEEE 1284-Compatible Parallel Interface
42
Datasheet
5.8
General-Purpose I/O Port
The CD1283 provides an 8-bit general-purpose port (GP[7:0]) used to control or give status of
external functions. Each of the eight signals are individually programmable for direction, so the
port can be comprised of any number of inputs and outputs. Each port signal is implemented with a
standard, bidirectional HCMOS pad and is fully TTL compatible. The port is controlled through
two internal registers
—
GPDIR and GPIO.
Each bit in the GPDIR sets the direction of the corresponding bit in the GPIO;
‘
1
’
sets the signal as
output, and
‘
0
’
sets it as input. When writing to the GPIO, only the bits programmed as outputs are
affected by the contents of the data bus. When reading the GPIO, bits programmed as inputs reflect
the true state of the condition of the external pin; bits programmed as outputs reflect the state of the
last value written to the register and the current state of the output pins.
At reset, all bits in the GPIO are cleared and the signals are programmed as inputs.
Note:
Interrupts are not generated on signal changes within the General-Purpose I/O port; the CPU must
periodically poll GPIO to detect changes in external conditions. Therefore, if it is necessary to
detect changes, use the port with signals that change with low-duty cycles.
5.9
Parallel Port Interface
The CD1283 parallel port signals are implemented with Level-2 characteristics, as defined in the
IEEE Std 1284-1994 specification with the exception of transient protection. As such, the port can
be directly connected to the interface cable with the addition of a few external components. The
components consist of passive pull-up resistors, series impedance matching resistors, and clipping
diodes. Additional noise filtering may be required in an end system.
Figure 10
illustrates a typical
interface with the components listed above.
Some system designs may require buffers between the CD1283 and the cable. Systems that require
drive cables longer than the specified maximum of 10 m or those that need to protect the CD1283
require inexpensive buffers between it and the cable. The device provides two signal outputs,
PDBEN and EBDIR, for connecting and controlling buffers (such as, 74AS245 or equivalent).
These signals do not allow direct control of the buffer. However, the addition of an XNOR gate
provides both an enable control signal and a signal to select the direction of the buffer. PDBEN and
EBDIR are outputs from the control state machine that indicate its current state (see
Figure 11 on
page 44
).
Table 7. System Clock Setup
CLK Freq.
(MHz)
Time/Tic
(ns)
SPR Value
T
P
Width
16
62.5
8
500
20
50
10
500
25
40
13
520
相關PDF資料
PDF描述
CD1284 IEEE 1284-Compatible Parallel Interface Controller with Two High-Speed Asynchronous Serial Ports
CD13002 NPN SILICON PLANAR EPITAXIAL, HIGH VOLTAGE FAST SWITCHING POWER TRANSISTOR
CD14538 CMOS DUAL PRECISION MONOSTABLE MULTIVIBRATOR
CD14538BMS CMOS Dual Precision Monostable Multivibrator
CD15B-15MB CD105B
相關代理商/技術參數
參數描述
CD1284 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:IEEE 1284-Compatible Parallel Interface Controller with Two High-Speed Asynchronous Serial Ports
CD-12AFFM-QL8D01 功能描述:MIDDLE 制造商:amphenol ltw 系列:* 零件狀態:在售 標準包裝:10
CD-12AFFM-QR8D01 功能描述:MIDDLE 制造商:amphenol ltw 系列:* 零件狀態:在售 標準包裝:10
CD-12AMMM-QL8D01 功能描述:MIDDLE 制造商:amphenol ltw 系列:* 零件狀態:在售 標準包裝:10
CD-12BFFA-LL7001 功能描述:MIDDLE 制造商:amphenol ltw 系列:* 零件狀態:在售 標準包裝:10
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*