- 您現在的位置：買賣IC網 > PDF目錄363841 > OR4E02-2BM680I FPGA PDF資料下載
參數資料
| 型號： | OR4E02-2BM680I |
| 英文描述： | FPGA |
| 中文描述： | FPGA的 |
| 文件頁數： | 10/153頁 |
| 文件大小： | 2737K |
| 代理商： | OR4E02-2BM680I |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁
10
Lattice Semiconductor
Data Sheet
November, 2002
ORCA
Series 4 FPGAs
Programmable Logic Cells
(continued)
Look-Up Table Operating Modes
The operating mode affects the functionality of the PFU input and output ports and internal PFU routing. For exam-
ple, in some operating modes, the DIN[7:0] inputs are direct data inputs to the PFU latches/FFs. In memory mode,
the same DIN[7:0] inputs are used as a 4-bit write data input bus and a 4-bit write address input bus into LUT
memory.
Table 2 lists the basic operating modes of the LUT. Figure 4—Figure 7 show block diagrams of the LUT operating
modes. The accompanying descriptions demonstrate each mode’s use for generating logic.
Table 2. Look-Up Table Operating Modes
PFU Control Inputs
Each PFU has eight routable control inputs and an active-low, asynchronous global set/reset (GSRN) signal that
affects all latches and FFs in the device. The eight control inputs are CLK[1:0], LSR[1:0], CE[1:0], and SEL[1:0],
and their functionality for each logic mode of the PFU is shown in Table 3. The clock signal to the PFU is CLK, CE
stands for clock enable, which is its primary function. LSR is the local set/reset signal that can be con
fi
gured as
synchronous or asynchronous. The selection of set or reset is made for each latch/FF and is not a function of the
signal itself. SEL is used to dynamically select between direct PFU input and LUT output data as the input to
the latches/FFs.
All of the control signals can be disabled and/or inverted via the con
fi
guration logic. A disabled clock enable
indicates that the clock is always enabled. A disabled LSR indicates that the latch/FF never sets/resets (except
from GSRN). A disabled SEL input indicates that DIN[7:0] PFU inputs are routed to the latches/FFs.
Table 3. Control Input Functionality
Mode
Logic
Function
4-, 5-, and 6-input LUTs; softwired LUTs; latches/FFs with direct input or LUT input; CIN as direct
input to ninth FF or as pass through to COUT.
Upper four LUTs and latches/FFs in logic mode; lower four LUTs and latches/FFs in ripple mode;
CIN and ninth FF for logic or ripple functions.
All LUTs combined to perform ripple-through data functions. Eight LUT registers available for
direct-in use or to register ripple output. Ninth FF dedicated to ripple out, if used. The submodes of
ripple mode are adder/subtractor, counter, multiplier, and comparator.
All LUTs and latches/FFs used to create a 32x4 synchronous dual-port RAM. Can be used as
single-port or as ROM.
Half Logic/
Half Ripple
Ripple
Memory
Mode
Logic
CLK
[1:0]
LSR
[1:0]
CE
[1:0]
SEL
[1:0]
CLK to all latches/
FFs
LSR to all latches/FFs,
enabled per nibble and
for ninth FF
LSR to all latches/FF,
enabled per nibble and
for ninth FF
LSR to all latches/FFs,
enabled per nibble and
for ninth FF
LSR0 Port enable 2
CE to all latches/FFs,
selectable per nibble
and for ninth FF
CE to all latches/FFs,
selectable per nibble
and for ninth FF
CE to all latches/FFs,
selectable per nibble
and for ninth FF
CE1 RAM write enable
CE0 Port enable 1
Not used
Select between LUT
input and direct input for
eight latches/FFs
Select between LUT
input and direct input for
eight latches/FFs
Select between LUT
input and direct input for
eight latches/FFs
Not used
Half Logic/
Half Ripple
CLK to all latches/
FFs
Ripple
CLK to all latches/
FFs
Memory
(RAM)
Memory
(ROM)
CLK to RAM
Optional for
synchronous outputs
Not used
Not used
相關PDF資料 |
PDF描述 |
|---|---|
| OR4E02-3BA352C | FPGA |
| OR4E02-3BM416C | FPGA |
| OR4E02-3BM680C | FPGA |
| OR4E04-1BA352C | FPGA |
| OR4E04-1BA352I | FPGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OR4E02-3BA352C | 功能描述:FPGA - 現場可編程門陣列 4992 LUT 405 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| OR4E02-3BM416C | 功能描述:FPGA - 現場可編程門陣列 4992 LUT 405 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| OR4E02-3BM680C | 功能描述:FPGA - 現場可編程門陣列 4992 LUT 405 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| OR4E04 | 制造商:LATTICE 制造商全稱:Lattice Semiconductor 功能描述:ORCASeries 4 FPGAs |
| OR4E04-1BA3521 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Lattice Semiconductor Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。