- 您現在的位置：買賣IC網 > PDF目錄383682 > OMAP5910(RISC) Dual-Core Processor PDF資料下載
參數資料
| 型號： | OMAP5910(RISC) |
| 英文描述： | Dual-Core Processor |
| 中文描述： | 雙核處理器 |
| 文件頁數： | 59/160頁 |
| 文件大?。?/td> | 1997K |
| 代理商： | OMAP5910(RISC) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁當前第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁
Functional Overview
47
August 2002 Revised August 2003
SPRS197B
3.6.7 HDQ/1-Wire Interface
This module allows implementation of both HDQ and the 1-Wire protocols. These protocols use a single wire
to communicate between a master and a slave. The HDQ/1-Wire pin is open-drain and requires an external
pullup resistor.
HDQ and 1-Wire interfaces can be found on commercially available battery management and power
management devices. The interface can be used to send command and status information between
OMAP5910 and such a battery or power management device.
3.6.8 Camera Interface
The camera interface is an 8-bit external port which may be used to accept data from an external camera
sensor. The interface handles multiple image formats synchronized on vertical and horizontal synchronization
signals. Data transfer to the camera interface may be done synchronously or asynchronously.
The camera interface module converts the 8-bit data transfers into 32-bit words and utilizes a 128-word buffer
to facilitate efficient data transfer to memory. Data may be transferred from the camera interface buffer to
internal memory by the system DMA controller or directly by the MPU. The interface may utilize an externally
driven clock at rates up to 13 MHz or may optionally provide an output reference clock at rates of 8 MHz,
9.6 MHz, or 24 MHz when the camera interface is configured for clocking from the internal 48 MHz. When the
camera interface is configured to obtain clocking from the base oscillator frequency (12 MHz or 13 MHz), the
camera interface clock is configurable to operate at the base frequency or one half the base frequency (6 MHz
or 6.5 MHz).
3.6.9 MPUIO/Keyboard Interface
The MPUIO pins may be used as either general-purpose I/O for the MPU or as a Keyboard Interface to a 6 x 5
or 8 x 8 keypad array. If a 6 x 5 keypad array is implemented, the unused MPUIO pins may be used as GPIO.
When used as GPIO, each pin may be configured individually as either an output or an input, and they may
be individually configured to generate MPU interrupts based on a level change (falling or rising) after a
debouncing process. These MPUIO interrupts may be used to wake up the device from deep-sleep mode
using the 32-kHz clock.
The MPUIO pins may also be used as a keyboard interface. The keyboard interface provides the following
pins:
KB.R[7:0] input pins for row lines
KB.C[7:0] output pins for column lines
To allow key-press detection, all input pins (KB.Rx) are pulled up to DV
DD
and all output pins (KB.Cx) are driven
low level. The KB.R[7:0] and KB.C[7:0] pins should be connected to an external keyboard matrix such that
when a key on the matrix is pressed, the corresponding row and column lines are shorted together. Any action
on a key generates an interrupt to the MPU, which then scans the column lines in a particular sequence to
determine which key or keys have been pressed.
3.6.10
Pulse-Width Light (PWL)
The Pulse-Width Light (PWL) module provides control of the LCD or keypad backlighting by employing a
random sequence generator. This voltage-level control technique decreases the spectral power at the
modulator harmonic frequencies. The module uses a switchable 32-kHz clock.
3.6.11
Pulse-Width Tone (PWT)
The Pulse-Width Tone (PWT) module generates a modulated frequency signal for use with an external buzzer.
The frequency is programmable between 349 Hz and 5276 Hz with 12 half-tone frequencies per octave. The
volume level of the output is also programmable.
相關PDF資料 |
PDF描述 |
|---|---|
| OMC506 | Closed Loop Speed Controller For 3-Phase Brushless DC Motor MP-3T Package |
| OMC507 | 5 Amp. Push-Pull 3-Phase Brushless DC Motor Controller Driver(5A,推挽三相無刷直流電機控制驅動器) |
| OMC510 | 36V Hi-Rel Three-Phase Brushless DC Motor Controller in a PCB-1 package |
| OMC510 | DSP-Based Three-Phase Brushless DC Motor Controller(基于DSP的三相無刷直流電機控制器) |
| OMD100F60HL | TRANSISTOR | IGBT POWER MODULE | HALF BRIDGE | 600V V(BR)CES | 150A I(C) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OMAP5912 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Applications Processor |
| OMAP5912GDYAR | 制造商:Texas Instruments 功能描述:- Tape and Reel |
| OMAP5912ZDY | 功能描述:處理器 - 專門應用 Applications Processor RoHS:否 制造商:Freescale Semiconductor 類型:Multimedia Applications 核心:ARM Cortex A9 處理器系列:i.MX6 數據總線寬度:32 bit 最大時鐘頻率:1 GHz 指令/數據緩存: 數據 RAM 大小:128 KB 數據 ROM 大小: 工作電源電壓: 最大工作溫度:+ 95 C 安裝風格:SMD/SMT 封裝 / 箱體:MAPBGA-432 |
| OMAP5912ZDYA | 制造商:Texas Instruments 功能描述:APPLICATIONS PROCESSOR - Trays |
| OMAP5912ZZG | 功能描述:處理器 - 專門應用 Applications Processor RoHS:否 制造商:Freescale Semiconductor 類型:Multimedia Applications 核心:ARM Cortex A9 處理器系列:i.MX6 數據總線寬度:32 bit 最大時鐘頻率:1 GHz 指令/數據緩存: 數據 RAM 大小:128 KB 數據 ROM 大小: 工作電源電壓: 最大工作溫度:+ 95 C 安裝風格:SMD/SMT 封裝 / 箱體:MAPBGA-432 |
發布緊急采購，3分鐘左右您將得到回復。
