- 您現在的位置：買賣IC網 > PDF目錄382298 > MC145574 (Motorola, Inc.) ISDN S/T-Interface Transceiver PDF資料下載
參數資料
| 型號： | MC145574 |
| 廠商： | Motorola, Inc. |
| 英文描述： | ISDN S/T-Interface Transceiver |
| 中文描述： | 綜合業務數字網S / T的接口收發器 |
| 文件頁數： | 28/164頁 |
| 文件大小： | 1072K |
| 代理商： | MC145574 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁
MC145574
4–2
MOTOROLA
ááááááááááááá
áááááááááááá
áááááááááááá
áááááááááááá
áááááááááááá
áááááááááááá
áááááááááááá
Din
This pin is always an input. Data to be output on the S/T–interface is input on this pin.
Dout
This pin is a three–state output. Data received on the S/T–interface is output on this pin during pro-
grammed timeslots and is high impedance at all other times.
TSEN/FST
This pin is normally three–state, but it can be reconfigured through the SCP to be used as TSEN
or FST. See Register OR7 description.
TSEN is an open drain output. TSEN can be used to enable an external bus driver and pulses low
when data is being output on the Dout pin. This signal can be used to control a high drive bus/backplane
driver in applications where the Dout data is going off–board. Since TSEN is open drain, it can be
wire–OR’d with other devices and share the same driver.
This pin can also be reconfigured through the SCP to be used as FST. In this mode, the IDL2 interface
operates with two independent frame syncs, one for the Tx direction (FST) and one for the Rx direction
(FSR). FST is bidirectional, the direction depending on whether the IDL2 is a master or a slave.
TFSC/TCLK/T_IN/FIX
This pin is the FIX input in NT modes, but in the TE slave mode it is reconfigured to be used as TFSC
and outputs an 8 kHz signal that is synchronized to the incoming S/T–interface frames. The TFSC
can be used in NT2 applications where the TE slave mode is utilized. The TFSC can be used to synchro-
nize the TE slaves to the network. Alternatively, this pin can output TCLK, selected via the SCP. TCLK
is a clock whose frequency can be chosen via the SCP, which is also synchronized to the received
S/T–interface. TCLK can be used as an alternative to TFSC in the NT2 slave–slave mode. Refer to
the slave–slave mode section for further details on TFSC and TCLK. See Register OR7 description.
In the NT Terminal mode (NTTERM), this pin is T_IN. See the section on NT Terminal mode. See
description for Register OR8.
This is the normal mode of operation for the MC145574, when active as an NT. In this mode FSC
and DCL are inputs to the device, and the outgoing S/T frame is synchronized to the IDL2 frame sync.
Typically the MC145574, when configured as an NT, is situated on a line card or an NT1 box. As
an IDL2 slave, this allows the S/T chip to derive its timing from the backplane or from the
MC14LC5472/MC145572 U–chips. As mentioned previously, FSC must be 8 kHz, while DCL can be
input to the device with any frequency from 512 kHz to 4.096 MHz.
When the MC145574 is configured as an NT, then BR7(3) determines whether the NT is acting as
an IDL2 master or as an IDL2 slave. When BR7(3) is a 0, the MC145574, when acting as an NT,
is behaving as an IDL2 slave. Conversely, when BR7(3) or OR8(3) is set to a 1, or when pulling high
the M/S pin, the chip acting as an NT behaves as an IDL2 timing master.
F
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
.
相關PDF資料 |
PDF描述 |
|---|---|
| MC14559BDWR2 | Successive Approximation Registers |
| MC14559B | Successive Approximation Registers |
| MC14559BCP | Successive Approximation Registers |
| MC1455 | Timing Circuit |
| MC1455BD | Timing Circuit |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC145574AAC | 功能描述:IC TRANSCEIVER ISDN 32-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC145574AACR2 | 功能描述:IC TRANSCEIVER ISDN 32-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC145574ADW | 功能描述:IC TRANSCEIVER ISDN 28-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC145574ADWR2 | 功能描述:IC TRANSCEIVER ISDN 28-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC145574AEG | 制造商:Freescale Semiconductor 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。