- 您現在的位置：買賣IC網 > PDF目錄382298 > MC145574 (Motorola, Inc.) ISDN S/T-Interface Transceiver PDF資料下載
參數資料
| 型號： | MC145574 |
| 廠商： | Motorola, Inc. |
| 英文描述： | ISDN S/T-Interface Transceiver |
| 中文描述： | 綜合業務數字網S / T的接口收發器 |
| 文件頁數： | 146/164頁 |
| 文件大小： | 1072K |
| 代理商： | MC145574 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁當前第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁
MC145574
B–4
MOTOROLA
Half Duplex
— A transmission system that permits communication in one direction at a time. CB ratios, with “push–to–talk”
switches, and voice–activated speakerphones, are half duplex.
Handset
— A rigid assembly providing both telephone transmitter and receiver in a form convenient for holding simultaneously
to mouth and ear.
Hookswitch
— A switch that connects the telephone circuit to the subscriber loop. The name derives from old telephones where
the switch was activated by lifting the receiver off and onto a hook on the side of the phone.
Idle Channel Noise
(ICN) — The total signal energy measured at the output of a device or channel under test when the input
of the device or channel is grounded (often a wide–band noise measurement using a C–message weighting filter to band–limit
the output noise).
Intermodulation
— The modulation of the components of a complex wave by each other (in a nonlinear system).
Intermodulation Distortion
— An analog line impairment when two frequencies interact to create an erroneous frequency, in
turn distorting the data signal representation.
IRED
— Infrared. Used as a wireless link for remote control or to transfer data.
ISDN
— Integrated Services Digital Network; a communication network intended to carry digitized voice and data multiplexed
onto the public network.
Jitter
— A type of analog communication line distortion caused by abrupt, spurious signal variation from a reference timing posi-
tion, and capable of causing data transmission errors, particularly at high speeds. (The variation can be in amplitude, time, frequen-
cy, or phase.)
Key System
— A miniature PABX that accepts 4 to 10 lines and can direct them to as many as 30 telsets.
μ
–law
— A companding law accepted as the North American standard for PCM based systems.
LAN
— Local Area Network; a data–only communication network between data terminals using a standard interface to the net-
work.
Line
— The portion of a circuit external to an apparatus that consists of the conductors connecting the apparatus to the exchange
or connecting two exchanges.
Line Length Compensation
— Also referred to as loop length compensation, it involves changing the gain of the transmit and
receive paths, within a telephone, to compensate for different signal levels at the end of different line lengths. A short line (close
to the CO) will attenuate signals less, and therefore less gain is needed. Compensation circuits generally use the loop current
as an indication of the line length.
Longitudinal Balance
— The common–mode rejection of a telephone circuit.
Loop
— The loop formed by the two subscriber wires (Tip and Ring) connected to the telephone at one end, and the central
office (or PBX) at the other end. Generally it is a floating system, not referred to ground, or ac power.
Loopback
— Directing signals back toward the source at some point along a communication path.
Loop Current
— The dc current that flows through the subscriber loop. It is typically provided by the central office or PBX, and
ranges from 20 to 120 mA.
LT
— Line Termination (Line Card).
MCU
— MicroComputer Unit (also MicroController Unit).
MPU
— MicroProcessor Unit.
Mu–Law
— A companding/encoding law commonly used in U.S. (same as
μ
–law).
MUX
— Multiplex or multiplexer.
Modem
— MOdulator–DEModulator; a unit that modulates and demodulates digital information from a terminal or computer
port to an analog carrier signal for passage over an analog line.
Multiframing
— When multiframing is enabled, 20 S/T frames are grouped together to provide maintenance subchannels be-
tween the TE and the NT. In the TE to NT direction, there is one subchannel called the Q channel. In the NT to TE direction,
there are five subchannels called SC1 through SC5. Messages for the Q, SC1, and SC2 subchannels have been defined in
CCITT I.430 and ANSI T1.605. Usage of the multiframing subchannels is not mandatory.
Multiplex
— To simultaneously transmit two or more messages on a single channel.
NT1
— Network Termination 1 (OSI Layer 1 Only).
F
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
.
相關PDF資料 |
PDF描述 |
|---|---|
| MC14559BDWR2 | Successive Approximation Registers |
| MC14559B | Successive Approximation Registers |
| MC14559BCP | Successive Approximation Registers |
| MC1455 | Timing Circuit |
| MC1455BD | Timing Circuit |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC145574AAC | 功能描述:IC TRANSCEIVER ISDN 32-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC145574AACR2 | 功能描述:IC TRANSCEIVER ISDN 32-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC145574ADW | 功能描述:IC TRANSCEIVER ISDN 28-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC145574ADWR2 | 功能描述:IC TRANSCEIVER ISDN 28-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC145574AEG | 制造商:Freescale Semiconductor 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。