- 您現在的位置：買賣IC網 > PDF目錄366260 > 82815EM Controller Miscellaneous - Datasheet Reference PDF資料下載
參數資料
| 型號： | 82815EM |
| 英文描述： | Controller Miscellaneous - Datasheet Reference |
| 中文描述： | 控制器雜項-數據表參考 |
| 文件頁數： | 95/163頁 |
| 文件大?。?/td> | 1049K |
| 代理商： | 82815EM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁當前第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁
Intel
82815EM GMCH
R
Datasheet
95
Bit
Descriptions
3
VGA Enable.
This bit works with the MDA present bit , GMCHCFG[3], of device 0 to control the
routing of processor initiated transactions targeting VGA compatible I/O and memory address ranges.
When this bit is set , the GMCH2-M will forward the following processor accesses to the AGP:
1) memory accesses in the range 0A0000h to 0BFFFFh
2) I/O addresses where A[9:0] are in the ranges 3B0h to 3BBh and 3C0h to 3DFh
(inclusive of ISA address aliases - A[15:10] are not decoded)
When this bit is set , forwarding of these accesses issued by the processor is independent of the I/O
address and memory address ranges defined by the previously defined base and limit registers.
Forwarding of these accesses is also independent of the settings of the bit 2 (ISA Enable) of this
register if this bit is “1”. If the VGA enable bit is set, then accesses to IO address range x3BCh - x3BFh
are forwarded to hub interface. If the VGA enable bit is not set then accesses to IO address range
x3BCh - x3BFh are treated just like any other IO accesses i.e. the cycles are forwarded to AGP if the
address is within IOBASE and IOLIMIT and ISA enable bit is not set, otherwise they are forwarded to
hub interface.
If this bit is “0” (default) , then VGA compatible memory and I/O range accesses are not forwarded to
AGP but rather they are mapped to primary PCI unless they are mapped to AGP via I/O and memory
range registers defined above (IOBASE, IOLIMIT, MBASE, MLIMIT, PMBASE, PMLIMIT)
The following table shows the behavior for all combinations of MDA and VGA:
VGA MDA
Behavior
0 0 All References to MDA and VGA Go To hub interface
0 1 Illegal Combination (DO NOT USE)
Address 3BF and aliases) will go to hub interface.
1 0 All References To VGA Go To AGP MDA-only references (I/O
1 1 VGA References go to AGP/PCI; MDA References go to the hub interface
2
ISA Enable:
Modifies the response by the GMCH2-M to an I/O access issued by the processor that
target ISA I/O addresses. This applies only to I/O addresses that are enabled by the IOBASE and
IOLIMIT registers. When this bit is set to 1 GMCH2-M will not forward to PCI1/AGP any I/O
transactions addressing the last 768 bytes in each 1KB block even if the addresses are within the
range defined by the IOBASE and IOLIMIT registers. Instead of going to PCI1/AGP these cycles will be
forwarded to the hub interface where they can eventually be subtractively or positively claimed by the
ISA bridge. If this bit is “0” (default) then all addresses defined by the IOBASE and IOLIMIT for
processor I/O transactions will be mapped to PCI1/AGP.
1
SERR# Enable.
This bit normally controls forwarding SERR# on the secondary interface to the
primary interface.
The GMCH2-M does not support the SERR# signal on the AGP/PCI1 bus. This bit is
hardwired to a “0”.
0
Parity Error Response Enable:
Controls GMCH2-M’s response to data phase parity errors on
PCI1/AGP. G_PERR# is not implemented by the GMCH2-M. However, when this bit is set to 1,
address and data parity errors on PCI1 are reported via SERR messaging, if enabled by SERRE1. If
this bit is reset to 0, then address and data parity errors on PCI1/AGP are not reported via SERR
messaging. Other types of error conditions can still be signaled via SERR messaging independent of
this bit’s state.
相關PDF資料 |
PDF描述 |
|---|---|
| 82820 | Interface IC |
| 82830009 | MOTOR 12VDC 2100RPM |
| 82830010 | MOTOR 24VDC 2100RPM |
| 82830MP | Intel 830MP Chipset: 82830MP Graphics and Memory Controller Hub (GMCH-M) |
| 82840 | Interface IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 82-816-1000 | 功能描述:RF 連接器 ST Plug RG-108A 50 Ohm RoHS:否 制造商:Bomar Interconnect 產品:Connectors 射頻系列:BNC 型式:Jack (Female) 極性: 觸點電鍍:Gold 阻抗: 端接類型:Solder 主體類型:Straight Bulkhead 電纜類型: |
| 82-81641 | 制造商:CHOMERICS (PARKER) 功能描述: |
| 828168-1 | 制造商:TE Connectivity 功能描述:7P MT RV100 CONNECTOR |
| 828168-2 | 功能描述:7P MT TAND BU STECK RoHS:是 類別:連接器，互連式 >> 矩形 - 自由懸掛，面板安裝 系列:AMPMODU RV 100 RoHS指令信息:5-643816-8 Statement of Compliance 3D 型號:5-643816-8.pdf 標準包裝:500 系列:MTA-100 連接器類型:插座 觸點類型：:母形插口 位置數:28 間距:0.100"（2.54mm） 行數:1 行間距:- 安裝類型:自由懸掛 緊固型:鎖銷滑道 電纜端接:IDC 導線類型:離散式或帶狀纜線 線規:28 AWG 特點:閉端，帶電極標記 觸點表面涂層:錫 觸點涂層厚度:80µin（2.03µm） 顏色:綠 包裝:散裝 相關產品:A1998-ND - HEAD ASSEM TOOL FOR MTA-100 RECP |
| 828169-1 | 功能描述:集管和線殼 2X7P MT TAND SOCKET CONNECTOR RoHS:否 產品種類:1.0MM Rectangular Connectors 產品類型:Headers - Pin Strip 系列:DF50 觸點類型:Pin (Male) 節距:1 mm 位置/觸點數量:16 排數:1 安裝風格:SMD/SMT 安裝角:Right 端接類型:Solder 外殼材料:Liquid Crystal Polymer (LCP) 觸點材料:Brass 觸點電鍍:Gold 制造商:Hirose Connector |
發布緊急采購，3分鐘左右您將得到回復。