- 您現在的位置：買賣IC網 > PDF目錄383255 > L9805 (意法半導體) Super Smart Power Motor Driver with 8-BIT MCU, CAN Interface, 16K EPROM, 256Bytes RAM, 128 Bytes EEPROM, 10 Bit ADC, WDG, 2 Timers, 2 PWM Modules, Ful PDF資料下載
參數資料
| 型號： | L9805 |
| 廠商： | 意法半導體 |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Super Smart Power Motor Driver with 8-BIT MCU, CAN Interface, 16K EPROM, 256Bytes RAM, 128 Bytes EEPROM, 10 Bit ADC, WDG, 2 Timers, 2 PWM Modules, Ful |
| 中文描述： | 超級智能型電動馬達驅動器，帶有8位微控制器，CAN接口，16K的存儲器，256Bytes RAM內存，128字節EEPROM，10位ADC，水分散粒劑，2定時器，2個PWM模塊，涪陵 |
| 文件頁數： | 24/103頁 |
| 文件大小： | 853K |
| 代理商： | L9805 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁
24/103
L9805
3.7 POWER SAVING MODES
3.7.1 Introduction
There are three Power Saving modes. The Slow
Mode may be selected by setting the relevant bits
in the Miscellaneous register as detailed in
Section
3.4
. Wait and Halt modes may be entered using
the WFI and HALT instructions.
3.7.2 Slow Mode
In Slow mode, the oscillator frequency can be di-
vided by 4, 8, 16 or 32 rather than by 2. The CPU
and peripherals (except CAN, see Note) are
clocked at this lower frequency. Slow mode is
used to reduce power consumption.
Note:
Before entering Slow mode and to guaran-
tee low power operations, the CAN Controller
must be placed by software in STANDBY mode.
3.7.3 Wait Mode
Wait mode places the MCU in a low power con-
sumption mode by stopping the CPU. All peripher-
als remain active. During Wait mode, the I bit (CC
Register) is cleared, so as to enable all interrupts.
All other registers and memory remain un-
changed. The MCU will remain in Wait mode until
an Interrupt or Reset occurs, whereupon the Pro-
gram Counter branches to the starting address of
the Interrupt or Reset Service Routine.
The MCU will remain in Wait mode until a Reset or
an Interrupt (coming from CAN, Timers 1 & 2,
EEPROM, ADC, PWM 1 & 2, I/O ports peripherals
and Power Bridge) occurs, causing its wake-up.
Refer to
Figure 12
below.
Figure 12. Wait Mode Flow Chart
WAIT INSTRUCTION
RESET
FETCH RESET VECTOR
OR SERVICE INTERRUPT
INTERRUPT
Y
N
N
Y
CPU CLOCK
I-BIT
OSCILLATOR
PERIPH. CLOCK
ON
ON
ON
SET
CPU CLOCK
I-BIT
OSCILLATOR
PERIPH. CLOCK
ON
ON
OFF
CLEARED
相關PDF資料 |
PDF描述 |
|---|---|
| L9813 | SUPER SMART MIRROR WITH EMBEDDED MCU |
| L9820 | HIGH SIDE DRIVER |
| L9820D | HIGH SIDE DRIVER |
| L9822E | Octal Serial Solenoid Driver(八串行螺線管驅動器) |
| L9822ED | CAP CER 1000PF 1KVDC B RAD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L9805E | 功能描述:馬達/運動/點火控制器和驅動器 Super Smart Power 8-Bit MCU, RAM RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| L9811 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single Peripheral Driver |
| L9812R | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single Peripheral Driver |
| L9813 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:SUPER SMART MIRROR WITH EMBEDDED MCU |
| L981CG-1 | 制造商:Thomas & Betts 功能描述:1/2 T CONDUIT BODY W/CVR & GASKET,E |
發布緊急采購，3分鐘左右您將得到回復。