- 您現在的位置：買賣IC網 > PDF目錄1961 > PI7C7300DNAE (Pericom)IC PCI-PCI BRIDGE 3PORT 272-BGA PDF資料下載
參數資料
| 型號： | PI7C7300DNAE |
| 廠商： | Pericom |
| 文件頁數： | 26/107頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PCI-PCI BRIDGE 3PORT 272-BGA |
| 標準包裝： | 40 |
| 系列： | * |
| 應用： | * |
| 接口： | * |
| 電源電壓： | * |
| 封裝/外殼： | 272-BBGA |
| 供應商設備封裝： | 272-PBGA（27x27） |
| 包裝： | 管件 |
| 安裝類型： | 表面貼裝 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁
PI7C7300D
3-PORT PCI-TO-PCI BRIDGE
Page 25 of 107
Pericom Semiconductor
November 2005 - Revision 1.01
4.6.2
MEMORY WRITE AND INVALIDATE TRANSACTIONS
Posted write forwarding is used for Memory Write and Invalidate transactions.
The PI7C7300D disconnects Memory Write and Invalidate commands at aligned cache
line boundaries. The cache line size value in the cache line size register gives the number
of DWORD in a cache line.
If the value in the cache line size register does meet the memory write and invalidate
conditions, the PI7C7300D returns a target disconnect to the initiator either on a cache
line boundary or when the posted write buffer fills.
When the Memory Write and Invalidate transaction is disconnected before a cache line
boundary is reached, typically because the posted write buffer fills, the trans-action is
converted to Memory Write transaction.
4.6.3
DELAYED WRITE TRANSACTIONS
Delayed write forwarding is used for I/O write transactions and Type 1 configuration
write transactions.
A delayed write transaction guarantees that the actual target response is returned back to
the initiator without holding the initiating bus in wait states. A delayed write transaction
is limited to a single DWORD data transfer.
When a write transaction is first detected on the initiator bus, and PI7C7300D forwards it
as a delayed transaction, PI7C7300D claims the access by asserting DEVSEL# and
returns a target retry to the initiator. During the address phase, PI7C7300D samples the
bus command, address, and address parity one cycle later. After IRDY# is asserted,
PI7C7300D also samples the first data DWORD, byte enable bits, and data parity. This
information is placed into the delayed transaction queue. The transaction is queued only
if no other existing delayed transactions have the same address and command, and if the
delayed transaction queue is not full. When the delayed write transaction moves to the
head of the delayed transaction queue and all ordering constraints with posted data are
satisfied. The PI7C7300D initiates the transaction on the target bus. PI7C7300D
transfers the write data to the target. If PI7C7300D receives a target retry
in response to the write transaction on the target bus, it continues to repeat the write
transaction until the data transfer is completed, or until an error condition is encountered.
If PI7C7300D is unable to deliver write data after 2
24 (default) or 232 (maximum)
attempts, PI7C7300D will report a system error. PI7C7300D also asserts P_SERR# if the
primary SERR# enable bit is set in the command register. See Section 7.4 for information
on the assertion of P_SERR#. When the initiator repeats the same write transaction (same
command, address, byte enable bits, and data), and the completed delayed transaction is
at the head of the queue, the PI7C7300D claims the access by asserting DEVSEL# and
returns TRDY# to the initiator, to indicate that the write data
was transferred. If the initiator requests multiple DWORD, PI7C7300D also asserts
STOP# in conjunction with TRDY# to signal a target disconnect. Note that only those
相關PDF資料 |
PDF描述 |
|---|---|
| PI7C8140AMAE | IC PCI-PCI BRIDGE 2PORT 128-QFP |
| PI7C8150ANDE | IC PCI-PCI BRIDGE 2PORT 256-PBGA |
| PI7C8150BNDIE | IC PCI-PCI BRIDGE ASYNC 256-PBGA |
| PI7C8152BMAIE | IC PCI-PCI BRIDGE 2PORT 160-MQFP |
| PI7C8154ANAE | IC PCI-PCI BRIDGE ASYNC 304-PBGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PI7C7300EVB | 功能描述:界面開發工具 3 Port PCI Bridge Eval Brd RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| PI7C8140A | 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:2 PORT PCI TO PCI BRIDGE PLX PCI 6140 COMPARISON |
| PI7C8140AEVB | 功能描述:界面開發工具 2 Port PCI to PCI Bridge Eval Brd RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| PI7C8140AMA | 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:2-Port PCI-to-PCI Bridge |
| PI7C8140AMAE | 功能描述:外圍驅動器與原件 - PCI PCI -to -PCI Bridge 2 Port RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。