- 您現在的位置：買賣IC網 > PDF目錄25640 > S1C63158D0A010P 4-BIT, FLASH, 4 MHz, MICROCONTROLLER, UUC53 PDF資料下載
參數資料
| 型號： | S1C63158D0A010P |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT, FLASH, 4 MHz, MICROCONTROLLER, UUC53 |
| 封裝： | DIE-53 |
| 文件頁數： | 123/159頁 |
| 文件大?。?/td> | 1200K |
| 代理商： | S1C63158D0A010P |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁當前第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁
58
EPSON
S1C63808 TECHNICAL MANUAL
CHAPTER 4: PERIPHERAL CIRCUITS AND OPERATION (Stopwatch Timer)
SWRUN: Stopwatch timer RUN/STOP (FF7CHD1)
This register controls the RUN/STOP of the stopwatch timer, and the operating status can be monitored
by reading this register.
When writing data
When "1" is written: RUN
When "0" is written: STOP
The stopwatch timer enters the RUN status when "1" is written to SWRUN, and the STOP status when "0"
is written. In the STOP status, the timer data is maintained until the next RUN status or resets timer. Also,
when the STOP status changes to the RUN status, the data that was maintained can be used for resuming
the count. RUN/STOP control with this register is valid only when the direct input function is set to
disable. When the direct input function is set, it becomes invalid.
When reading data
When "1" is read: RUN
When "0" is read: STOP
Reading is always valid regardless of the direct input function setting. "1" is read when the stopwatch
timer is in the RUN status, and "0" is read in the STOP status.
At initial reset, this register is set to "0".
LCURF: Lap data carry-up request flag (FF7CHD3)
This flag indicates a carry that has been generated to 1 sec-digit when the data is held. Note that this flag
is invalid when the direct input function is disabled.
When "1" is read: Carry is required
When "0" is read: Carry is not required
Writing: Invalid
If the capture buffer shifts into hold status while the 1 Hz interrupt factor flag ISW1 is set to "1", LCURF is
set to "1" to indicate that a carry-up to 1-sec digit is required. When performing a processing such as a
LAP input preceding with 1 Hz interrupt processing, read this flag before processing and check whether
carry-up is needed or not.
This flag is renewed (set/reset) every time the capture buffer shifts into hold status.
At initial reset, this flag is set to "0".
CRNWF: Capture renewal flag (FF7CHD2)
This flag indicates that the content of the capture buffer has been renewed.
When "1" is read: Renewed
When "0" is read: Not renewed
Writing: Invalid
The content of the capture buffer is renewed if the LAP key is input when the data held into the capture
buffer has not yet been read. Reading SWD8–11 in that status sets this flag to "1", and the hold status is
maintained. Consequently, when data that is held by a LAP input is read, read this flag after reading the
SWD8–11 and check whether the data has been renewed or not.
This flag is renewed when SWD8–11 is read.
At initial reset, this flag is set to "0".
EIRUN, EILAP, EISW1, EISW10: Interrupt mask registers (FFE8H)
These registers are used to select whether to mask the stopwatch timer interrupt.
When "1" is written: Enabled
When "0" is written: Masked
Reading: Valid
The interrupt mask registers EIRUN, EILAP, EISW1 and EISW10 are used to separately select whether to
mask the direct RUN, direct LAP, 1 Hz and 10 Hz interrupts.
At initial reset, these registers are set to "0".
相關PDF資料 |
PDF描述 |
|---|---|
| S1C7XXXF00E199 | 16-BIT, 90 MHz, RISC MICROCONTROLLER, PQFP |
| S2041 | PHOTO TRANSISTOR DETECTOR |
| S3P44R10 | TRIGGER OUTPUT SOLID STATE RELAY, 4000 V ISOLATION-MAX |
| S3S12P128J0VQK | 16-BIT, MROM, 1.05 MHz, MICROCONTROLLER, PQFP80 |
| MC9S12P128J0CFTR | 16-BIT, FLASH, 1.05 MHz, MICROCONTROLLER, QCC48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S1C63408 | 制造商:EPSON 制造商全稱:EPSON 功能描述:4-bit Single Chip Microcomputer |
| S1C63557D04Q000 | 制造商:Seiko Instruments Inc (SII) 功能描述:EPSON MCU 4BIT |
| S1C63567 | 制造商:EPSON 制造商全稱:EPSON 功能描述:4-bit Single Chip Microcomputer |
| S1C63616 | 制造商:EPSON 制造商全稱:EPSON 功能描述:4-bit Single Chip Microcomputer |
| S1C63632 | 制造商:EPSON 制造商全稱:EPSON 功能描述:4-bit Single Chip Microcomputer |
發布緊急采購，3分鐘左右您將得到回復。