- 您現在的位置：買賣IC網 > PDF目錄190253 > PSD4256G6V-10UIT (STMICROELECTRONICS) 1M X 8 FLASH, 52 I/O, PIA-GENERAL PURPOSE, PQFP80 PDF資料下載
參數資料
| 型號： | PSD4256G6V-10UIT |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 1M X 8 FLASH, 52 I/O, PIA-GENERAL PURPOSE, PQFP80 |
| 封裝： | PLASTIC, TQFP-80 |
| 文件頁數： | 65/127頁 |
| 文件大?。?/td> | 1091K |
| 代理商： | PSD4256G6V-10UIT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁當前第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁
Programming Flash memory
PSD4256G6V
since the Toggle Flag bit (DQ6/DQ14) may have changed simultaneously with the Error Flag
bit (DQ5/DQ13) (see Figure 6).
The Error Flag bit (DQ5/DQ13) is set if either an internal timeout occurred while the
embedded algorithm attempted to program, or if the MCU attempted to program a '1' to a bit
that was not erased (not erased is logic '0').
It is suggested (as with all Flash memories) to read the location again after the embedded
programming algorithm has completed, to compare the word that was written to Flash
memory with the word that was intended to be written.
When using the data toggle method after an Erase cycle, Figure 6 still applies. the Toggle
Flag bit (DQ6/DQ14) toggles until the Erase cycle is complete. A '1' on the Error Flag bit
(DQ5/DQ13) indicates a timeout condition on the Erase cycle, a '0' indicates no error. The
MCU can read any even location within the sector being erased to get the Toggle Flag bit
(DQ6/DQ14) and the Error Flag bit (DQ5/DQ13).
PSDsoft generates ANSI C code functions which implement these Data Toggling algorithms.
8.3
Unlock Bypass
The Unlock Bypass instruction allows the system to program words to the Flash memories
faster than using the standard Program instruction. The Unlock Bypass mode is entered by
first initiating two Unlock cycles. This is followed by a third WRITE cycle containing the
Unlock Bypass command, 20h (as shown in Table 29: 16-bit instructions and Table 30: 8-bit
instructions). The Flash memory then enters the Unlock Bypass mode.
A two-cycle Unlock Bypass Program instruction is all that is required to program in this
mode. The first cycle in this instruction contains the Unlock Bypass Program command,
A0h. The second cycle contains the program address and data. Additional data is
programmed in the same manner. This mode dispense with the initial two Unlock cycles
required in the standard Program instruction, resulting in faster total programming time.
During the unlock bypass mode, only the Unlock Bypass Program and Unlock Bypass Reset
instructions are valid.
To exit the Unlock Bypass mode, the system must issue the two-cycle Unlock Bypass Reset
instruction. The first cycle must contain the data 90h; the second cycle the data 00h.
Addresses are “Don’t care” for both cycles. The Flash memory then returns to Read mode.
相關PDF資料 |
PDF描述 |
|---|---|
| PSD6407 | POSITION SENSITIVE DETECTOR |
| PSD813F2-15JT | 128K X 8 FLASH, 27 I/O, PIA-GENERAL PURPOSE, PQCC52 |
| PSD813F5V-20MT | 128K X 8 FLASH, 27 I/O, PIA-GENERAL PURPOSE, PQFP52 |
| PSD853F2-15JIT | 128K X 8 FLASH, 27 I/O, PIA-GENERAL PURPOSE, PQCC52 |
| PSD833F2-15M | 1M X 1 FLASH, 27 I/O, PIA-GENERAL PURPOSE, PQFP52 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PSD4-36 | 制造商:Tamura Corporation of America 功能描述: |
| PSD-45 | 制造商:MEANWELL 制造商全稱:Mean Well Enterprises Co., Ltd. 功能描述:45W DC-DC Single Output Switching Power Supply |
| PSD-45_11 | 制造商:MEANWELL 制造商全稱:Mean Well Enterprises Co., Ltd. 功能描述:45W DC-DC Single Output Switching Power Supply |
| PSD-45A-05 | 功能描述:線性和開關式電源 30W 5Vout 6A Input 9.2-18VDC RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
| PSD-45A-12 | 功能描述:線性和開關式電源 30W 12Vout 2.5A Input 9.2-18VDC RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
發布緊急采購，3分鐘左右您將得到回復。