- 您現在的位置：買賣IC網 > PDF目錄2012 > MC92604ZT (Freescale Semiconductor)IC TXRX ETH DUAL GIG 196-MAPBGA PDF資料下載
參數資料
| 型號： | MC92604ZT |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 61/122頁 |
| 文件大小： | 0K |
| 描述： | IC TXRX ETH DUAL GIG 196-MAPBGA |
| 標準包裝： | 630 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 2/2 |
| 規程： | 千兆位以太網 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 196-LBGA |
| 供應商設備封裝： | 196-MAPBGA（15x15） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁當前第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁
Receiver
MC92604 Dual Gigabit Ethernet Transceiver Reference Manual, Rev. 1
Freescale Semiconductor
3-9
If in the GMII or RGMII mode, alignment is acquired per the PCS state diagram as shown in Figure 36-9
of the IEEE Std. 802.3 2002 specification [4].
Alignment remains locked until any one of three events occur that indicate loss of alignment:
Alignment is lost when a misaligned COMMA sequence is detected. The MC92604 can be
configured to automatically realign to a new COMMA sequence. This mode is always enabled
when in backplane byte mode or GMII mode (TBIE low) or when both XMIT_x_K and TBIE are
high. If automatic realignment is allowed then alignment is lost (and immediately regained) when
a misaligned COMMA sequence is detected. A misaligned COMMA sequence is defined as four
COMMA code groups with a new alignment other than the current alignment. Non-COMMA code
groups can be dispersed between the four misaligned COMMAs; however, a properly-aligned
COMMA code group or a COMMA code group with yet another alignment breaks the sequence.
When alignment is lost due to misaligned COMMAs, the receiver is automatically aligned to the
new COMMA sequence and data continues without interruption. Also, if realignment is allowed
by the state of XMIT_x_K when in TBI mode, the FIFOs are automatically realigned to keep all
word synchronization is enabled, any byte realignment will cause loss of word synchronization
If the 8B/10B encoder is enabled (TBIE = low), alignment is also lost when the number of received
code groups with 8B/10B coding errors outnumbers the non-errored code groups by four. Credit
for non-errored code groups in excess of errored code groups is limited to four, such that alignment
is lost after four consecutive errored code groups. The receiver restarts its alignment procedure and
halts data flow until alignment is achieved.
Finally, the user may force loss of alignment by asserting XCVR_x_DISABLE (high). Each
receiver may thus be forced to restart its alignment procedure. Data flow will halt until alignment
is achieved. Normally, XCVR_x_DISABLE will also disable the transmitter. If this is not desired,
raising DROP_SYNC concurrent with (or prior to) XCVR_x_DISABLE will force the receiver to
re-align and have no effect on the corresponding transmitter.
NOTE
Since XCVR_x_DISABLE and DROP_SYNC are not synchronous to the
internal clock domain DROP_SYNC should be raised prior to
XCVR_x_DISABLE is raised and remain high until after
XCVR_x_DISABLE is negated low.
When establishing byte alignment, or when data flow is halted due to misalignment, the ‘Not Byte Sync’
error is reported as described in Section 3.7.3, “Error Handling.”
相關PDF資料 |
PDF描述 |
|---|---|
| MCP2120T-I/SL | IC ENCODR/DECODR 2.5V IR 14-SOIC |
| MCP2122-E/P | IC ENCODER/DECODER IRDA 8-DIP |
| MCP2122T-E/SNG | IC ENCODER/DECODR INFRARED 8SOIC |
| MCP3901A0T-E/SS | IC ENERGY METER AFE 2CH 20-SSOP |
| MCP3903T-E/SS | IC AFE 24BIT 64KSPS 6CH 28SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC92610 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad 3.125 Gbaud SERDES |
| MC92610VF | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad 3.125 Gbaud SERDES |
| MC928G | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Motorola Inc 功能描述: 制造商:MOTOROLA 功能描述: |
| MC929F | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Motorola Inc 功能描述: |
| MC929G | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。