
xr
XRT94L33
3-CHANNEL DS3/E3/STS-1 TO STS-3/STM-1 MAPPER IC DATA SHEET
Rev.1.2.0.
159
Note:
The Transmit UTOPIA Interface block will sample and latch the state of the TxUSoC input pin upon the rising
edge of TxUClk. Therefore, if the TxUClk to TxUSoC output delay (of the ATM Layer Processor) is 1ns or more,
then the ATM Layer Processor should update the state of the “TxUSoC” input pin (of the XRT94L33) upon the
rising edge of TxUClk.
3.
Apply the Odd-Parity value of this first byte (or word), currently residing on the Transmit UTOPIA
Data Bus, to the TxUPrty input pin.
This should be done concurrently with pulsing the TxUSoC input pin “high”.
Note:
The Transmit UTOPIA Interface block will sample and latch the state of the “TxUPrty” input pin upon the rising
edge of TxUClk. Therefore, if the TxUClk to TxUPrty output delay (of the ATM Layer Processor) is 1ns or more,
then the ATM Layer Processor should update the state of the “TxUPrty” input pin (of the XRT94L33) upon the
rising edge of “TxUClk”.
4.
Assert the “Transmit UTOPIA Data Bus” - Write Enable Signal, TxUEnb*.
This step should also be done concurrently with pulsing the TxUSoC input pin “high”.
When writing the subsequent bytes (word) of the cell, the ATM Layer Processor must repeatedly exercise
Steps 3 and 4, of the above list.
Since the XRT94L33 is always operating in the Cell-Level Handshake mode, then the ATM Layer Processor
should check the level of the TxUClav signal, as it nears completion of writing in a given cell. If “TxUClav” is
“high” then the ATM Layer Processor can finish writing the current cell into the “Transmit UTOPIA Interface”
block. Afterwards, the ATM Layer Processor may proceed to write in the contents of the very next “outbound”
ATM cell into the Transmit UTOPIA Interface block.
Conversely, if “TxUClav” is “l(fā)ow” then the ATM Layer Processor should finish writing the current ATM cell data
into the “Transmit UTOPIA Interface” block.
Afterwards, the ATM Layer Processor must negate the
“TxUEnb*” input pin and halt writing any more ATM cell data into the “Transmit UTOPIA Interface” block, until
the TxUClav output pin toggles “high” again.
The above-mentioned procedure is also depicted in Flow-Chart Form in
Figure 13 and in Timing Diagram