![](http://datasheet.mmic.net.cn/Exar-Corporation/XRT94L33IB-L_datasheet_100163/XRT94L33IB-L_352.png)
XRT94L33
xr
Rev.1.2.0.
3-CHANNEL DS3/E3/STS-1 TO STS-3/STM-1 MAPPER IC DATA SHEET
352
2.3.1.4.3
Configuring the Transmit STS-3 TOH Processor block to automatically transmit the RDI-L
indicator whenever the Receive STS-3 TOH Processor block declares the AIS-L Defect
Condition
The user can configure the Transmit STS-3 TOH Processor block to automatically transmit the RDI-L
indicator to the remote LTE whenever (and for the duration that) the corresponding Receive STS-3 TOH
Processor block declares the AIS-L defect condition.
Figure 85 presents an illustration of the Transmit STS-3 TOH Processor block transmitting the RDI-L
indicator, to the remote LTE, whenever the corresponding Receive STS-3 TOH Processor block declares the
AIS-L defect condition.
Figure 85Illustration of the Transmit STS-3 TOH Processor block (within a given XRT94L33)
transmitting the RDI-L indicator, to the remote LTE whenever the corresponding Receive STS-3 TOH
Processor block declares the AIS-L defect condition.
The user can implement this configuration by setting Bit 2 (Transmit RDI-L upon AIS-L) within the Transmit
STS-3 Transport – RDI-L Control Register, as depicted below.
Transmit STS-3 Transport – RDI-L Control Register (Address = 0x1933)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
Unused
External
RDI-L
Enable
Transmit
RDI-L upon
AIS-L
Transmit
RDI-L upon
LOF
Transmit
RDI-L upon
LOS
R/O
R/W
0
1
0
2.3.1.4.4
Configuring the Receive STS-3 TOH Processor block to automatically transmit the AIS-P
indicator in the down-stream direction (towards the Receive STS-3c POH Processor
block) whenever it declares the AIS-L Defect Condition
The user can configure the Receive STS-3 TOH Processor block to automatically transmit the AIS-P
indicator, in the down-stream direction (towards the corresponding Receive STS-3c POH Processor block)
whenever (and for the duration that) it declares the AIS-L defect condition.
Note:
If the XRT94L33 is configured to operate in either the “1-Channel STS-3 ATM UNI/PPP” Mode, then the Receive
STS-3 TOH Processor block will transmit the AIS-P indicator to all three Receive SONET POH Processor
blocks, in parallel, whenever it declares the AIS-L defect condition.
Figure 86 presents an illustration of the Receive STS-3 TOH Processor block transmitting the AIS-P indicator,
in the down-stream direction (towards the Receive STS-3c POH Processor block) whenever it declares the
AIS-L defect condition.