參數資料
型號: SPD6729QCE
廠商: INTEL CORP
元件分類: 總線控制器
英文描述: PCMCIA BUS CONTROLLER, PQFP208
封裝: MQFP-208
文件頁數: 33/116頁
文件大?。?/td> 1442K
代理商: SPD6729QCE
PCI-to-PC Card (PCMCIA) Controller — PD6729
Datasheet
23
3.0
Introduction to the PD6729
3.1
System Architecture
This section describes PCMCIA basics, windowing, socket power management features, interrupts,
device power management, write FIFO usage, bus sizing, programmable PCMCIA timing, and
ATA mode operation.
3.1.1
PCMCIA Basics
PCMCIA is an abbreviation for Personal Computer Memory Card International Association.
PCMCIA 2.1 is a standard for using memory and I/O devices as insertable, exchangeable
peripherals for PCs (personal computers) and handheld computers.
Note:
The PD6729 is backward-compatible with PCMCIA standards 1.0, 2.0, and 2.01. The PD6729 is
also compatible with JEIDA 4.1 and its earlier standards corresponding with the PCMCIA
standards above.
For simpler end-user and vendor implementation of the standard, systems employing PCMCIA 2.1
should also be backward-compatible with industry-standard PC addressing.
For PCMCIA memory-type cards, the memory information must be mapped into the system
memory address space. This is accomplished with a ‘windowing’ technique that is similar to
expanded memory schemes already used in PC systems (for example, LIM 4.0 memory manager).
PCMCIA cards can have attribute and common memory. Attribute memory is used to indicate to
host software the capabilities of the PCMCIA card, and it allows host software to change the
configuration of the card. Common memory can be used by host software for any purpose (such as
flash file system, system memory, and floppy emulation).
PCMCIA I/O-type cards, such as modem network cards, should also be directly addressable, as if
the cards were I/O devices plugged into the PCI bus. For example, it would be highly desirable to
have a PCMCIA modem accessible to standard communications software as if it were at a COM
port. For COM1, this would require that the modem be accessed at system I/O address 3F8h–3FFh.
The method of mapping a PCMCIA I/O address into anticipated areas of PCI I/O space is done
similarly to memory windowing.
PCMCIA I/O-type cards usually have interrupts that need to be serviced by host software. For the
example of a modem card accessed as if at COM1, software would expect the modem to generate
interrupts on the IRQ4 line. To be sure all interrupts are routed as expected, the PD6729 can steer
the interrupt from the PCMCIA card to one of the four PCI-bus-defined interrupts or to one of
3.1.2
PD6729 Windowing Capabilities
For full compatibility with existing software, and to ensure compatibility with future memory cards
and software, the PD6729 provides five programmable memory windows per socket and two
programmable I/O windows per socket. These windows can be used by an inserted PCMCIA card
to access PCI memory and I/O space.
相關PDF資料
PDF描述
SPEAR-09-B042 1 CHANNEL(S), 100M bps, I2C BUS CONTROLLER, PBGA289
SPEAR300-2 32-BIT, FLASH, 333 MHz, RISC MICROCONTROLLER, PBGA289
SPL505YC264ATT PROC SPECIFIC CLOCK GENERATOR, PDSO64
SPL505YC264BT 400 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO64
SPL505YC264BT 400 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO64
相關代理商/技術參數
參數描述
SPD6730QCB 制造商:Rochester Electronics LLC 功能描述:- Bulk
SPD6832QCB 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Intel 功能描述:
SPD73 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Shielded Surface Mount Inductors
SPD73-103M 功能描述:固定電感器 10uH 20% .067ohm Shield Choke SMT Pwr RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm
SPD73-103MTR 功能描述:固定電感器 10 UH 20% RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm