參數資料
型號： ORT8850L-3BM680C
廠商： Lattice Semiconductor Corporation
文件頁數： 49/105頁
文件大?。?/td> 0K
描述： IC FPSC TRANSCEIVER 8CH 680-BGA
產品變化通告： Product Discontinuation 01/Aug/2011
標準包裝： 24
系列： *
Lattice Semiconductor
ORCA ORT8850 Data Sheet
48
SYS_FP
I
System frame pulse generated inside the FPGA logic. This is a sin-
gle clock pulse of FPGA_SYSCLK every 9720 clock cycles. For a
77.76 MHz reference clock the system frame pulse is at the SONET
standard of 8 KHz. All the eight Transmit channels' rst A1 byte
should be aligned to the SYS_FP. Internally SYS_FP is used when
Far end loopback (line side loopback) needs to be performed. This
loopback can only be performed when Pointer Mover is not
bypassed.
LINE_FP
I
User-provided frame pulse used by only the Pointer Mover block in
the receive direction. The Pointer Mover moves the data to align it
with the LINE_FP. If the Pointer Mover is bypassed, LINE_FP is not
used.
TOH_CLK
I
Clock driven from the FPGA to clock the TOH processor. This clock
can be in the range from 25MHz to 77.76MHz. If not using the TOH
communication channel this signal can be connected to GND.
Signals to TX Logic Blocks
DINxx[7:0]
I
Byte wide data for channel xx. This data is ultimately preset on the
serial LVDS pin TXDxx_W_[P:N] (work) and TXDxx_P_[P:N] (pro-
tect).
DINxx_PAR
I
Parity input for byte wide data DINxx. Odd or even parity selection
is controlled by a bit in the control register at 0x3000C.
Signals from RX Logic Blocks
DOUTxx[7:0]
O
Byte wide data for channel AA
DOUTxx_PAR
O
Parity output for byte wide data DOUTxx[7:0]. Odd/Even is con-
trolled by control register at 0x3000C.
DOUTxx_FP
O
Frame pulse output from the SONET framer. A single clock pulse to
indicate the start of the SONET frame. If bypassing the pointer
mover/interpreter this pulse will line up directly with the rst A1 on
DOUTxx[7:0]. If using the pointer interpreter/mover DOUTxx_FP
will fall several clock cycles before the A1 on DOUTxx[7:0] due to
the latency from the pointer mover.
DOUTxx_SPE
O
When '1' indicates SPE bytes are on the DOUTxx[7:0] lines. Only
available when using the pointer interpreter/mover
DOUTxx_C1J1
O
When '1' indicates the C1J1 bytes are on the DOUTxx[7:0] lines.
Only available when using the pointer interpreter/mover.
DOUTxx_EN
O
Indicates the state of register setting for DOUTxx_EN.
CDR_CLK_xx
O
Recovered clock from the Channel xx SERDES. If not using the
alignment FIFO all of the parallel data from Channel xx will be
clocked from this clock.
Signals to TOH Logic Blocks (Note: These signals are active only in the serial TOH insertion mode)
TX_TOH_CK_EN
I
Active-hi TOH_CLK enable. If using serial TOH insertion this enable
must be active.
TOH_INxx
I
Serial TOH insertion port for channel xx.
Signals from TOH Logic Blocks (Note: These signals are active only in the serial TOH insertion mode)
RX_TOH_CK_EN
O
When '1' indicates a control register bit has been set to enable the
TOH clock and frame pulse.
RX_TOH_FP
O
Single clock frame pulse to indicate the serial link frame pulse.
TOH_CK_FP_EN
O
When '1' indicates the TOH serial link clock is enabled.
TOH_OUTxx
O
TOH serial link output from Channel xx
Table 15. FPGA/Embedded Core Interface Signals (Continued)
ORT8850 FPGA/Embedded Core Interface Signals - SONET Blocks
FPGA/Embedded Core
Interface Signal Name
xx=[AA,…,BD]
Input (I) to or Output (O)
from Core
Signal Description
相關PDF資料
PDF描述
P1010PSE5HFA MPU PROTO 800/667 425-TEPBGA1
P1013NXN2LFB IC MPU 1067MHZ 689TEPBGA
P1013PSE2EFA IC MPU PROTO 600MHZ 689-TEPBGA
P1014NSN5DFA IC MPU 800MHZ 425TEPBGA1
P1014NSN5FFA IC MPU 800MHZ 425TEPBGA1
相關代理商/技術參數
參數描述
ORT8850L-3BMN680C 功能描述:FPGA - 現場可編程門陣列 4992 LUT 278 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
ORT9303 制造商:BOT 制造商全稱:Bedford Opto Technology Ltd. 功能描述:3 ELEMENT PCB MOUNT 1.8mm LED ARRAY
ORT9303B 制造商:BOT 制造商全稱:Bedford Opto Technology Ltd. 功能描述:3 ELEMENT PCB MOUNT 1.8mm LED ARRAY
ORT9303BL 制造商:BOT 制造商全稱:Bedford Opto Technology Ltd. 功能描述:3 ELEMENT PCB MOUNT 1.8mm LED ARRAY
ORT9303G 制造商:BOT 制造商全稱:Bedford Opto Technology Ltd. 功能描述:3 ELEMENT PCB MOUNT 1.8mm LED ARRAY
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*