- 您現在的位置：買賣IC網 > PDF目錄45219 > MC68HC05CJ4FB (MOTOROLA INC) 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQFP44 PDF資料下載
參數資料
| 型號： | MC68HC05CJ4FB |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQFP44 |
| 封裝： | QFP-44 |
| 文件頁數： | 52/114頁 |
| 文件大?。?/td> | 361K |
| 代理商： | MC68HC05CJ4FB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁當前第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁
GENERAL RELEASE SPECIFICATION
MC68HC(7)05CJ4
SERIAL COMMUNICATIONS INTERFACE
MOTOROLA
Rev. 2.1
8-5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
3. Ignore the sample at RT2 and sample RXD at RT3. Call this the first test
sample.
4. Ignore the sample at RT4 and sample RXD at RT5. Call this the second test
sample. If test samples at RT3 and RT5 were both high, assume that the low
detected at RT1 was noise and go back to step 1 else continue.
5. Ignore the sample at RT6 and sample RXD at RT7. Call this the third test
sample. If any two of the test samples at RT3, RT5, or RT7 were high
assume that the low detected at RT1 was noise and go back to step 1 else
continue.
6. A valid start bit has been found and synchronization has been achieved.
From this point on until the end of the frame the RT clock will increment to
RT16 and start over at RT1 where RT1 is considered to be the beginning of
a bit time and RT16 is considered to be the end of a bit time.
NOTE
Any one-to-zero transition will re-synchronize the RT clock and may
shift the assumed location of RT1.
Upon detection of a valid start bit, synchronization has been established and
locked to the internal 16 times baud rate clock. The incoming data is no longer
considered asynchronous until after reception of the stop bit, at which time a new
asynchronous search for a start bit is initiated.
During each bit time of the frame, including the start and stop bit times, three logic
sense samples are taken at RT8, RT9, and RT10. The logic sense of the bit time
is taken to be the sense of the majority of these three samples (except the start bit,
which is assumed to be logic sense zero regardless of the RT8 – RT10 samples).
Note that during the start bit time, samples were also taken at RT1, RT3, RT5, and
RT7 and the samples taken at RT8, RT9, and RT10 during the start bit time are
only used for possible setting of a working “noise flag”. There is a working “noise
flag” associated with each received frame which implies whether or not the
information in the frame is likely to be in error. If the noise flag is clear, it implies
good information, and, if this flag is set, it implies that the data may (but probably
does not) contain errors. At the beginning of a frame, the working noise flag starts
out at zero. If any of the samples taken at RT3, RT5, or RT7 during the start bit
search was a high, the working noise flag will be set. Also, if the samples taken at
RT8, RT9, and RT10 during any one bit time (including the start bit, all data bits,
optional ninth bit, and stop bit) do not all three agree, the working noise flag will
be set.
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HC05CL48 | 8-BIT, MROM, 1.802 MHz, MICROCONTROLLER, PQFP112 |
| MC68HC705CL48 | 8-BIT, OTPROM, 1.802 MHz, MICROCONTROLLER, PQFP112 |
| MC68HC05CT4FN | 8-BIT, MROM, 2.048 MHz, MICROCONTROLLER, PQCC44 |
| MC68HC05CT4FB | 8-BIT, MROM, 2.048 MHz, MICROCONTROLLER, PQFP44 |
| MC68HC05E16CB | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP56 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC05CT4FB | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification |
| MC68HC05CT4FN | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification |
| MC68HC05D9 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:8-bit microcomputer with PWM outputs and LED drive |
| MC68HC05E0 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:High-density complementary metal oxide semiconductor (HCMOS) microcontroller unit |
| MC68HC05E0FN | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。