參數資料
型號: GS4911BCNE3
廠商: Gennum Corporation
英文描述: HD/SD/Graphics Clock and Timing Generator with GENLOCK
中文描述: 高清/標清/圖形時鐘和定時發生器鎖相
文件頁數: 13/113頁
文件大?。?/td> 1017K
代理商: GS4911BCNE3
GS4911B/GS4910B Data Sheet
36655 - 2
April 2006
13 of 113
28, 29, 30
ACLK1
ACLK2
ACLK3
(GS4911B only)
Output
CLOCK SIGNAL OUTPUTS
Signal levels are LVCMOS/LVTTL compatible.
Audio output clock signals.
ACLK1, ACLK2, and ACLK3 present audio sample rate clock outputs to
the application layer.
By default, after system reset, the audio clock output pins of the device
provide clock signals as follows:
ACLK1 = 256fs
ACLK2 = 64fs
ACLK3 = fs, where fs is the fundamental sampling frequency.
The fundamental sampling frequency is selected using ASR_SEL[2:0].
Additional sampling frequencies may be programmed in the host
interface.
It is also possible to select different division ratios for each of the audio
clock outputs by programming designated registers in the host interface.
Clock outputs of 512fs, 384fs, 256fs, 192fs, 128fs, 64fs, fs and z bit are
selectable on a pin-by-pin basis.
NOTE: ACLK1-3 will have a 50% duty cycle, unless fs is selected as
96kHz and the host interface is configured such that one of the three
ACLK pins is set to output a clock signal at 192fs or 384fs. If this is the
case, then a 512fs clock will have a 33% duty cycle.
These signals will be high impedance when ASR_SEL[2:0] = 000b.
NC
(GS4910B only)
Do not connect.
32, 33, 34
ASR_SEL[2:0]
(GS4911B only)
Non
Synchronous
Input
CONTROL SIGNAL INPUTS
Signal levels are LVCMOS/LVTTL compatible.
Audio Sample Rate Select.
Used to select the fundamental sampling frequency, fs, of the audio clock
outputs. See
Table 3-7
.
When ASR_SEL[2:0] = 000b, audio clock generation will be disabled and
the ACLK1 to ACLK3 pins will be high impedance. In this case,
AUD_PLL_VDD (pin 14) may be connected to GND to minimize noise
and power consumption.
ANALOG_GND
(GS4910B only)
Power
Supply
Ground connection for the analog input block. Connect to GND.
35
TIMING_OUT_1
Synchronous
with PCLK1 ~
PCLK3
Output
TIMING SIGNAL OUTPUT
Signal levels are LVCMOS/LVTTL compatible.
Selectable timing output.
Selectable from: H sync; H blanking; V sync; V blanking; F sync; F
digital; Display Enable; 10 field ID (film cadence); AFS video/audio timing
(GS4911B only); USER_1~4.
See
Section 1.5 on page 25
for signal descriptions.
NOTE: Default output is H Sync.
The current drive capability of this pin may be set high or low via
designated registers in the host interface. By default, the current drive
will be low.
This signal will be high impedance when VID_STD[5:0] = 00h.
Table 1-1: Pin Descriptions (Continued)
Pin
Number
Name
Timing
Type
Description
相關PDF資料
PDF描述
GS4915 CONN,S/R,8 POS,254C-08-1, CLOSED END STRAIN RELIEF COVER
GS6332 3 Pin, Low-Power, P Reset Circuits
GS6332UR15D1 3 Pin, Low-Power, P Reset Circuits
GS6333UR19D1 FC/ACP F.O. SINGLE MODE IN-LINE ATTENUATOR 10DB
GS6332UR19D1 FC/PC F.O. SINGLE MODE IN-LINE ATTENUATOR 5 DB
相關代理商/技術參數
參數描述
GS4915 制造商:GENNUM 制造商全稱:GENNUM 功能描述:ClockCleaner
GS4915_09 制造商:GENNUM 制造商全稱:GENNUM 功能描述:ClockCleaner
GS4915-CNE3 制造商:Semtech Corporation 功能描述:QFN-40 pin (490/tray)
GS4915INE3 制造商:Gennum Corporation 功能描述:CLOCKCLEANER HD/SD VIDEO INPUT 40QFN 制造商:Gennum Corporation 功能描述:CLOCKCLEANER, HD/SD, VIDEO INPUT, 40QFN
GS4915-INE3 功能描述:IC CLK JITTER CLEANR 40QFN RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器,PLL,頻率合成器 系列:ClockCleaner™ 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML,PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤,16-MLF? 供應商設備封裝:16-MLF?(3x3) 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND