參數資料
型號: DS21554LN
廠商: DALLAS SEMICONDUCTOR
元件分類: Digital Transmission Interface
英文描述: DATACOM, PCM TRANSCEIVER, PQFP100
封裝: 14 X 14 MM, LQFP-100
文件頁數: 31/117頁
文件大?。?/td> 698K
代理商: DS21554LN
DS21354 & DS21554
20 of 117
Signal Name:
8MCLK
Signal Description:
8 MHz Clock
Signal Type:
Output
An 8.192MHz clock output that is referenced to the clock that is output at the RCLK pin.
Signal Name:
RPOSO
Signal Description:
Receive Positive Data Input
Signal Type:
Output
Updated on the rising edge of RCLKO with bipolar data out of the line interface. This pin is normally
tied to RPOSI.
Signal Name:
RNEGO
Signal Description:
Receive Negative Data Input
Signal Type:
Output
Updated on the rising edge of RCLKO with the bipolar data out of the line interface. This pin is normally
tied to RPOSI.
Signal Name:
RCLKO
Signal Description:
Receive Clock Output
Signal Type:
Output
Buffered recovered clock from the T1 line. This pin is normally tied to RCLKI.
Signal Name:
RPOSI
Signal Description:
Receive Positive Data Input
Signal Type:
Input
Sampled on the falling edge of RCLKI for data to be clocked through the receive side framer. RPOSI and
RNEGI can be tied together for a NRZ interface. Can be internally connected to RPOSO by tying the
LIUC pin high.
Signal Name:
RNEGI
Signal Description:
Receive Negative Data Input
Signal Type:
Input
Sampled on the falling edge of RCLKI for data to be clocked through the receive side framer. RPOSI and
RNEGI can be tied together for a NRZ interface. Can be internally connected to RNEGO by tying the
LIUC pin high.
Signal Name:
RCLKI
Signal Description:
Receive Clock Input
Signal Type:
Input
Clock used to clock data through the receive side framer. This pin is normally tied to RCLKO. Can be
internally connected to RCLKO by tying the LIUC pin high.
4.1.3 Parallel Control Port Pins
Signal Name:
INT*
Signal Description:
Interrupt
Signal Type:
Output
Flags host controller during conditions and change of conditions defined in the Status Registers 1 and 2
and the HDLC Status Register. Active low, open drain output
相關PDF資料
PDF描述
DS2155G DATACOM, FRAMER, PBGA100
DS21600SN PLL BASED CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO16
DS21600N PLL BASED CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDIP8
DS2155LN DATACOM, FRAMER, PQFP100
DS21602N PLL BASED CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDIP8
相關代理商/技術參數
參數描述
DS21554LN+ 功能描述:網絡控制器與處理器 IC 3.3/5V E1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發(fā)器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2155DK 功能描述:網絡開發(fā)工具 RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
DS2155G 功能描述:網絡控制器與處理器 IC T1/E1/J1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發(fā)器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2155G/T&R 制造商:Maxim Integrated Products 功能描述:DS2155 T1/E1/J1 SCT 100P CSBGA T&R - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC LIU T1/E1/J1 SCT 100P CSBGA 制造商:Maxim Integrated Products 功能描述:Network Controller & Processor ICs T1/E1/J1 Transceiver