- 您現在的位置：買賣IC網 > PDF目錄98068 > S1C6N3B0D0A0100 MICROCONTROLLER, UUC54 PDF資料下載
參數資料
| 型號： | S1C6N3B0D0A0100 |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | MICROCONTROLLER, UUC54 |
| 封裝： | DIE-54 |
| 文件頁數： | 36/79頁 |
| 文件大?。?/td> | 606K |
| 代理商： | S1C6N3B0D0A0100 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁當前第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁
S1C6N3B0 TECHNICAL MANUAL
EPSON
33
CHAPTER 4: PERIPHERAL CIARCUITS AND OPERATION (LCD Driver)
4.6.2 Switching between dynamic and static drive
The S1C6N3B0 Series allows software setting of the LCD static drive.
The procedure for executing of the LCD static drive is as follows:
Write "1" to the CSDC register at address "0FBH D3".
Write the same value to the display memory corresponding to COM0–COM3.
Note: Even when l/3 duty is selected, the display data corresponding to COM3 is valid for static drive.
Hence, for static drive, set the same value to all display memory corresponding COM0–COM3.
Figure 4.6.2.1 shows the drive waveform for static drive.
SEG
0–25
(19)
COM
0–3
Frame frequency
LCD status
COM0
COM1
COM2
COM3
SEG0–25(19)
–V
Off
On
C3
C2
C1
SS
–V
C3
C2
C1
SS
–V
C3
C2
C1
SS
Fig. 4.6.2.1 LCD static drive waveform
4.6.3 Display control
The ALLOFF register is provided to turn all the LCD dots off. At initial reset, the ALLOFF register is set
to "1" and the LCD display goes off because the contents of the display memory are undefined. To start
display, write "0" to the ALLOFF register after writing display data to the display memory. In the LCD all-
off status, the OFF waveform shown in Figure 4.6.2.1 is output.
Similarly, the ALLON register is also provided to turn all the LCD dots on. This register allows the
software to control blinking in the display. In the LCD all-on status, the ON waveform shown in Figure
4.6.2.1 is output.
These controls do not affect display memory data.
相關PDF資料 |
PDF描述 |
|---|---|
| S1C6P366D0A0100 | 4-BIT, FLASH, 4.1 MHz, MICROCONTROLLER, UUC102 |
| S1C6P466D0A0A00 | MICROCONTROLLER, UUC140 |
| S1C6S2L7D | 4-BIT, MROM, 0.032 MHz, MICROCONTROLLER, UUC58 |
| S1C6S2A7F | 4-BIT, MROM, 0.08 MHz, MICROCONTROLLER, PQFP60 |
| S1C6S2B7F | 4-BIT, MROM, 0.08 MHz, MICROCONTROLLER, PQFP60 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S1C-6-S | 制造商:GRIPCO 功能描述: |
| S1C7309X | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:B/W CCD PROCESSOR |
| S1C7309X01 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:B/W CCD PROCESSOR |
| S1C88349 | 制造商:EPSON 制造商全稱:EPSON 功能描述:8-bit Single Chip Microcomputer |
| S1C88649 | 制造商:EPSON 制造商全稱:EPSON 功能描述:8-bit Single Chip Microcomputer |
發布緊急采購，3分鐘左右您將得到回復。