- 您現在的位置：買賣IC網 > PDF目錄379877 > celeron processor (Intel Corp.) 32 bit Celeron Processor Mobile Module(32 位帶移動模塊處理器) PDF資料下載
參數資料
| 型號： | celeron processor |
| 廠商： | Intel Corp. |
| 英文描述： | 32 bit Celeron Processor Mobile Module(32 位帶移動模塊處理器) |
| 中文描述： | 32位賽揚處理器的移動模塊（32位帶移動模塊處理器） |
| 文件頁數： | 54/64頁 |
| 文件大?。?/td> | 799K |
| 代理商： | CELERON PROCESSOR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁當前第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
Celeron
Processor Mobile Module MMC-2
at 650 MHz, 600 MHz, 550 MHz, 500 MHz, and 450 MHz
48
Datasheet
243357-004
5.4
Active Thermal Feedback
Table 26. Thermal Sensor SMBus Address
5.5
Thermal Sensor Configuration Register
The configuration register of the thermal sensor controls the operating mode (Auto Convert vs.
Standby) of the device. Since the processor temperature varies dynamically during normal
operation, Auto Convert mode should be used exclusively to monitor processor temperature.
Table 27
shows the format of the configuration register. If the RUN/STOP bit is low, then the
thermal sensor enters Auto Convert mode. If the RUN/STOP bit is set high, then the thermal sensor
immediately stops converting and enters the Standby mode. The thermal sensor will still perform
temperature conversions in Standby mode when it receives a one-shot command. However, the
result of a one-shot command during Auto Convert mode is not guaranteed. Intel does not
recommend using the one-shot command to monitor temperature when the processor is active, only
Auto Convert mode should be used. The thermal sensor can be configured in various interface
modes for temperature sampling. Intel recommends interfacing the thermal sensor using Interrupt
mode. For more detailed information regarding interface methods, please see the
Intel
Mobile
Module Thermal Diode Temperature Sensor Application Note
available through your Intel Field
Representative
.
NOTE:
All RFU bits should be written as “0” and read as “don’t care” for programming purposes.
Function
SMBus Address
Thermal Sensor
1001 110
Table 27. Thermal Sensor Configuration Register
Bit
Name
Reset State
Function
7 MSB
MASK
0
Masks SMBALERT# when high
6
RUN/STOP
0
Standby mode control bit. If low, the device enters Auto Convert
mode. If high, the device immediately stops converting and enters
Standby mode where the one-shot command can be performed.
5-0
RFU
0
Reserved for future use
相關PDF資料 |
PDF描述 |
|---|---|
| CEM11C2 | Dual Enhancement Mode Field Effect Transistor (N and P Channel) |
| CEM2005 | Dual Enhancement Mode Field Effect Transistor(N and Channel) |
| CEM2030A | Dual Enhancement Mode Field Effect Transistor(N and P Channel) |
| CEM2030 | Dual Power MOSFET |
| CEM3310 | Voltage Controlled Envelope Generator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CELF001001J1 | 制造商:Panasonic Industrial Company 功能描述:FILTER |
| CELHK11-1REC5-59-3.00-AV-01-V | 功能描述:CIRCUIT BRKR MAG-HYDR LEVER 3A 制造商:sensata technologies/airpax 系列:CEL 零件狀態:有效 斷路器類型:磁性（液力延遲） 額定電流:3A 額定電壓 - AC:- 額定電壓 - DC:- 極數:2 致動器類型:搖臂 照明:- 照明電壓（標稱值）:- 安裝類型:面板安裝 標準包裝:1 |
| CELHK11-1REC5-59-35.0-AV-01-V | 功能描述:CIRCUIT BRKR MAG-HYDR LEVER 35A 制造商:sensata technologies/airpax 系列:CEL 零件狀態:有效 斷路器類型:磁性（液力延遲） 額定電流:35A 額定電壓 - AC:- 額定電壓 - DC:- 極數:2 致動器類型:搖臂 照明:- 照明電壓（標稱值）:- 安裝類型:面板安裝 標準包裝:1 |
| CELHK11-1REC5-71165-10-V | 功能描述:CIRCUIT BREAKER MAG-HYDR LEVER 制造商:sensata technologies/airpax 系列:* 零件狀態:有效 標準包裝:1 |
| CELHK11-1REC5-71165-11-V | 功能描述:CIRCUIT BREAKER MAG-HYDR LEVER 制造商:sensata technologies/airpax 系列:* 零件狀態:有效 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。