- 您現在的位置：買賣IC網 > PDF目錄166217 > AM54BDS128AGT89IT (ADVANCED MICRO DEVICES INC) SPECIALTY MEMORY CIRCUIT, PBGA93 PDF資料下載
參數資料
| 型號： | AM54BDS128AGT89IT |
| 廠商： | ADVANCED MICRO DEVICES INC |
| 元件分類： | 存儲器 |
| 英文描述： | SPECIALTY MEMORY CIRCUIT, PBGA93 |
| 封裝： | 10 X 10 MM, 0.80 PITCH, FBGA-93 |
| 文件頁數： | 29/71頁 |
| 文件大?。?/td> | 1031K |
| 代理商： | AM54BDS128AGT89IT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁
35
Am54BDS128AG
July 23, 2002
ADV ANCE
I N FO RMAT I O N
from a “0” to a “1.” If the time between additional sec-
tor erase commands from the system can be assumed
to be less than 50 s, the system need not monitor
DQ3. See also the Sector Erase Command Sequence
section.
After the sector erase command is written, the system
should read the status of DQ7 (Data# Polling) or DQ6
(Toggle Bit I) to ensure that the device has accepted
the command sequence, and then read DQ3. If DQ3 is
“1,” the Embedded Erase algorithm has begun; all fur-
ther commands (except Erase Suspend) are ignored
until the erase operation is complete. If DQ3 is “0,” the
device will accept additional sector erase commands.
To ensure the command has been accepted, the sys-
tem software should check the status of DQ3 prior to
and following each subsequent sector erase com-
mand. If DQ3 is high on the second status check, the
last command might not have been accepted.
Table 15 shows the status of DQ3 relative to the other
status bits.
Table 15.
Write Operation Status
Notes:
1. DQ5 switches to ‘1’ when an Embedded Program or Embedded Erase operation has exceeded the maximum timing limits.
Refer to the section on DQ5 for more information.
2. DQ7 and DQ2 require a valid address when reading status
information. Refer to the appropriate subsection for further
details.
3. When reading write operation status bits, the system must
always provide the bank address where the Embedded
Algorithm is in progress. The device outputs array data if
the system addresses a non-busy bank.
4. The system may read either asynchronously or synchronously (burst) while in erase suspend. RDY will function exactly as in
non-erase-suspended mode.
Status
DQ7
DQ6
DQ5
DQ3
DQ2
Standard
Mode
Embedded Program Algorithm
DQ7#
Toggle
0
N/A
No toggle
Embedded Erase Algorithm
0
Toggle
0
1
Toggle
Erase
Suspend
Mode
Erase-Suspend-
Read (Note 4)
Erase
Suspended Sector
1
No toggle
0
N/A
Toggle
Non-Erase Suspended
Sector
Data
Erase-Suspend-Program
DQ7#
Toggle
0
N/A
相關PDF資料 |
PDF描述 |
|---|---|
| AM7200-65RC | 256 X 9 OTHER FIFO, 65 ns, PDIP28 |
| AM7200-80RC | 256 X 9 OTHER FIFO, 80 ns, PDIP28 |
| AM7201-25DC | 512 X 9 OTHER FIFO, 25 ns, CDIP28 |
| AM7203-65JC | 2K X 9 OTHER FIFO, 65 ns, PQCC32 |
| AM7831X | DUAL LINE DRIVER, UUC16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM54S | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Four-Bit Shifter With Three-State Outputs |
| AM54S350 | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Four-Bit Shifter With Three-State Outputs |
| AM-55 | 制造商:Amprobe Test Tools 功能描述:Digital Multimeter |
| AM-550 | 功能描述:數字萬用表 Digital Multimeter TRMS RoHS:否 制造商:Tektronix 產品:Multimeters 類型:Bench 準確性:0.04 % 電壓范圍:2 V to 2 kV 電阻范圍: 電容范圍: 顯示計數: 頻率:10 Hz to 45 Hz, 850 Hz to 1 MHz 測距: 真均方根值: 數據保持: |
| AM55-0001 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:140 mW Power Amplifier with T/R and Diversity Switches 2.42.5 GHz |
發布緊急采購，3分鐘左右您將得到回復。