- 您現在的位置：買賣IC網 > PDF目錄384345 > GS4911B (Gennum Corporation) HD/SD/Graphics Clock and Timing Generator with GENLOCK PDF資料下載
參數資料
| 型號： | GS4911B |
| 廠商： | Gennum Corporation |
| 英文描述： | HD/SD/Graphics Clock and Timing Generator with GENLOCK |
| 中文描述： | 高清/標清/圖形時鐘和定時發生器鎖相 |
| 文件頁數： | 40/113頁 |
| 文件大小： | 1017K |
| 代理商： | GS4911B |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁當前第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁
GS4911B/GS4910B Data Sheet
36655 - 2
April 2006
40 of 113
4. For sync-based input references, the device will advance all line-based output
timing signals by 1 line if the value programmed in the H_Offset register is
greater than 20. The user may compensate for this advance by adding 1 line
to the desired vertical offset before loading this value into the register. In
addition, the internal V_lock and F_lock signals reported in bits 3 and 4 of
register 16h will be LOW when H_Offset = 21 only, although the device will
remained genlocked. The user may choose to mask these lock signals such
that the device will continue to report genlock under this condition.
5. For blanking-based input references, the device will advance all line-based
output timing signals by 1 line if the value programmed in the H_Offset register
is greater than the number of output video clock cycles from the start of H
Sync to the end of active video (Hsync_to_EAV) + 20. The value of
Hsync_to_EAV is reported in register 51h and changes according to the output
VID_STD selected. The user may compensate for this advance by adding 1
line to the desired vertical offset before loading this value into the register. In
addition, the internal V_lock and F_lock signals reported in bits 3 and 4 of
register 16h will be LOW when H_Offset = Hsync_to_EAV + 21 only, although
the device will remained genlocked. The user may choose to mask these lock
signals such that the device will continue to report genlock under this
condition.
6. The offsets that occur as described in notes 1-5 are independent of one
another and must be accounted for as such.
3.2.1.2 Freeze Mode
When the device is in Genlock mode and the input reference is removed, the
GS4911B/GS4910B will enter Freeze mode. The behaviour of the device during
loss and re-acquisition of an input reference signal is described in
Section 3.5.3 on
page 47
.
In Freeze mode, the frequency of the output clock and timing signals will be
maintained to within +/- 2ppm. This assumes a loop bandwidth of 10Hz. Also, if the
frequency of the 27MHz reference crystal shifts while in Freeze mode, the
frequency of the output clock and timing signals will shift as well.
3.2.2 Free Run Mode
The GS4911B/GS4910B will enter Free Run mode when the GENLOCK pin is set
HIGH by the application layer. In this mode, the occurrence of all frequencies is
based on the external 27MHz reference input. Therefore, the frequency of the
output clock and timing signals will have the same accuracy as the crystal
reference.
If operating in Free Run mode, using a more accurate crystal (e.g. 10ppm) ensures
more accurate clock and timing signals are generated.
NOTE: In Free Run mode, the audio clocks of the GS4911B will remain genlocked
to the video clock.
相關PDF資料 |
PDF描述 |
|---|---|
| GS4911BCNE3 | HD/SD/Graphics Clock and Timing Generator with GENLOCK |
| GS4915 | CONN,S/R,8 POS,254C-08-1, CLOSED END STRAIN RELIEF COVER |
| GS6332 | 3 Pin, Low-Power, P Reset Circuits |
| GS6332UR15D1 | 3 Pin, Low-Power, P Reset Circuits |
| GS6333UR19D1 | FC/ACP F.O. SINGLE MODE IN-LINE ATTENUATOR 10DB |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS4911B_09 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HD/SD/Graphics Clock and Timing Generator with GENLOCK |
| GS4911BCNE3 | 功能描述:IC RE-TIMER RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT |
| GS4915 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:ClockCleaner |
| GS4915_09 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:ClockCleaner |
| GS4915-CNE3 | 制造商:Semtech Corporation 功能描述:QFN-40 pin (490/tray) |
發布緊急采購，3分鐘左右您將得到回復。