- 您現在的位置：買賣IC網 > PDF目錄385298 > GC4116 (Electronic Theatre Controls, Inc.) MULTI-STANDARD QUAD DUC CHIP PDF資料下載
參數資料
| 型號： | GC4116 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | MULTI-STANDARD QUAD DUC CHIP |
| 中文描述： | 多標準四數字上芯片 |
| 文件頁數： | 9/57頁 |
| 文件大?。?/td> | 401K |
| 代理商： | GC4116 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁
GC4116 MULTI-STANDARD QUAD DUC CHIP
DATA SHEET REV 1.0
19992001
GRAYCHIP,INC.
- 4 -
APRIL 27, 2001
This document contains preliminary information which may be changed at any time without notice
3.2
CHANNEL INPUT FORMAT
The input samples are 16 bits, either real or complex.
The samples are input to the chip either through the bit-serial
input ports, or through memory mapped control registers.
The channel data request signal (CHREQ) is output from the
chip to identify when the GC4116 is ready for another
complex input sample or pair of real samples.
3.2.1 Bit Serial Interface
The bit serial format consists of a data input pin (SIN), a
bit clock pin (SCK), and a frame strobe pin (SFS) for each of
the four channels (A,B,C and D), and a channel data request
pin (CHREQ) which is common to all channels.
The serial channel inputs can come directly from the
Four Channel Resampler by connecting the resampler’s
serial output ports to the channel’s serial input ports, and
connecting the CHREQ pin to the resampler’s RSTART pin.
The Resampler and its I/O interface is described in Section
3.7.
If the Resampler is not being used, then the Serial
Controller can be used to generate the proper serial clocks
and frame strobes fro the channel inputs. In this case
CHREQ is tied to SCSTART, and then SCCK and the SCFS
strobes are used to drive the serial clock and frame strobes
for both the channel inputs and the channel data source
(typically a DSP chip, FPGA, or ASIC).
The bit serial samples are always entered MSB first.
Complex values are entered I-half first followed by the Q-half.
Real values are entered as pairs of samples, with the first
sample in the I-half and the second sample in the Q-half. The
input accepts either pairs of 16 bit words each with its own
frame strobe (the unpacked mode), or as a single 32 bit
transfer with a single frame strobe (the packed mode). The
bit serial input formats are shown in Figure 4
Figure 4a shows the unpacked input mode (PACKED in
the input control register is low). The user provides a bit serial
clock (SCK), a frame strobe (SFS) and a data bit line (SIN).
The chip clocks SFS and SIN into the chip on the rising edge
of SCK (or falling edge if the SCK_POL bit in the input control
register is set). The user sends a 16 bit serial input word to
the GC4116 by setting SFS high (or low if SFS_POL in the
input control register is set) for one SCK clock cycle, and
then transmitting the data, MSB first, on the next 16 SCK
clocks. The SFS may remain high during the transfer, but
must go low for one SCK cycle before the next serial word is
sent. The serial sample is transferred to a parallel register on
the next SCK clock. Additional SCK clocks are acceptable
but are ignored. The data can be transmitted “back to back”
as shown in Figure 4b as long as the SFS signal toggles low
and then high as shown. If the PACKED control bit is high,
then the I and Q samples (or I0 then I1 for real data) are sent
as a single 32 bit word with only one SFS strobe as shown in
Figure 4c.:
SCK
SFS
SIN
I15
I14
I13
I3
I2
I1
I0
(a) UNPACKED MODE
SCK
SFS
SIN
I15
I14
I13
I3
I2
I1
I0
Q15
(b) 16 BIT MODE, BACK TO BACK TRANSFER
(must go low before next transfer)
SCK
SFS
SIN
I15
I14
I13
I3
I2
I1
I0
Q15
(c) 32 BIT “PACKED” MODE
(SFS occurs once at beginning of the 32 bit transfer)
T
HD
T
SU
T
HD
T
SU
Figure 4. Serial Input Formats
相關PDF資料 |
PDF描述 |
|---|---|
| GD37931 | SINGLE PHASE MOULDED BRIDGES 0,8 AMP TO 1,5 AMP |
| GD39931 | SINGLE PHASE MOULDED BRIDGES 0,8 AMP TO 1,5 AMP |
| GD40931 | SINGLE PHASE MOULDED BRIDGES 0,8 AMP TO 1,5 AMP |
| GD75189 | QUADRUPLE LINE RECEIVERS |
| GD75189A | QUADRUPLE LINE RECEIVERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GC4116-PB | 功能描述:上下轉換器 4 Ch Narrowband DDC Monitor RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128 |
| GC4116-PBZ | 功能描述:上下轉換器 4 Ch Narrowband DDC Monitor RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128 |
| GC-41259-02 | 制造商:Microsemi Corporation 功能描述:DIODE - Bulk |
| GC4-12F1 | 制造商:GC Electronics 功能描述:Lead Acid Rectangular 12V 4Ah Rechargeable |
| GC4130A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:GC4130A Low Distortion AGC Amplifier |
發布緊急采購，3分鐘左右您將得到回復。