參數資料
型號: AM79C970
廠商: Advanced Micro Devices, Inc.
英文描述: PCnetTM-PCI Single-Chip Ethernet Controller for PCI Local Bus
中文描述: PCnetTM - PCI單芯片以太網控制器的PCI總線
文件頁數: 61/168頁
文件大小: 943K
代理商: AM79C970
AMD
P R E L I M I N A R Y
1-928
Am79C970
Power Savings Modes
The PCnet-PCI controller supports two hardware power
savings modes. Both are entered by driving the
SLEEP
pin LOW.
The PCI interface section is not effected by
SLEEP
. In
particular, access to the PCI configuration space re-
mains possible. None of the configuration registers will
be reset by
SLEEP
. All I/O accesses to the PCnet-PCI
controller will result in a PCI target abort response.
The first power saving mode is called coma mode. In
coma mode, the PCnet-PCI controller has no means to
use the network to automatically wake itself up. Coma
mode is enabled when the AWAKE bit in BCR2 is reset.
Coma mode is the default power down mode.
The second power saving mode is called snooze mode.
In snooze mode, enabled by setting the AWAKE bit in
BCR2 and driving the
SLEEP
pin LOW, the T-MAU re-
ceive circuitry will remain enabled even while the
SLEEP
pin is driven LOW. The
LNKST
output is the only
one of the LED pins that continues to function. The
LNKSTE bit must be set in BCR4 to enable indication of
a good 10BASE-T link if there are link beat pulses or
valid frames present. This
LNKST
pin can be used to
drive an LED and/or external hardware that directly con-
trols the
SLEEP
pin of the PCnet-PCI controller. This
configuration effectively wakes the system when there
is any activity on the 10BASE-T link. Snooze mode can
be used only if the T-MAU is the selected network port.
Link beat pulses are not transmitted during snooze
mode.
If the
REQ
output is active when the
SLEEP
pin is as-
serted, then the PCnet-PCI controller will wait until the
GNT
input is asserted. Next, the PCnet-PCI controller
will deassert the
REQ
pin and finally, it will internally en-
ter either the coma or snooze sleep mode.
Before the sleep mode is invoked, the PCnet-PCI con-
troller will perform an internal S_RESET. This
S_RESET operation will not affect the values of the BCR
registers or the PCI configuration space.
The
SLEEP
pin should not be asserted during power
supply ramp-up. If it is desired that
SLEEP
be asserted
at power up time, then the system must delay the asser-
tion of
SLEEP
until three CLK cycles after the comple-
tion of a valid pin
RST
operation.
Software Access
Configuration Registers
The PCnet-PCI controller supports the 64-byte header
portion of the configuration space as predefined by the
PCI specification revision 2.0. None of the device spe-
cific registers in locations 64 – 255 are used. The layout
of the configuration registers in the header region is
shown in the table below. All registers required to iden-
tify the PCnet-PCI controller and its function are imple-
mented. Additional registers are used to setup the
configuration of the PCnet-PCI controller in a system.
相關PDF資料
PDF描述
AM79C971VCW PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus
AM79C971 PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus
AM79C971KCW IC LOGIC 16211 24-BIT FET BUS SWITCH -40+85C TSSOP-56 35/TUBE
AM79C972BKCW PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support
AM79C972BKIW PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support
相關代理商/技術參數
參數描述
AM79C970A 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product
AM79C970AKC 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product
AM79C970AKC\\W 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Advanced Micro Devices 功能描述:
AM79C970AKC\W 制造商:Rochester Electronics LLC 功能描述:- Bulk