- 您現在的位置：買賣IC網 > PDF目錄385813 > SAA6712E (NXP SEMICONDUCTORS) ECONOLINE: RB & RA - Dual Output from a Single Input Rail- Power Sharing on Output- Industry Standard Pinout- 1kVDC & 2kVDC Isolation- Custom Solutions Available- UL94V-0 Package Material- Efficiency to 85% PDF資料下載
參數資料
| 型號： | SAA6712E |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 數學處理器 |
| 英文描述： | ECONOLINE: RB & RA - Dual Output from a Single Input Rail- Power Sharing on Output- Industry Standard Pinout- 1kVDC & 2kVDC Isolation- Custom Solutions Available- UL94V-0 Package Material- Efficiency to 85% |
| 中文描述： | GRAPHICS PROCESSOR, PBGA292 |
| 封裝： | 27 X 27 MM, 1.75 MM HEIGHT, PLASTIC, SOT-489-1, BGA-292 |
| 文件頁數： | 17/64頁 |
| 文件大?。?/td> | 228K |
| 代理商： | SAA6712E |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
1999 Aug 25
17
Philips Semiconductors
Preliminary specification
XGA RGB to TFT graphics engine
SAA6712E
7.6
I
2
C-bus interface
This serial interface consists of only two signals, the serial
clock line (SCL) and the serial data line (SDA).
The maximum supported frequency on this bus is 1 MHz.
Spikes with a maximum pulse length of 50 ns are
suppressed by the internal input filter.
The SAA6712E operates as a slave and cannot initiate
any data transfer, so the clock line is always input. Via the
data line, data is transmitted and received, so this pin must
be input/output. The SCL and SDA lines are driven by
open-drain stages and pull-up resistors. When a logic 0 is
applied, the bus is set to ground level via the output
buffers. When a logic 1 is applied, the output buffer
switches to 3-state and the pull-up resistors pull the bus up
to +5 V.
Data transfer changes on SDA are allowed only when SCL
is LOW. Data is sampled on the positive edge of SCL.
In Idle state the output buffers are in 3-state, and the bus
is HIGH. A data transfer must be initiated by an I
2
C-bus
master device. This is done by sending a START condition
whenSDAchangesfromHIGHtoLOWwhenSCLisHIGH
(see Fig.5). The device address of the SAA6712E must
then be sent with the desired I/O direction.
If the SAA6712E reads its device address, it
acknowledges this by sending a single bit ACK to the
master. If write mode was selected, the master sends the
register address to be written and then the data bytes.
If read mode was selected, the SAA6712E sends the data
bytes starting from the last address accessed either by
write command or the next address at a read command.
All byte transfers are acknowledged from the receiving
device. The data transfer is aborted by sending a STOP
condition, when SDA changes from LOW to HIGH when
SCL is HIGH (see Fig.6).
If a new address has to be read or written, it is possible to
send a new START condition without a preceding STOP
condition. In this case the bus is still occupied by the
master, and it can initiate a new data transfer. This is
useful for read activities, where at first the register address
must be sent in write mode and after that a read command
will be sent to read data from this and following addresses.
If the data transfer was a read transfer and the master was
receiver, the master must not generate an acknowledge
before the STOP condition.
Fig.5 Start of a data transfer.
handbook, full pagewidth
MHB248
SDA
A4
A1
A2
A3
A6
A5
ACK
R/W
A0
R5
R7
R6
START condition
acknowledge
Fig.6 End of a data transfer.
handbook, full pagewidth
MHB249
SDA
D7
D4
D5
D6
D1
D0
ACK
D2
D3
A/A
D1
D0
STOP condition
acknowledge/
not acknowledge
相關PDF資料 |
PDF描述 |
|---|---|
| SAA6713AH | XGA analog input flat panel controller |
| SAA6713H | XGA dual input flat panel controller |
| SAA7110 | Digital Multistandard Colour Decoder(數字多標準彩色譯碼器) |
| SAA7111 | Video Input Processor VIP |
| SAA7120H | Digital video encoder |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAA6713AH | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:XGA analog input flat panel controller |
| SAA6713AH/V1 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:XGA analog input flat panel controller |
| SAA6713H | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:XGA dual input flat panel controller |
| SAA6713H/V1 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:XGA dual input flat panel controller |
| SAA6721 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:SXGA RGB to TFT graphics engine |
發布緊急采購，3分鐘左右您將得到回復。