- 您現在的位置：買賣IC網 > PDF目錄98011 > S568013MFA00E (FREESCALE SEMICONDUCTOR INC) 0-BIT, 8 MHz, OTHER DSP, PQFP32 PDF資料下載
參數資料
| 型號： | S568013MFA00E |
| 廠商： | FREESCALE SEMICONDUCTOR INC |
| 元件分類： | 數字信號處理 |
| 英文描述： | 0-BIT, 8 MHz, OTHER DSP, PQFP32 |
| 封裝： | ROHS COMPLIANT, LQFP-32 |
| 文件頁數： | 27/125頁 |
| 文件大小： | 1702K |
| 代理商： | S568013MFA00E |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁
56F8013/56F8011 Data Sheet, Rev. 11
122
Freescale Semiconductor
The thermal characterization parameter is measured per JESD51-2 specification using a 40-gauge type T
thermocouple epoxied to the top center of the package case. The thermocouple should be positioned so
that the thermocouple junction rests on the package. A small amount of epoxy is placed over the
thermocouple junction and over about 1mm of wire extending from the junction. The thermocouple wire
is placed flat against the package case to avoid measurement errors caused by cooling effects of the
thermocouple wire.
When heat sink is used, the junction temperature is determined from a thermocouple inserted at the
interface between the case of the package and the interface material. A clearance slot or hole is normally
required in the heat sink. Minimizing the size of the clearance is important to minimize the change in
thermal performance caused by removing part of the thermal interface to the heat sink. Because of the
experimental difficulties with this technique, many engineers measure the heat sink temperature and then
back-calculate the case temperature using a separate measurement of the thermal resistance of the
interface. From this case temperature, the junction temperature is determined from the junction-to-case
thermal resistance.
12.2 Electrical Design Considerations
Use the following list of considerations to assure correct operation of the 56F8013/56F8011:
Provide a low-impedance path from the board power supply to each VDD pin on the 56F8013/56F8011 and
from the board ground to each VSS (GND) pin
The minimum bypass requirement is to place 0.01–0.1
μF capacitors positioned as close as possible to the
package supply pins. The recommended bypass configuration is to place one bypass capacitor on each of
the VDD/VSS pairs, including VDDA/VSSA. Ceramic and tantalum capacitors tend to provide better
tolerances.
Ensure that capacitor leads and associated printed circuit traces that connect to the chip VDD and VSS (GND)
pins are as short as possible
CAUTION
This device contains protective circuitry to guard
against damage due to high static voltage or electrical
fields. However, normal precautions are advised to
avoid
application
of
any
voltages
higher
than
maximum-rated voltages to this high-impedance circuit.
Reliability of operation is enhanced if unused inputs are
tied to an appropriate voltage level.
相關PDF資料 |
PDF描述 |
|---|---|
| MC56F8023VLC | 16-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP32 |
| MC56F8033VLC | 16-BIT, FLASH, 32 MHz, MICROCONTROLLER, PQFP32 |
| MC56F8347MPY60 | 16-BIT, 120 MHz, OTHER DSP, PQFP160 |
| MC56F8355VFG60 | 4-BIT, 120 MHz, OTHER DSP, PQFP128 |
| MC56F8355MFG60 | 4-BIT, 120 MHz, OTHER DSP, PQFP128 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S5-680RF1 | 制造商:Riedon 功能描述:RES 680 OHM 4W 1% WW SMD |
| S5688B | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:TOSHIBA Rectifier Silicon Diffused Type |
| S5688B(Q) | 制造商:Toshiba 功能描述:Diode 100V 1A 2-Pin DO-41SS |
| S5688B(TPA2) | 制造商:Toshiba America Electronic Components 功能描述:Diode 100V 1A 2-Pin DO-41SS T/R Cut Tape |
| S5688G | 制造商:Toshiba America Electronic Components 功能描述: 制造商:Panasonic Industrial Company 功能描述:DIODE |
發布緊急采購，3分鐘左右您將得到回復。