- 您現在的位置：買賣IC網 > PDF目錄383724 > ORT4622 Field-Programmable System Chip (FPSC) Four-Channel x 622 Mbits/s Backplane Transceiver PDF資料下載
參數資料
| 型號： | ORT4622 |
| 英文描述： | Field-Programmable System Chip (FPSC) Four-Channel x 622 Mbits/s Backplane Transceiver |
| 中文描述： | 現場可編程系統芯片（促進文化基金）四通道x 622 Mbits /秒背板收發器 |
| 文件頁數： | 25/90頁 |
| 文件大?。?/td> | 1915K |
| 代理商： | ORT4622 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁
Lucent Technologies Inc.
25
Preliminary Data Sheet
March 2000
ORCA ORT4622 FPSC
Four-Channel x 622 Mbits/s Backplane Transceiver
Backplane Transceiver Core Detailed Description
(continued)
5-9331
Notes: SPE signal behavior shown in this figure is just for illustration purposes: SPE behavior is dependent on pointer movements and concat-
enation.
SPE signal must be high during negative stuff opportunity byte time slots (H3) for which valid data is carried (negative stuffing).
SPE signal must be low during positive stuff opportunity byte time slots for which there is no valid data (positive stuffing).
Figure 10. SPE Stuff Bytes
STS-12
TOH ROW # 4
SPE ROW # 4
H1H1H1H1H1H1H1H1H1H1H1H1H2H2H2H2H2H2H2H2H2H2H2H2H3H3H3H3H3H3H3H3H3H3H3H3
STS-12
SPE
POSITIVE STUFF
OPPORTUNITY BYTES
1 2
3
4
5 6
7
8
9 10 11 12
NEGATIVE STUFF
OPPORTUNITY BYTES
SPE SIGNAL SHOWS NEGATIVE STUFFING FOR 2ND STS-1,
AND POSITIVE STUFFING FOR 6TH STS-1
Powerdown Mode
Powerdown mode will be entered when the corre-
sponding channel is disabled. Channels can be inde-
pendently enabled or disabled under software control.
Parallel data bus output enable and TOH serial data
output enable signals are made available to the FPGA
logic. The HSI macrocell’s corresponding channel is
also powered down. The device will power up with all
four channels in powerdown mode.
In addition, an LVDS_EN pin has been added to control
the LVDS pins during boundary scan. During functional
operation, enabling/disabling LVDS buffers is con-
trolled by software registers. When in boundary scan
mode, LVDS_EN controls the enabling/disabling of
LVDS buffers instead of software registers. This
LVDS_EN pin should be pulled high on the board for
functional operation, and pulled low during boundary
scan.
Redundancy and Protection Switching
The ORT4622 supports STS-12/STS-48 redundancy
by either software or hardware control for protection
switching applications. For the transmitter mode, no
additional functionality is required for redundant opera-
tion. For receiving data, STS-12 data redundancy can
be implemented within the same device, while STS-48
and above data stream requires a pair of ORT4622
devices to support redundancy.
In STS-12 mode, the channel A receive data bus port is
used for both channel A and channel B. Similarly, the
channel C receive data bus port is used for both chan-
nel C and channel D. Channel B and channel D
become the redundant channels. The channel B and
channel D receive data bus ports are unused. Soft reg-
isters provide independent control to the protection
switching MUXes for both parallel data ports and serial
TOH data ports. When direct hardware control for pro-
tection switching is needed, external protection switch
pins are available for channels A and B, and also chan-
nels C and D. The external protection switch pins only
support parallel SPE/TOH data protection switching,
but not the serial TOH data.
In STS-48 mode, two independent devices are
required to work and protect for redundancy. Parallel
and serial port output pins on the FPGA side should be
3-stated as the basis for supporting redundancy. The
existing local bus enable signals at the CIC can be
used as 3-state controls for FPGA data bus if needed,
which can be easily accessed by software control.
Users can also create their own protection switch 3-
state enable signals either in FPGA logic or external to
the device, depending on the specific application.
相關PDF資料 |
PDF描述 |
|---|---|
| ort551 | Reed Switch(舌簧開關) |
| ord2210v | Reed Switch(舌簧開關) |
| ord2210 | Reed Switch(舌簧開關) |
| ord211 | Reed Switch(舌簧開關) |
| ord2211 | Reed Switch(舌簧開關) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ORT4622BC432-DB | 功能描述:FPGA - 現場可編程門陣列 10368 LUT 204 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| ORT551 | 制造商:Hasco Components International Corp 功能描述: |
| ORT551(1315) | 制造商:OKI Semiconductor 功能描述: |
| ORT551/10-15 AT | 功能描述:磁性/簧片開關 1 Form C 14mm AT 1015 OKI RoHS:否 制造商:MEDER electronic (Standex) 開關類型:Reed 觸點形式:1 Form A (SPST-NO) 觸點額定值:10 VA 操作范圍:10 At to 50 At 工作間隙: 磁鐵類型: 顏色: 端接類型:Axial 封裝:Bulk |
| ORT551-1/10-15 AT | 功能描述:磁性/簧片開關 1 Form C 14mm AT1015 Formed Ld OKI RoHS:否 制造商:MEDER electronic (Standex) 開關類型:Reed 觸點形式:1 Form A (SPST-NO) 觸點額定值:10 VA 操作范圍:10 At to 50 At 工作間隙: 磁鐵類型: 顏色: 端接類型:Axial 封裝:Bulk |
發布緊急采購，3分鐘左右您將得到回復。