- 您現在的位置：買賣IC網 > PDF目錄383724 > ORT4622 Field-Programmable System Chip (FPSC) Four-Channel x 622 Mbits/s Backplane Transceiver PDF資料下載
參數資料
| 型號： | ORT4622 |
| 英文描述： | Field-Programmable System Chip (FPSC) Four-Channel x 622 Mbits/s Backplane Transceiver |
| 中文描述： | 現場可編程系統芯片（促進文化基金）四通道x 622 Mbits /秒背板收發器 |
| 文件頁數： | 10/90頁 |
| 文件大?。?/td> | 1915K |
| 代理商： | ORT4622 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁
ORCAORT4622 FPSC
Four-Channel x 622 Mbits/s Backplane Transceiver
Preliminary Data Sheet
March 2000
10
L Lucent Technologies Inc.
ORT4622 Overview
(continued)
HSI Interface
The high-speed interconnect (HSI) macrocell is used
for clock/data recovery and MUX/deMUX between
77.76 MHz byte-wide internal data buses and
622 Mbits/s external serial links.
The HSI interface receives four 622 Mbits/s serial input
data streams from the LVDS inputs and provides four
independent 77.76 MHz byte-wide data streams and
recovered clock to the STM macro. There is no require-
ment for bit alignment since SONET type framing will
take place inside the ORT4622 core. For transmit, the
HSI converts four byte-wide 77.76 MHz data streams to
serial streams at 622 Mbits/s at the LVDS outputs.
STM Macrocell
The STM portion of the embedded core consists of
transmitter (Tx) and receiver (Rx) sections. The
receiver receives four byte-wide data streams at
77.76 MHz and the associated clocks from the HSI. In
the Rx section, the incoming streams are SONET
framed and descrambled before they are written into a
FIFO which absorbs phase and delay variations and
allows the shift to the system clock. The TOH is then
extracted and sent out on the four serial ports. The
pointer Mover consists of three blocks: pointer inter-
preter, elastic store, and pointer generator. The pointer
interpreter finds the synchronous transport signal
(STS) synchronous payload envelopes (SPE) and
places it into a small elastic store from which the
pointer generator will produce four byte-wide STS-12
streams of data that are aligned to the system timing
pulse.
In the Tx section, transmitted data for each channel is
received through a parallel bus and a serial port from
the FPGA circuit. TOH bytes are received from the
serial input port and can be optionally inserted from
programmable registers or serial inputs to the STS-12
frame via the TOH processor. Each of the four parallel
input buses is synchronized to a free-running system
clock. Then the SPE and TOH data is transferred to the
HSI.
The STM macrocell also has a scrambler/descrambler
disable feature, allowing the user to disable the scram-
bler of the transmitter and the descrambler of the
receiver. Also, unused channels can be disabled to
reduce power dissipation.
CPU Interface
The embedded core has a dedicated, asynchronous,
MPC860 compatible, CPU interface that is used for de-
vice setup, control, and monitoring. Dual sets of I/O pins
of this CPU interface with a bit stream configurable
scheme provide designers a convenient and flexible op-
tion for configuration. One set of CPU I/O pins goes off
chip allowing direct connection with an onboard CPU.
Another set of CPU I/O pins is available to the FPGA
logic allowing for a stand-alone system free of an exter-
nal CPU interface, or for itegration into the Series 3
FPGA MPI interface.
The CPU interface is composed of an 8-bit data bus, a
7-bit address bus, a chip select signal, a read/write sig-
nal, and an interrupt signal.
FPGA Interface
The FPGA logic will receive/transmit frame-aligned
streams of 77.76 MHz data (maximum of four streams
in each direction) from/to the backplane transceiver
embedded core. All frames transmitted to the FPGA
will be aligned to the FPGA frame pulse which will be
provided by the FPGA user’s logic to the STM macro.
All frames received from the FPGA logic will be aligned
to the system frame pulse that will be supplied to the
STM macro from the FPGA user’s logic.
相關PDF資料 |
PDF描述 |
|---|---|
| ort551 | Reed Switch(舌簧開關) |
| ord2210v | Reed Switch(舌簧開關) |
| ord2210 | Reed Switch(舌簧開關) |
| ord211 | Reed Switch(舌簧開關) |
| ord2211 | Reed Switch(舌簧開關) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ORT4622BC432-DB | 功能描述:FPGA - 現場可編程門陣列 10368 LUT 204 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| ORT551 | 制造商:Hasco Components International Corp 功能描述: |
| ORT551(1315) | 制造商:OKI Semiconductor 功能描述: |
| ORT551/10-15 AT | 功能描述:磁性/簧片開關 1 Form C 14mm AT 1015 OKI RoHS:否 制造商:MEDER electronic (Standex) 開關類型:Reed 觸點形式:1 Form A (SPST-NO) 觸點額定值:10 VA 操作范圍:10 At to 50 At 工作間隙: 磁鐵類型: 顏色: 端接類型:Axial 封裝:Bulk |
| ORT551-1/10-15 AT | 功能描述:磁性/簧片開關 1 Form C 14mm AT1015 Formed Ld OKI RoHS:否 制造商:MEDER electronic (Standex) 開關類型:Reed 觸點形式:1 Form A (SPST-NO) 觸點額定值:10 VA 操作范圍:10 At to 50 At 工作間隙: 磁鐵類型: 顏色: 端接類型:Axial 封裝:Bulk |
發布緊急采購，3分鐘左右您將得到回復。