- 您現在的位置：買賣IC網 > PDF目錄360706 > IBM3288H2848 Telecommunication IC PDF資料下載
參數資料
| 型號： | IBM3288H2848 |
| 英文描述： | Telecommunication IC |
| 中文描述： | 通信集成電路 |
| 文件頁數： | 94/131頁 |
| 文件大?。?/td> | 1679K |
| 代理商： | IBM3288H2848 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁當前第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁
PRS28.4G
IBM Packet Routing Switch
I/O Definitions and Timing
Page 94 of 131
prs28.03.fm
August 31, 2000
7. I/O Definitions and Timing
Table 21: Signal Definitions
(Page 1 of 6)
Signal Name
Type
Description
Clock and Reset Signals
SYS_CLK_Q
SYS_CLK_QN
Input,
differential
System clock used for the internal clock generation network. When the internal PLL is
enabled, SYS_CLK is equal to the internal byte clock divided by either two or four,
depending on the setting of the PLL register.
See
Electrical Characteristics
on page 125 for requirements on SYS_CLK.
When using an external PLL, SYS_CLK is a equal to the internal byte clock times 2,
with 50% duty cycle.
C_CLK_OUTQ
C_CLK_OUTQN
Output
differential
Free running C clock phase of the byte clock at the output of the internal clock tree.
When the internal PLL is used, this clock output will be at the correct frequency of
100
μ
s after the Clock Start OCM Event is sent. During Flush Reset and BIST, this sig-
nal is the free-running byte clock feeding the clock generation logic. During normal
operation, this signal is generated by the end of the C clock tree.
When using an external PLL, C_CLK_OUT is to be used as the PLL feedback clock.
nRESET
Input
active low
Must be active for at least four EMB clock cycles. Asserting this pin causes a reset of
all internal logic, except the IEEE 1149.1 (JTAG logic block). See
Reset, Initialization,
and Operation
on page 88 for details on the reset sequence.
SEQ_CLK
Bidirec-
tional
Low frequency clock used to synchronize the internal sequencers of different mod-
ules. For external speed expansion, it is a synchronous signal generated by the Mas-
ter device and fed to the slave device.
The period of this clock is equal to one-quarter of the total packet length in SYS_CLK
cycle units. Therefore, it can vary from 16 to 20 SYS_CLK cycles according to the
packet length.
The mode of operation of this pin is programmable via the Sequencer Sync Mode bit
in Configuration Register 0. It can be either tri-stated for single device operation, gen-
erated by the device, or received by the device.
This signal is HSTL level and can only be connected point to point.
SEQ_CLK_TTL
Output
Identical to the SEQ_CLK output, but is in TTL level, and is only used as an output
signal.
Data Signals
DATA_IN_[00:15]_Q(0:3)
DATA_IN_[00:15]_QN(0:3)
Input
DATA_IN_
n
_Q(
i
) and DATA_IN_
n
_QN(
i
) form one of the four 444 Mb/s differential
signals for input port
n
.
For each port, bits 0 and 1 carry the slave byte stream and bits 2 and 3 carry the mas-
ter byte stream (see
Physical Bit Organization of a Port
on page 27).
DATA_OUT_[00:15]_Q(0:3)
DATA_OUT_[00:15]_QN(0:3)
Output
DATA_OUT_
n
_Q(
i
) and DATA_OUT_
n
_QN(
i
) form one of the four 444 Mb/s differen-
tial signals for output port
n
.
For each port, bits 0 and 1 carry the slave byte stream and bits 2 and 3 carry the mas-
ter byte stream (see
Physical Bit Organization of a Port
on page 27).
相關PDF資料 |
PDF描述 |
|---|---|
| IBM32NPR100EXXCAB133 | Microprocessor |
| IBM32NPR101EPXCAC133 | Microprocessor |
| IBM37RGB524CF17A | Video DAC with Color Palette (RAMDAC) |
| IBM37RGB524CF22A | Video DAC with Color Palette (RAMDAC) |
| IBM39MPEGS420PBA18C | |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IBM32NPR100EXXCAB133 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| IBM32NPR101EPXCAC133 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| IBM35CPC945C03C-2 | 制造商:IBM 功能描述: |
| IBM37RGB524CF17A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Video DAC with Color Palette (RAMDAC) |
| IBM37RGB524CF22A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Video DAC with Color Palette (RAMDAC) |
發布緊急采購，3分鐘左右您將得到回復。