參數資料
型號： 7640
英文描述： IrDA. protocol handler plus endec for DCE Apps, -40C to +85C, 18-PDIP, TUBE
中文描述： 7640組數據表數據表1885K/SEP.05.00
文件頁數： 34/97頁
文件大?。?/td> 1885K
代理商： 7640
33
Ver 1.4
MITSUBISHI MICROCOMPUTERS
7640 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
1.17.2 Timer Y
Timer Y is a 16-bit timer that has a 16-bit reload latch,
and can be placed in any of four modes by setting
TYM4 and TYM5 (bits 4 and 5) (see Figure 1.34). The
desired mode is selected by modifying the values of
TYM4 and TYM5.
1.17.2.1 Read and Write Method
Read and write operations on the high and low-order
bytes of Timer Y must be performed in a specific or-
der.
Write Method
When writing to the timer, the lower order byte is
written first. This data is placed in a temporary reg-
ister that is assigned the same address as Timer
YL. Next, the high-order byte is written. Then, the
data is placed in the Timer YH reload latch and the
low-order byte is transferred from its temporary reg-
ister to the Timer YL reload latch. At this point, if the
Timer Y Data Write Control Bit (TYM0) (bit 0) is low,
the value in the Timer Y reload latch is also loaded
in Timer Y. If TYM0 is “1”, the data in the Timer Y
reload latch is loaded in Timer Y after Timer Y
underflows.
Fig. 1.34. Timer Y Mode Register (TYM)
Read Method
When reading Timer Y, the high-order byte is read
first. Reading the high-order byte causes the values
of Timer YH and Timer YL to be placed in temporary
registers that are assigned the same addresses as
Timer YH and Timer YL. The low-order byte of
Timer Y is then read from its temporary register.
This operation assures the correct reading of Timer
Y while it is counting.
1.17.2.2 Count Stop Control
If the Timer Y Count Stop Bit (TYM7) (bit 7) is set to a
“1”, Timer Y stops counting in all four modes.
Timer Mode
Count Source: /n (where n is 8, 16, 32, or 64)
In this mode, each time the timer underflows, the
corresponding timer interrupt request bit is set to a
“1”, the contents of the timer latch are loaded into
the timer, and the count down sequence begins
again.
In Timer mode, the signal TYOUT can also be
brought out on the CNTR1 pin. This is controlled by
TYM1 (bit1).
TYM0
Timer Y Data Write Control Bit (bit 0)
0: Write data in latch and timer
1: Write data in latch only
Timer Y Output Control Bit (bit 1)
0: TYOUT output disable
1: TYOUT output enable
Timer Y Frequency Division Ratio Bits (bit 3,2)
Bit 2
Bit 1
0
0:
0
1:
1
0:
1
1:
Timer Y Mode Bits (bits 5,4)
Bit 2
Bit 1
0
0: Timer Mode
0
1: Pulse period measurement mode
1
0: Event counter mode
1
1: HL pulse width measurement mode (continu-
ously measures high period and low period)
CNTR1 Polarity Select Bit (bit 6)
0: For event counter mode, clocked by rising edge
For pulse period measurement mode, falling edge detection
For CNTR1 interrupt request, falling edge active
For TYOUT, start on high output
1: For event counter mode, clocked on falling edge
For pulse period measurement mode, rising edge detection
For CNTR1 interrupt request, rising edge active
For TYOUT, start on low output
Timer Y Stop Bit (bit 7)
0: Count start
1: Count stop
TYM1
TYM3,2
divided by 8
divided by 16
divided by 32
divided by 64
TYM5,4
TYM6
TYM7
TYM7
TYM5
TYM4
TYM3
TYM2
TYM1
TYM0
MSB
7
LSB
0
Address: 0028
16
Access: R/W
Reset: 00
16
TYM6
相關PDF資料
PDF描述
7641 7641 Group Datasheet Datasheet 2145K/MAR.26.02
7643 IrDA. protocol handler plus endec for DCE Apps, -40C to +85C, 18-SOIC 300mil, TUBE
765-11-(SERIES) Analog IC
765-11-20K Analog IC
765-11-25A Analog IC
相關代理商/技術參數
參數描述
76400 制造商:AMP 功能描述:76400 AMPHENOL NXF4C 制造商:TE Connectivity 功能描述:
76-400 制造商:AMP 功能描述:76400 AMPHENOL NXF4C
764-00/001 功能描述:MULTI FUNCT MOD SCREW C14 SWITCH RoHS:是 類別:連接器，互連式 >> 電源輸入 - 輸入端，輸出端，模塊 系列:764 標準包裝:50 系列:FELCOM 連接器類型:IEC 320-C14 連接器類型:插座，公引腳 - 模塊 位置數:3 電流:10A 電壓:250V 安裝類型:面板安裝，卡入式；通孔 端接類型:焊接 保險絲盒:包括在內 特點:保險絲盒
764-00/002 功能描述:交流電源輸入模塊 Screw Mnt Solder RoHS:否 制造商:Schurter 過濾:Yes 過濾器類型:IEC Inlet Filters 產品:Inlets 電流額定值:4 A 電壓額定值:250 VAC 外殼材料:Thermoplastic 安裝風格:Panel, Screw 端接類型:Quick Connect 工作溫度范圍:- 25 C to + 85 C 連接器類型:C-14
764-00/003 功能描述:交流電源輸入模塊 SWITCHING AC RECPT RoHS:否 制造商:Schurter 過濾:Yes 過濾器類型:IEC Inlet Filters 產品:Inlets 電流額定值:4 A 電壓額定值:250 VAC 外殼材料:Thermoplastic 安裝風格:Panel, Screw 端接類型:Quick Connect 工作溫度范圍:- 25 C to + 85 C 連接器類型:C-14
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*