參數資料
型號: PCA5007
廠商: NXP Semiconductors N.V.
英文描述: Pager baseband controller
中文描述: 傳呼機基帶控制器
文件頁數: 67/112頁
文件大?。?/td> 604K
代理商: PCA5007
1998 Oct 07
67
Philips Semiconductors
Product specification
Pager baseband controller
PCA5007
6.22.9
DC/DC C
ONTROL
R
EGISTER
(DCCON0)
The DCCON0 special function register is used to control the operation of the on-chip DC/DC converter.
Table 56
DC/DC Control Register (DCCON0, SFR address D1H)
Table 57
Description of the DCCON0 bits
7
6
5
4
3
2
1
0
OFF
SBY
RXE
SBLI
STB
BLI
BIT
SYMBOL
FUNCTION
DCCON0.7
OFF
Writing this SFR bit to logic 1 puts the DC/DC converter in the off mode (independent of
other control bits).
Writing this SFR bit to logic 1 puts the DC/DC converter in standby mode, where the
DC/DC converter is clocked from the 76.8 kHz oscillator and the ripple voltage will be
higher. If the DC/DC converter is unable to deliver enough current in SBY mode, the
software has to reset the SBY mode.
Writing this SFR bit to logic 1 uses the stored set of coefficients from a local register to
force the DC/DC converter into the state which is appropriate for the required current.
The contents of this local register are maintained when the DC/DC converter is set into
off state. For the first time after connecting V
BAT
a set of default coefficients is used.
Writing this bit to logic 0 copies the actual coefficients used momentary by the DC/DC
converter back to the local register.
Writing this SFR bit to logic 1 enables the circuitry for measurement of the battery
voltage. The new BLI value is valid 0.5 ms later. In order to make a new measurement,
the receiver should draw current (continuous mode of DC/DC converter). If SBLI is
logic 0 (BLI measurement disabled) BLI will go to HIGH.
unused
unused
Set by the DC/DC converter after power-up
. Reset by the DC/DC converter if the
converter is not able to deliver the required power. The signal is set in SBY and non
SBY mode. This bit is read only.
Battery low indicator
. Set by the DC/DC converter if V
BAT
< 1100 mV
±
50 mV. This bit
is read only.
DCCON0.6
SBY
DCCON0.5
RXE
DCCON0.4
SBLI
DCCON0.3
DCCON0.2
DCCON0.1
STB
DCCON0.0
BLI
相關PDF資料
PDF描述
PCA5007H Pager baseband controller
PCA5010 Pager baseband controller
PCA5010H Pager baseband controller
PCA82C200 STAND-ALONE CAN-CONTROLLER
PCA82C200P STAND-ALONE CAN-CONTROLLER
相關代理商/技術參數
參數描述
PCA5007H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pager baseband controller
PCA5007H/XXX 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
PCA5010 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pager baseband controller
PCA5010H 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pager baseband controller
PCA5010H/XXX 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MICROCONTROLLER|8-BIT|8051 CPU|CMOS|QFP|48PIN|PLASTIC