- 您現在的位置：買賣IC網 > PDF目錄45022 > M306H3FCFP 16-BIT, FLASH, 10 MHz, MICROCONTROLLER, PQFP116 PDF資料下載
參數資料
| 型號： | M306H3FCFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, FLASH, 10 MHz, MICROCONTROLLER, PQFP116 |
| 封裝： | 20 X 20 MM, 0.65 MM PITCH, PLASTIC, LQFP-116 |
| 文件頁數： | 114/135頁 |
| 文件大?。?/td> | 2583K |
| 代理商： | M306H3FCFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁當前第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁
Rev.1.00
2004.03.23
page 8 of 320
M306H3MC-XXXFP/FCFP
Table 1.5.2 Pin Description
Signal name
Function
Pin name
I/O type
I/O port P5
Input/output
P50 to P57
This is an 8-bit I/O port equivalent to P0. In single-chip mode, P57 in
this port outputs a divide-by-8 or divide-by-32 clock of XIN or a clock of
the same frequency as XCIN as selected by program.
Output
Input
Output
Input
WRL / WR,
WRH / BHE,
RD,
BCLK,
HLDA,
HOLD,
ALE,
RDY
Output WRL, WRH (WR and BHE), RD, BCLK, HLDA, and ALE
signals. WRL and WRH, and BHE and WR can be switched using
program.
WRL, WRH, and RD selected
With a 16-bit external data bus, data is written to even addresses
when the WRL signal is “L” and to the odd addresses when the WRH
signal is “L”. Data is read when RD is “L”.
WR, BHE, and RD selected
Data is written when WR is “L”. Data is read when RD is “L”. Odd
addresses are accessed when BHE is “L”. Use this mode when using
an 8-bit external data bus.
While the input level at the HOLD pin is “L”, the microcomputer is
level. ALE is used to latch the address. While the input level of the
RDY pin is “L”, the microcomputer is in the wait state.
placed in the hold state. While in the hold state, HLDA outputs a “L”
Input/output
Input
Input/output
I/O port P6
I/O port P7
I/O port P8
I/O port P85
I/O port P9
I/O port P10
P60 to P67
P70 to P77
P80 to P84,
P86,
P87,
P85
P90 to P97
P100 to P107
This is an 8-bit I/O port equivalent to P0. Pins in this port also function
as UART0 and UART1 I/O pins as selected by program.
This is an 8-bit I/O port equivalent to P0 (P70 and P71 are N channel
open-drain output). This port can function as input/output pins for timers
A0 to A3 when so selected in a program.
Furthermore, P70 to P75, P71, and P72 to P75 can also function as
input/output pins for UART2, an input pin for timer B5, and output pins
for the three-phase motor control timer, respectively.
This is an 8-bit I/O port equivalent to P0. Pins in this port also function
as SI/O3, 4 I/O pins, Timer B0 to B4 input pins, A-D converter extended
input pins, A-D trigger input pins, or remote control input pins as
selected by program.
This is an 8-bit I/O port equivalent to P0. Pins in this port also function
as A-D converter input pins as selected by program. Furthermore, P104
to P107 also function as input pins for the key input interrupt function.
P80 to P84, P86, and P87 are I/O ports with the same functions as P0.
When so selected in a program, P80 to P81 and P82 to P84 can function
as input/output pins for timer A4 or output pins for the three-phase
motor control timer and INT interrupt input pins, respectively. P86 and
P87, when so selected in a program, both can function as input/output
pins for the subclock oscillator circuit. In that case, connect a crystal
resonator between P86 (XCOUT pin) and P87 (XCIN pin).
P85 is an input-only port shared with NMI. An NMI interrupt is generated
when input on this pin changes state from high to low.
The NMI function cannot be disabled in a program.
A pull-up cannot be set for this pin.
Output port P11
P11
Output
This is a 1-bit output-only port. Pins in this port also function as
SLICEON output pins as selected by program.
相關PDF資料 |
PDF描述 |
|---|---|
| M306H5MG-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP116 |
| M306H5MG-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP116 |
| M306H5FGFP | 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP116 |
| M306N4FGVFP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 |
| M306N4MGT-XXXFP | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP100 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M306H3FCFP#U0 | 制造商:Renesas Electronics Corporation 功能描述:MCU 16BIT R8C CISC 128KB FLASH 5V 116LQFP - Trays |
| M306H3MC-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER |
| M306H5FGFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SNGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER |
| M306H5FGFP#U0 | 功能描述:IC M16C/6H MCU FLASH 116LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:M16C™ M16C/60 標準包裝:160 系列:S08 核心處理器:S08 芯體尺寸:8-位 速度:40MHz 連通性:I²C，LIN，SCI，SPI 外圍設備:LCD，LVD，POR，PWM，WDT 輸入/輸出數:53 程序存儲器容量:32KB（32K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1.9K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 12x12b 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:64-LQFP 包裝:托盤 |
| M306H5MC-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SNGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。