參數資料
型號： XE8000EV108
廠商： Semtech
文件頁數： 37/143頁
文件大小： 0K
描述： EVAL BOARD FOR XE8806/XE8807
標準包裝： 1
類型： MCU
適用于相關產品： XE88LC06AMI026
所含物品： 完全組裝的評估板
產品目錄頁面： 585 (CN2011-ZH PDF)
Semtech 2006
www.semtech.com
17-10
XE8806A/XE8807A
When the capture function is active, the A and B counters can either upcount or downcount. They do not count
circularly: they restart at zero or at the maximal value (either 0xFF when not cascaded or 0xFFFF when cascaded)
when respectively an overflow or an underflow condition occurs in the counting. The capture function is also active
on the counters when used to generate PWM signals.
CapFunc(1:0) in register RegCntConfig2 determines if the capture function is enabled or not and selects which
edges of the capture signal source are valid for the capture operation. The source of the capture signal can be
selected by setting CapSel(1:0) in the RegCntConfig2 register. For all sources, rising, falling or both edge
sensitivity can be selected. Table 17-15 shows the capture condition as a function of the setting of these
configuration bits.
CapSel(1:0)
Selected capture signal
CapFunc
Selected condition
Capture condition
11
1 K
00
01
10
11
Capture disabled
Rising edge
Falling edge
Both edges
-
1 K rising edge
1 K falling edge
2 K
10
16 K
00
01
10
11
Capture disabled
Rising edge
Falling edge
Both edges
-
16 K rising edge
16 K falling edge
32 K
01
PA3
00
01
10
11
Capture disabled
Rising edge
Falling edge
Both edges
-
PA3 rising edge
PA3 falling edge
PA3 both edges
00
PA2
00
01
10
11
Capture disabled
Rising edge
Falling edge
Both edges
-
PA2 rising edge
PA2 falling edge
PA2 both edges
Table 17-15: Capture condition selection
CapFunc(1:0) and CapSel(1:0) can be modified only when the counters are stopped otherwise data may be
corrupted during one counter clock cycle.
Due to the synchronization mechanism of the shadow registers and depending on the frequency ratio between the
capture and counter clocks, the interrupts may be generated one or only two counter clock pulses after the effective
capture condition occurred. When the counters A and B are not cascaded and do not operate on the same clock,
the interruptions on IrqA and IrqB which inform that the capture condition was met, may appear at different
moments. In this case, the processor should read the shadow register associated to a counter only if
the
interruption related to this counter has been detected.
An edge is detected on the capture signals only if the minimal pulse widths of these signals in the low and high
states are higher than a period of the counter clock source.
17.12 Specifications
Parameter
Min
Typ
Max
Unit
Conditions
500
ns
@ 1.2V
Pulse width in the low and high states for
an external clock source, frequency
division by 2 disabled
125
ns
@ 2.4V
100
ns
@ 1.2V
Pulse width in the low and high states for
an external clock source, frequency
division by 2 enabled
25
ns
@ 2.4V
Pulse width of external capture signals
1
fckcnt
s
Table 17-16: Timing specifications for the counters
相關PDF資料
PDF描述
94SVP476X0020E7 CAP ALUM 47UF 20V 20% SMD
EBC22DRTI-S13 CONN EDGECARD 44POS .100 EXTEND
AT-S-26-8/8/B-14-R MOD CORD STANDARD 8-8 BLACK 14'
LGU2E221MELZ CAP ALUM 220UF 250V 20% SNAP
VE-BT1-EY CONVERTER MOD DC/DC 12V 50W
相關代理商/技術參數
參數描述
XE8000EV110 功能描述:EVAL BOARD FOR XE8802AMI035LF RoHS:否 類別:編程器，開發系統 >> 通用嵌入式開發板和套件（MCU、DSP、FPGA、CPLD等） 系列:- 產品培訓模塊:Blackfin® Processor Core Architecture Overview Blackfin® Device Drivers Blackfin® Optimizations for Performance and Power Consumption Blackfin® System Services 特色產品:Blackfin? BF50x Series Processors 標準包裝:1 系列:Blackfin® 類型:DSP 適用于相關產品:ADSP-BF548 所含物品:板，軟件，4x4 鍵盤，光學撥輪，QVGA 觸摸屏 LCD 和 40G 硬盤 配用:ADZS-BFBLUET-EZEXT-ND - EZ-EXTENDER DAUGHTERBOARDADZS-BFLLCD-EZEXT-ND - BOARD EXT LANDSCAP LCD INTERFACE 相關產品:ADSP-BF542BBCZ-4A-ND - IC DSP 16BIT 400MHZ 400CSBGAADSP-BF544MBBCZ-5M-ND - IC DSP 16BIT 533MHZ MDDR 400CBGAADSP-BF542MBBCZ-5M-ND - IC DSP 16BIT 533MHZ MDDR 400CBGAADSP-BF542KBCZ-6A-ND - IC DSP 16BIT 600MHZ 400CSBGAADSP-BF547MBBCZ-5M-ND - IC DSP 16BIT 533MHZ MDDR 400CBGAADSP-BF548BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGAADSP-BF547BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGAADSP-BF544BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGAADSP-BF542BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGA
XE8000EV120 功能描述:BOARD EVAL FOR SX8722I070TRLF RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:ZoomingADC™ 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件
XE8000EV121 功能描述:BOARD EVAL FOR SX8723/24 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板
XE8000MP 功能描述:PROG BOARD AND PROSTART2 CARD RoHS:否 類別:編程器，開發系統 >> 獨立編程器 系列:- 產品目錄繪圖:CHIPPROG-G4 標準包裝:1 系列:- 類型:成組編程器 適用于相關產品:EEPROM，EPROM，F(xiàn)LASH，MCU，NVRAM，PLD 所含物品:編程器，線纜，CD 產品目錄頁面:598 (CN2011-ZH PDF) 相關產品:AE-TS56-16I-3-ND - ISP CABLEADAPTER 14-PIN HEADERAE-TS40N-ND - ADAPTER SOCKET 40-TSOP TO 40-DIPAE-TS32N-ND - ADAPTER SOCKET 32-TSOP TO 32-DIPAE-TS28-ND - ADAPTER SOCKET 28-TSOP TO 28-DIPAE-T44-P16-ND - ADAPTER SOCKET 44-QFP TO 40-DIPAE-T44-I51/505-ND - ADAPTER SOCKET 44-QFP TO 40-DIPAE-SS56-16I-ND - ADAPTER SOCKET 56-SSOP TO 40-DIPAE-SP8U-ND - ADAPTER SOCKET 8-SSOP TO 8-DIPAE-SP28U2-ND - ADAPTER SOCKET 28-SSOP TO 28-DIPAE-SP28U1-ND - ADAPTER SOCKET 28-SSOP TO 28-DIP更多...
XE8801A 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Data Acquisition with ZoomingADC?
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*