- 您現在的位置：買賣IC網 > PDF目錄368631 > TDA935X (NXP Semiconductors N.V.) TV signal processor-Teletext decoder with embedded m-Controller PDF資料下載
參數資料
| 型號： | TDA935X |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | TV signal processor-Teletext decoder with embedded m-Controller |
| 中文描述： | 電視信號處理器與嵌入式米圖文電視解碼器控制器 |
| 文件頁數： | 123/140頁 |
| 文件大?。?/td> | 570K |
| 代理商： | TDA935X |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁當前第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁
1999 Sep 28
123
Philips Semiconductors
Preliminary Device Specification
TV signal processor-Teletext decoder with
embedded
μ
-Controller
TDA935X/6X/8X series
36. To obtain a good performance for both weak signal and VCR playback the time constant of the first control loop is
switched depending on the input signal condition and the condition of the POC, FOA, FOB and VID bits in
subaddress 24H. The circuit contains a noise detector and the time constant is switched to ‘slow’ when too much
noise is present in the signal. In the ‘fast’ mode during the vertical retrace time the phase detector current is increased
50% so that phase errors due to head-switching of the VCR are corrected as soon as possible. Switching of the time
constant can be automatically or can be set by means of the control bits.
The circuit contains a video identification circuit which is independent of the first loop. This identification circuit can
be used to close or open the first control loop when a video signal is present or not present on the input. This enables
a stable On Screen Display (OSD) when just noise is present at the input.
To prevent that the horizontal synchronisation is disturbed by anti copy signals like Macrovision the phase detector
is gated during the vertical retrace period so that pulses during scan have no effect on the output voltage. The width
of the gate pulse is about 22
μ
s. During weak signal conditions (noise detector active) the gating is active during the
complete scan period and the width of the gate pulse is reduced to 5.7
μ
s so that the effect of noise is reduced to a
minimum.
The output current of the phase detector in the various conditions are shown in Table 122.
37. The ICs have 2 protection inputs. The protection on the second phase detector pin is intended to be used as ‘flash’
protection. When this protection is activated the horizontal drive is switched-off immediately and then switched-on
again via the slow start procedure.
The protection on the EHT input is intended for overvoltage (X-ray) protection. When this protection is activated the
horizontal drive is directly switched-off (via the slow stop procedure).
The EHT protection input can also be used to switch-off the TV receiver in a correct way when it is switched off via
the mains power switch or when the power supply is interrupted by pulling the mains plug. This can be realised by
means of a detection circuit which monitors the main supply voltage of the receiver. When this voltage suddenly
decreases the EHT protection input must be pulled HIGH and then the horizontal drive is switched off via the slow
stop procedure. Whether the EHT capacitor is discharged in the overscan or not during the switch-off period depends
on the setting of the OSO bit (subaddress 25H, D4). See also note 56.
38. The control range indicates the maximum phase difference at the top and the bottom of the screen. Compared with
the phase position at the centre of the screen the maximum phase difference at the top and the bottom of the screen
is
±
0.5
μ
s.
39. During switch-on the horizontal drive starts-up in a soft-start mode. The horizontal drive starts with a very short T
ON
time of the horizontal output transistor, the ‘off time’ of the transistor is identical to the ‘off time’ in normal operation.
The starting frequency during switch-on is therefore about 2 times higher than the normal value. The ‘on time’ is
slowly increased to the nominal value. When the nominal frequency is reached the PLL is closed in such a way that
only very small phase corrections are necessary. This ensures a safe operation of the output stage. The switch-on
characteristic is given in Fig.54
During switch-off the soft-stop function is active. This is realised by decreasing the T
ON
of the output transistor
complimentary to the start-up behaviour. The switch-off time is about 43 ms. The soft-stop procedure is synchronised
to the start of the first new vertical field after the reception of the switch-off command. Furthermore the EHT capacitor
of the picture tube is discharged with a fixed beam current which is forced by the black current loop. The discharge
time is about 38 ms. During switch-off the vertical scan is stopped so that the discharge takes place in the overscan.
The horizontal output is gated with the flyback pulse so that the horizontal output transistor cannot be switched-on
during the flyback time.
40. The vertical blanking pulse in the RGB outputs has a width of 26 or 21 lines (50 or 60 Hz system). The vertical pulse
in the sandcastle pulse has a width of 14 lines. This to prevent a phase distortion on top of the picture due to a timing
modulation of the incoming flyback pulse.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA936X | TV signal processor-Teletext decoder with embedded m-Controller |
| TDA938X | TV signal processor-Teletext decoder with embedded m-Controller |
| TDA9829T | Downconverter For DVB(下變頻器 （DVB應用）) |
| TDAT04622 | TDAT SONET/SDH 155/622/2488 Mbits/s Data Interfaces |
| TDAT042G51A-3BLL1 | TDAT SONET/SDH 155/622/2488 Mbits/s Data Interfaces |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA9380 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TDA938O超級芯片將微處理器(CPU)與TV信號處理器集成在一起 |
| TDA9383 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| TDA9400 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
| TDA9403 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
| TDA9500 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED CIRCUITS FOR TV AND RADIO RECEVERS |
發布緊急采購，3分鐘左右您將得到回復。