- 您現在的位置：買賣IC網 > PDF目錄383644 > MT90500 (Mitel Networks Corporation) Multi-Channel ATM AAL1 SAR(多通道 ATM AAL1分段及重組設備（基于通訊總線的系統與ATM網絡的接口）) PDF資料下載
參數資料
| 型號： | MT90500 |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | Multi-Channel ATM AAL1 SAR(多通道 ATM AAL1分段及重組設備（基于通訊總線的系統與ATM網絡的接口）) |
| 中文描述： | 多通道自動柜員機AAL1特區（多通道自動柜員機AAL1分段及重組設備（基于通訊總線的系統與空中交通管理網絡的接口）） |
| 文件頁數： | 73/159頁 |
| 文件大?。?/td> | 514K |
| 代理商： | MT90500 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁當前第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁
MT90500
73
A 4-bit RTS value is generated once every “period of the RTS” (T
N
). Since one RTS value is carried by the CSI
bits in each 8-cell sequence, the “period of the RTS” is the assembly time of 8 cells on the designated SRTS
VC. The SRTS Transmit Byte Counter Register at 60B2h contains the number of payload bytes within an 8-cell
sequence of the SRTS VC. The value in this register is used to divide the byte frequency f
B
to obtain the
“period of the RTS”. For pointerless AAL1 Structured Data Transfer, the number of bytes necessary to fill 8 cells
is 376 (8 cells @ 47 bytes per cell). In Nx64 AAL1 SDT, the number of bytes required to fill 8 cells varies
depending on the number of P-bytes sent within an 8-cell sequence, but it is generally set to 375 bytes (1 cell
of 46 TDM payload bytes plus 7 cells of 47 TDM payload bytes). The SRTS Transmit Divider Register shown in
Figure 33 generates a latch pulse which captures the value of a free-running counter clocked by the external
signal fnx (the network reference clock, input at the FNXI pin). The latched value is the four-bit residual time
stamp. Multiple latches (a 5-deep FIFO) are used to synchronize this clocking block with cell transmission
(controlled by the transmit event schedulers).
In order for the SRTS clock recovery method to operate correctly, the divided-down network clock, FNXI, must
be properly derived. As stated in I.363.1:
“For SDH and non-SDH physical layers, a clock at frequency f
8
= 8 kHz, synchronized to a common
network clock, is available from which clocks at frequencies
f
nx
= f
8
x (19440 / 2
k
) kHz, where k = 0,1,2,...,12
can be derived. This set of derived frequencies can accommodate all service rates from 64 kbps up to
the full capacity of the STM-1 payload. The exact value of f
nx
to be used is uniquely specified since the
frequency ratio is constrained by 1
≤
f
nx
/f
s
< 2.”
For example, to support N = 24 (f
S
= 1.536 MHz) or N = 32 (f
S
= 2.048 MHz), the derived network frequency will
be 2.430 MHz (8000 * 19440 / 2
6
). To support N = 1 (f
S
= 64 kbps), the derived network frequency will be
75.9375 kHz (8000 * 19440 / 2
11
).
In compliance with I.363.1, the MT90500 transmits the 4-bit RTS values in the serial bit stream provided by the
CSI bits of successive odd-sequence-numbered SAR-PDU headers (the even-numbered CSI bits are available
for other uses such as SDT pointers). The modulo-8 sequence count provides a frame structure over 8 bits in
this serial bit stream. The MSB of the RTS is placed in the CSI bit of the SAR-PDU header with a sequence
count of 1.
Due to the internal hardware design of the MT90500, the frequency of FNXI must be < MCLK / 3. This places
no restrictions on the SRTS VC as long as MCLK is greater than 30 MHz. Since the maximum structure size is
122 channels, the maximum value of f
S
= 7.808 MHz, and the maximum value of f
nx
is 9.72 MHz.
4
ATM Physical Layer
Network Clock
Divide by x
4-bit counter
f
nx
RTS
4
MULTIPLE
LATCHES
clk
data_in
TX_SAR
BLOCK
FNXI
enable
Byte Counter
CLKx1
period of the RTS
(one 8-cell cycle)
f
B
Gapping Control
f
B
Generator
SRTS Transmit Divider Register
f
B
= f
S
/ 8 = service byte clock
Internal to MT90500
Transmit
ATM Cells
w/ CSI b
its
Figure 33 - Transmit SRTS Operation
相關PDF資料 |
PDF描述 |
|---|---|
| MT90500 | Multi-Channel ATM AAL1 SAR |
| MT90500AL | Multi-Channel ATM AAL1 SAR |
| MT90502 | Multi-Channel AAL2 SAR(多通道 ATM AAL2分段及重組設備（基于通訊總線的系統與ATM網絡的接口）) |
| MT90732AP | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| MT90732 | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT90500AL | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:Multi-Channel ATM AAL1 SAR |
| MT90500AL-ENG1 | 制造商:Mitel Networks Corporation 功能描述: |
| MT90502 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Multi-Channel AAL2 SAR |
| MT90502_06 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Multi-Channel AAL2 SAR |
| MT90502AG | 制造商:Rochester Electronics LLC 功能描述: 制造商:Zarlink Semiconductor Inc 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。