- 您現在的位置：買賣IC網 > PDF目錄383134 > ISL5416EVAL1 (Intersil Corporation) Four-Channel Wideband Programmable DownConverter PDF資料下載
參數資料
| 型號： | ISL5416EVAL1 |
| 廠商： | Intersil Corporation |
| 英文描述： | Four-Channel Wideband Programmable DownConverter |
| 中文描述： | 四通道可編程寬帶下變頻器 |
| 文件頁數： | 20/71頁 |
| 文件大小： | 1128K |
| 代理商： | ISL5416EVAL1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁
20
Two NCOs and two counters set the sample rates through
the rate change section. NCO1 sets the output sample rate
of the resampling filter. NCO1 is 48 bits and is updated at the
clock rate, so its output frequency is:
Fout
1
= Fclk * N
1
/ 2
48
,
where N1 is the 48-bit programming word. The carry output
of the phase accumulator is used as the output clock, so
there can be one clock period of jitter. NCO2 is programmed
for the input sample rate to the resampler (equals the half-
band filter output rate). NCO2 is updated at the NCO1 output
rate. NCO2 controls the phase of the resampling filter. This
NCO also has a 48-bit phase accumulator. The equation for
programming the output frequency of NCO2 is:
Fout
2
= Fout
1
* N
2
/ 2
48
= Fclk * (N
1
/ 2
48
) * (N
2
/ 2
48
)
when the resampling filter is enabled and
Fout
2
= Fclk * N
2
/ 2
48
when the resampling filter is bypassed. NCO2 can have one
output sample period (Fout
1
period) of jitter (one clock
period when the HOIF is bypassed).
A static phase offset can be programmed for NCO2. The
range of the phase offset is 0 to 2 NCO2 output sample
periods (0 - 2 resampling filter input sample periods). The
programming resolution is 1/256 of a resampling filter input
sample period. This programmable offset allows the user
vary the group delay of one channel relative to another in
very fine increments to compensate for differences in system
delays.
If the resampler is not needed for rate change, it can be used
for phase shifting by setting bit 22 in IWA *001h.
While the 48-bit phase accumulators provide very good
frequency programming resolution, at some input/output
sample rate ratios, there will be a slow phase drift due to the
finite word length. To correct for this, a “l(fā)eap” counter is
provided to reset the phase of the NCOs after a programmed
interval to remove any accumulated error. The leap counter
is 32 bits. If properly programmed, this phase correction will
not be seen in the output of the part.
The input rate to the IHBF/RS section must match the output
sample rate of FIR2, i.e. the output rate of NCO2 must equal
the input sample rate of the part divided by the decimation
factors in the CIC, FIR1, and FIR2. The leap counter can
guarantees this over the long term, but due to the jitter of the
phase accumulator outputs, a FIFO is provided to guarantee
that there are no dropped samples. The FIFO is filled at the
output sample rate of the AGC and is emptied by Fout
2
(or
Fout
2
/2 if the IHBF is enabled). After reset, the FIFO is filled
to a depth of two before the NCOs are enabled. This
minimum fill depth guarantees that there are enough
samples in the FIFO that the FIFO never empties or
overflows due to NCO jitter if the NCOs and leap counter are
properly programmed. FIFO reads are enabled after an
0
0.5
1
1.5
2
2.5
3
x 10
7
-80
-70
-60
-50
-40
-30
-20
-10
0
10
FIGURE 7D. INDIVIDUAL AND COMPOSITE
RESPONSES (FIR2 OUTPUT AT 7.68 MHz WITH IHBF,
INTERPOLATE BY 2 AND RE-SAMPLER, INTERPOLATE BY 2
0
5
10
15
x 10
6
-80
-70
-60
-50
-40
-30
-20
-10
0
10
FIGURE 7E. FIR2 AND IHBF COMPOSITE RESPONSE
0
0.5
1
1.5
2
2.5
3
x 10
7
-80
-70
-60
-50
-40
-30
-20
-10
0
10
FIGURE 7F. FIR2, IHBF AND RESAMPLER COMPOSITE
RESPONSE
ISL5416
相關PDF資料 |
PDF描述 |
|---|---|
| ISL5416KIZ | Four-Channel Wideband Programmable DownConverter |
| ISL54200_07 | USB 2.0 High/Full Speed Multiplexer |
| ISL54200IRUZ-T | USB 2.0 High/Full Speed Multiplexer |
| ISL54200 | USB 2.0 High/Full Speed Multiplexer |
| ISL54200IRZ | USB 2.0 High/Full Speed Multiplexer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL5416KI | 功能描述:上下轉換器 QUAD WIDEBAND DOWN CONVERTER, 256 CABGA RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128 |
| ISL5416KIZ | 制造商:Intersil Corporation 功能描述:LEAD-FREE QUAD WIDEBAND DOWN CONVERTER, 256 CABGA - Trays 制造商:Intersil Corporation 功能描述:PB-FREE W/ANNEAL QUAD DIGITAL DOWNCONVER 制造商:Intersil 功能描述:QD WIDEB& DWN CNVRTR 256 CABGA |
| ISL54200 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:USB 2.0 High/Full Speed Multiplexer |
| ISL54200_07 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:USB 2.0 High/Full Speed Multiplexer |
| ISL54200EVAL1Z | 功能描述:EVALUATION BOARD FOR ISL54200 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口，收發器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板 |
發布緊急采購，3分鐘左右您將得到回復。