參數資料
型號: GS9090
廠商: Gennum Corporation
英文描述: GS9090 GenLINX-R III 270Mb/s Deserializer for SDI and DVB-ASI
中文描述: GS9090 GenLINX - R的第三270Mb / s的SDI和DVB解串器,意大利航天局
文件頁數: 26/70頁
文件大?。?/td> 696K
代理商: GS9090
GS9090 Data Sheet
28201 - 1
July 2005
26 of 70
3.6.1 SMPTE Descrambling and Word Alignment
After serial-to-parallel conversion, the internal 10-bit data bus is fed to the SMPTE
descramble and word alignment internal block. The function of this block is to carry
out NRZI-to-NRZ decoding, descrambling according to SMPTE 259M-C, and word
alignment of the data to the TRS sync words.
NOTE: When 8-bit data is embedded in the 10-bit SMPTE signal, the two LSBs
(DOUT[1:0]) must be set to zero for word alignment to work correctly.
Word alignment occurs when two consecutive valid TRS words (SAV and EAV
inclusive) with the same bit alignment have been detected (1 video line).
In normal operation, re-synchronization of the word alignment process will only
take place when two consecutive identical TRS word positions have been
detected. When automatic or manual switch line lock handling occurs (see
Switch
Line Lock Handling on page 27
), word alignment re-synchronization will occur on
the next received TRS code word.
The device will drop out of SMPTE mode, only after 6 consecutive missing TRS
timing words.
3.6.2 Internal Flywheel
The GS9090 has an internal flywheel for the generation of internal / external timing
signals, the detection and correction of certain error conditions, and the automatic
detection of video standards. The flywheel is only operational in SMPTE mode.
The flywheel 'learns' the video standard by monitoring the horizontal and vertical
reference information contained in the TRS ID words of the received video stream.
Full synchronization of the flywheel to the received video standard therefore
requires one complete video frame.
Once synchronization has been achieved, the flywheel will continue to monitor the
received TRS timing information to maintain synchronization.
The FW_EN input pin controls the synchronization mechanism of the flywheel.
When this input signal is LOW, the flywheel will re-synchronize all pixel and line
based counters on every received TRS ID word.
When FW_EN is held HIGH, re-synchronization of the pixel and line based
counters will take place after 3 consecutive video lines with identical TRS timing
are identified. This provides a measure of noise immunity for output timing signal
generation.
The flywheel will be disabled should the LOCKED signal or RESET signal be LOW.
This will occur regardless of the setting of the FW_EN pin.
相關PDF資料
PDF描述
GS9090-CNE3 GS9090 GenLINX-R III 270Mb/s Deserializer for SDI and DVB-ASI
GS9092A GS9092A GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI
GS9092ACNE3 GS9092A GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI
GS9092 GS9092 GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI
GS9092-CNE3 GS9092 GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI
相關代理商/技術參數
參數描述
GS9090A 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GS9090A GenLINX-R III 270Mb/s Deserializer for SDI
GS9090A_10 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GenLINX III 270Mb/s Deserializer
GS9090ACNE3 制造商:Semtech Corporation 功能描述:270Mb/s Deserializer 56-Pin QFN EP 制造商:Semtech Corporation 功能描述:270Mb/s Deserializer for SDI & ASI
GS9090B 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GenLINX III 270Mb/s Deserializer for SDI
GS9090B_10 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GenLINX III 270Mb/s Deserializer for SDI