- 您現在的位置：買賣IC網 > PDF目錄385344 > GS9090 (Gennum Corporation) GS9090 GenLINX-R III 270Mb/s Deserializer for SDI and DVB-ASI PDF資料下載
參數資料
| 型號： | GS9090 |
| 廠商： | Gennum Corporation |
| 英文描述： | GS9090 GenLINX-R III 270Mb/s Deserializer for SDI and DVB-ASI |
| 中文描述： | GS9090 GenLINX - R的第三270Mb / s的SDI和DVB解串器，意大利航天局 |
| 文件頁數： | 56/70頁 |
| 文件大?。?/td> | 696K |
| 代理商： | GS9090 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁當前第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁
GS9090 Data Sheet
28201 - 1
July 2005
56 of 70
3.11.2 Parallel Output in SMPTE Mode
When the device is operating in SMPTE mode (see
SMPTE Functionality on
page 25
), SD data is presented to the output bus in multiplexed format. The data
will be output on the DOUT[9:0] pins and word aligned according to TRS ID words.
3.11.3 Parallel Output in DVB-ASI Mode
When operating in DVB-ASI mode (see
DVB-ASI Functionality on page 29
), the
extracted 8-bit data words will be presented on DOUT[7:0] such that DOUT7 =
HOUT is the most significant bit of the decoded transport stream data and DOUT0
= AOUT is the least significant bit.
In addition, DOUT9 and DOUT8 will be configured as the DVB-ASI status signals
WORDERR and SYNCOUT respectively. See
Status Signal Outputs on page 29
for a description of these DVB-ASI specific output signals.
3.11.4 Parallel Output in Data-Through Mode
When operating in Data-Through mode (see
Data-Through functionality on
page 29
), the GS9090 presents data to the output data bus without performing any
decoding, descrambling, or word-alignment.
As described in
Data-Through functionality on page 29
, the data bus outputs will
be forced to logic LOW if the device is set to operate in Auto mode but cannot
identify SMPTE TRS ID or DVB-ASI sync words in the input data stream.
3.12 Programmable Multi-Function Outputs
The GS9090 has a multi-function output port that uses 4 pins, STAT0 through
STAT3. Each pin can be programmed via the host interface to output one of the
following signals: H, V, F, FIFO_LD, ANC_DETECT, EDH_DETECT, FIFO_FULL,
and FIFO_EMPTY.
Table 3-17: Output Signals Available on Multi-Function Output Ports
Output Status Signal
Reference
H
HVF Timing Signal Generation on page 28
V
HVF Timing Signal Generation on page 28
F
HVF Timing Signal Generation on page 28
FIFO_LD
FIFO Load Pulse on page 30
ANC_DETECT
Ancillary Data Detection and Indication on
page 31
EDH_DETECT
EDH Packet Detection on page 33
FIFO_FULL
Reading From the FIFO on page 48
FIFO_EMPTY
Reading From the FIFO on page 48
相關PDF資料 |
PDF描述 |
|---|---|
| GS9090-CNE3 | GS9090 GenLINX-R III 270Mb/s Deserializer for SDI and DVB-ASI |
| GS9092A | GS9092A GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| GS9092ACNE3 | GS9092A GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| GS9092 | GS9092 GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
| GS9092-CNE3 | GS9092 GenLINX-R III 270Mb/s Serializer for SDI and DVB-ASI |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS9090A | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GS9090A GenLINX-R III 270Mb/s Deserializer for SDI |
| GS9090A_10 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GenLINX III 270Mb/s Deserializer |
| GS9090ACNE3 | 制造商:Semtech Corporation 功能描述:270Mb/s Deserializer 56-Pin QFN EP 制造商:Semtech Corporation 功能描述:270Mb/s Deserializer for SDI & ASI |
| GS9090B | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GenLINX III 270Mb/s Deserializer for SDI |
| GS9090B_10 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GenLINX III 270Mb/s Deserializer for SDI |
發布緊急采購，3分鐘左右您將得到回復。