參數資料
型號： ST7FLU05MAE
廠商： STMICROELECTRONICS
元件分類： 微控制器/微處理器
英文描述： 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PDSO8
封裝： 0.150 INCH, LEAD FREE, PLASTIC, SOP-8
文件頁數： 46/124頁
文件大?。?/td> 2186K
代理商： ST7FLU05MAE
Obsolete
Product(s)
- Obsolete
Product(s)
Supply, reset and clock management
ST7LUS5, ST7LU05, ST7LU09
28/124
Caution:
If the voltage or temperature conditions change in the application, the frequency may need
to be recalibrated.
Refer to application note AN2326 for information on how to calibrate the RC frequency using
an external reference signal.
The ST7LUxx also contains an auto wake-up RC oscillator. This RC oscillator should be
enabled to enter auto wake-up from halt mode.
The auto wake-up RC oscillator can also be configured as the startup clock through the
CKSEL[1:0] option bits (see Section 14.1 on page 131).
This is recommended for applications where very low power consumption is required.
Switching from one startup clock to another can be done in run mode as follows (see
Figure 12):
Case 1: Switching from internal RC to AWU
1.
Set the RC/AWU bit in the CKCNTCSR register to enable the AWU RC oscillator.
2.
The RC_FLAG is cleared and the clock output is at 1.
3.
Wait 3 AWU RC cycles until the AWU_FLAG is set.
4.
The switch to the AWU clock is made at the positive edge of the AWU clock signal.
5.
Once the switch is made, the internal RC is stopped.
Case 2: Switching from AWU RC to internal RC
1.
Reset the RC/AWU bit to enable the internal RC oscillator.
2.
Using a 4-bit counter, wait until 8 internal RC cycles have elapsed. The counter is
running on internal RC clock.
3.
Wait until the AWU_FLAG is cleared (1 AWU RC cycle) and the RC_FLAG is set (2 RC
cycles).
4.
The switch to the internal RC clock is made at the positive edge of the internal RC clock
signal.
5.
Once the switch is made, the AWU RC is stopped.
Note:
1
When the internal RC is not selected, it is stopped so as to save power consumption.
2
When the internal RC is selected, the AWU RC is turned on by hardware when entering
Auto Wake-up from Halt mode.
3
When the external clock is selected, the AWU RC oscillator is always on.
Figure 9.
Clock switching
AWU RC
Set RC/AWU
Poll AWU_FLAG until set
Internal RC
Reset RC/AWU
Poll RC_FLAG until set
AWU RC
Internal RC
相關PDF資料
PDF描述
ST7LNB0V2Y0M6 8-BIT, 8 MHz, MICROCONTROLLER, PDSO16
ST7LNB1Y0M6 8-BIT, EEPROM, 8 MHz, MICROCONTROLLER, PDSO16
ST7PL05Y0MB/XXXTRE 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDSO16
ST7PL05Y0MB 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDSO16
ST7PLITE05F0U6TR 8-BIT, MROM, 16 MHz, MICROCONTROLLER, QCC20
相關代理商/技術參數
參數描述
ST7FLU09MCE 制造商:STMicroelectronics 功能描述:
ST7FMC1K2B3 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-bit MCU with nested interrupts, Flash, 10-bit ADC, brushless motor control, five timers, SPI, LINSCI?
ST7FMC1K2B6 功能描述:8位微控制器 -MCU 8 BITS MICROCONTR RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ST7FMC1K2T3 功能描述:8位微控制器 -MCU ST7MC1/ST7MC2 8B MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ST7FMC1K2T6 功能描述:8位微控制器 -MCU 8K Flash 384 RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*