- 您現在的位置：買賣IC網 > PDF目錄382553 > ST7FLCD1 (意法半導體) 8-bit MCU for LCD Monitors with 60 KBytes Flash, 2 KBytes RAM, 2 DDC Ports and Infrared Controller PDF資料下載
參數資料
| 型號： | ST7FLCD1 |
| 廠商： | 意法半導體 |
| 英文描述： | 8-bit MCU for LCD Monitors with 60 KBytes Flash, 2 KBytes RAM, 2 DDC Ports and Infrared Controller |
| 中文描述： | 8位微控制器的液晶顯示器為60千字節閃存，2千字節RAM，2個DDC的港口和紅外線控制器 |
| 文件頁數： | 66/95頁 |
| 文件大?。?/td> | 633K |
| 代理商： | ST7FLCD1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁當前第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁
Display Data Channel Interfaces (DDC)
ST7FLCD1
66/95
Read and Write Operations
After each byte transfer, the internal address counter automatically increments. If the counter is
pointing to the top of the structure, it rolls over to the bottom since the increment is performed only
on the 7 or 8 LSBs of the pointer depending on the selected data structure size. It rolls over from
7Fh to 00h or from FFh to 80h depending on the MSB of the last data address received.
Then after that last byte has been effectively written or read in RAM at LSB address 7Fh or FFh, the
EDF flag is set and an interrupt is generated if EDE is set.
The transfer is terminated by the master generating a STOP condition.
11.5
DDC/CI Factory Alignment Interface
Refer to the CR, SR1 and SR2 registers in
Section 11.7: Register Description
for the bit definitions.
The DDC/CI interface works as an I/O interface between the microcontroller and the DDC2Bi,
HDCP, E-DDC or Factory alignment protocols. It receives and transmits data in Slave I2C mode
using an interrupt or polled handshaking.
The interface is connected to the I2C bus through a data pin (SDAD) and a clock pin (SCLD)
configured as an open-drain output.
The DDC/CI interface has five internal register locations. Two of them are used to initialize the
interface:
1. 2 Own Address Registers OAR1 and OAR2
2. Control register CR
The following four registers are used during data transmission/reception:
1. Data Register DR
2. Control Register CR
3. Status Register 1 SR1
4. Status Register 2 SR2
The interface decodes an I2C or DDC2Bi address stored by software in either OAR register and/or
the DDC/CI address (6Eh/6Fh) as its default hardware address.
After a reset, the interface is disabled.
11.5.1 I2C Modes
The interface operates in Slave Transmitter/Receiver modes.
The master generates both Start and Stop conditions. The I2C clock (SCL) is always received by the
interface from a master, but the interface is able to stretch the clock line.
The interface can recognize its two programmable addresses (7-bit) and its default hardware
address (DDC/CI address: 6Eh/6Fh). The DDC/CI address detection may be enabled or disabled by
software. It never recognizes the Start byte (01h) whatever its own address is.
Slave mode
As soon as a start condition is detected, the address is received from the SDA line and sent to the
shift register where it is compared to the programmable addresses or to the DDC/CI address (if
selected by software).
Address not matched
: the interface ignores it and waits for another Start condition.
Address matched
: the following events occur in sequence:
相關PDF資料 |
PDF描述 |
|---|---|
| ST7FLIT19B | 8-Bit MCU With Single Voltage Flash Memory, Data EEPROM, ADC, 5 Timers, SPI(內部RC,PLL,ADC,ROP,ICP, IAP,SPI的8位MCU) |
| ST7FLITE10F1B6 | 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 4 TIMERS, SPI |
| ST7FLITE19F1M6 | CLUSTER PANEL,RJ-11 W/ (12) 4- |
| ST7LITE1 | 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 4 TIMERS, SPI |
| ST7FLITE15F1B6 | 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 4 TIMERS, SPI |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST7FLCD1_05 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-bit MCU for LCD Monitors with 60 KBytes Flash,2 KBytes RAM, 2 DDC Ports and Infrared Controller |
| ST7FLI15BF1U6 | 功能描述:8位微控制器 -MCU 8-Bit MCU w/ Single Volt Flash RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| ST7FLI15BF1U6TR | 功能描述:8位微控制器 -MCU 8 BITS MICROCONTR RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| ST7FLI19BF1M3TR | 功能描述:8位微控制器 -MCU 8 BITS MICROCONTR RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| ST7FLI19BF1U6TR | 功能描述:8位微控制器 -MCU 8-Bit MCU w/ Single Volt Flash RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。