- 您現在的位置：買賣IC網 > PDF目錄367801 > PC8245 (Atmel Corp.) Integrated Processor Family PDF資料下載
參數資料
| 型號： | PC8245 |
| 廠商： | Atmel Corp. |
| 英文描述： | Integrated Processor Family |
| 中文描述： | 綜合處理器系列 |
| 文件頁數： | 10/61頁 |
| 文件大?。?/td> | 429K |
| 代理商： | PC8245 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁
10
PC8245
2171D–HIREL–06/04
3. This pin has an internal pull-up resistor which is enabled only when the PC8245 is in the reset state. The value of the inter-
nal pull-up resistor is not guaranteed, but is sufficient to ensure that a logic 1 is read into configuration bits during reset.
4. This pin is a reset configuration pin.
5. DL[0] is a reset configuration pin and has an internal pull-up resistor which is enabled only when the PC8245 is in the reset
state. The value of the internal pull-up resistor is not guaranteed, but is sufficient to ensure that a logic 1 is read into config-
uration bits during reset.
6. Multi-pin signals such as AD[31:0] or MDL[0:31] have their physical package pin numbers listed in order, corresponding to
the signal names. Example: AD0 is on pin C22, AD1 is on pin D22, ..., AD31 is on pin V25.
7. GNT4 is a reset configuration pin and has an internal pull-up resistor which is enabled only when the PC8245 is in the reset
state.
8. Recommend a weak pull-up resistor (2 k
–
10 k
) be placed on this PCI control pin to LV
DD
.
9. V
IH
and V
IL
for these signals are the same as the PCI V
IH
and V
IL
entries in Table 4 on page 23.
10. Recommend a weak pull-up resistor (2 k
–
10 k
) be placed on this pin to OV
DD
.
11. Recommend a weak pull-up resistor (2 k
–
10 k
) be placed on this pin to GV
DD
.
12. This pin has an internal pull-up resistor which is enabled at all times. The value of the internal pull-up resistor is not guaran-
teed, but is sufficient to prevent unused inputs from floating.
13. External PCI clocking source or fan-out buffer may be required for system if using the PC8245 DUART functionality since
PCI_CLK[0:3] are not available in DUART mode. Only PCI_CLK4 is available in DUART mode.
14. This pin is a multiplexed signal and appears more than once in this table.
15. This pin is affected by programmable PCI_HOLD_DEL parameter.
16. This pin is an open drain signal.
17. This pin can be programmed to be driven (default) or can be programmed (in PMCR2) to be open drain.
18. This pin is a sustained three-state pin as defined by the PCI Local Bus Specification.
19. OSC_IN utilizes the 3.3V PCI interface driver which is 5V tolerant, see Table “Recommended Operating Conditions” on page
12 for details.
20. PLL_CFG[0:4] signals are sampled a few clocks after the negation of HRST_CPU and HRST_CTRL.
21. SDRAM_CLK[0:3] and SDRAM_SYNC_OUT signals use DRV_MEM_CTRL for chip Rev 1.1 (A). These signals use
DRV_MEM_CLK for chip Rev 1.2 (B).
22. The 266 and 300 MHz part offerings can be ran at a source voltage of 1.8 ± 100 mV or 2.0 ± 100 mV. Note that source volt-
age should be 2.0 ± 100 mV for 333- and 350-MHz parts.
23. This pin was formally LAVDD on the PC8240. It is a no connect on the PC8245. This should not pose a problem when
replacing an PC8240 with an PC8245.
24. The driver capability of this pin is hardwired to 40
and cannot be changed.
相關PDF資料 |
PDF描述 |
|---|---|
| PC8245MTPU300D | Integrated Processor Family |
| PC8245MTPU333D | Integrated Processor Family |
| PC824A | NPN-OUTPUT DC-INPUT OPTOCOUPLER |
| PC844A | NPN-OUTPUT AC-INPUT OPTOCOUPLER |
| PC844X | PHOTOCOUPLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PC8245MTPU300D | 制造商:e2v Aerospace & Defense 功能描述:MPU MPC82xx RISC 32-Bit 0.25um 300MHz 3.3V 352-Pin TBGA 制造商:e2v technologies 功能描述:MPU MPC82XX RISC 32BIT 0.25UM 300MHZ 3.3V 352TBGA - Trays |
| PC8245MTPU333D | 制造商:e2v Aerospace & Defense 功能描述:MPU MPC82xx RISC 32-Bit 0.25um 333MHz 3.3V 352-Pin TBGA 制造商:e2v technologies 功能描述:MPU MPC82XX RISC 32BIT 0.25UM 333MHZ 3.3V 352TBGA - Trays |
| PC8245MTPU350D | 制造商:e2v technologies 功能描述:PC8245MTPU350D - Trays |
| PC824A | 功能描述:PHOTOCOUPLER 2CH AC INPUT 8-DIP RoHS:否 類別:隔離器 >> 光隔離器 - 晶體管，光電輸出 系列:- 標準包裝:1,000 系列:- 通道數:2 輸入類型:DC 電壓 - 隔離:2500Vrms 電流傳輸比（最小值）:7% @ 16mA 電流傳輸比（最大）:50% @ 16mA 輸出電壓:20V 電流 - 輸出 / 通道:8mA 電流 - DC 正向(If):25mA Vce飽和（最大）:- 輸出類型:有 Vcc 的晶體管 安裝類型:通孔 封裝/外殼:8-DIP（0.400"，10.16mm） 包裝:管件 其它名稱:HCPL-2530W |
| PC825 | 功能描述:PHOTOCOUPLER 2CH DARL OUT 8-DIP RoHS:否 類別:隔離器 >> 光隔離器 - 晶體管，光電輸出 系列:- 標準包裝:1,000 系列:- 通道數:2 輸入類型:DC 電壓 - 隔離:2500Vrms 電流傳輸比（最小值）:7% @ 16mA 電流傳輸比（最大）:50% @ 16mA 輸出電壓:20V 電流 - 輸出 / 通道:8mA 電流 - DC 正向(If):25mA Vce飽和（最大）:- 輸出類型:有 Vcc 的晶體管 安裝類型:通孔 封裝/外殼:8-DIP（0.400"，10.16mm） 包裝:管件 其它名稱:HCPL-2530W |
發布緊急采購，3分鐘左右您將得到回復。