- 您現在的位置：買賣IC網 > PDF目錄245657 > W25Q64BVSSIG (WINBOND ELECTRONICS CORP) 8M X 8 SPI BUS SERIAL EEPROM, PDSO8 PDF資料下載
參數資料
| 型號： | W25Q64BVSSIG |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | PROM |
| 英文描述： | 8M X 8 SPI BUS SERIAL EEPROM, PDSO8 |
| 封裝： | 0.208 INCH, GREEN, PLASTIC, SOIC-8 |
| 文件頁數： | 33/61頁 |
| 文件大?。?/td> | 1726K |
| 代理商： | W25Q64BVSSIG |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁
W25Q64BV
Publication Release Date: July 08, 2010
- 39 -
Revision E
11.2.21 Erase Suspend (75h)
The Erase Suspend instruction “75h”, allows the system to interrupt a Sector or Block Erase operation
and then read from or program data to, any other sectors or blocks. The Erase Suspend instruction
sequence is shown in figure 21.
The Write Status Register instruction (01h) and Erase instructions (20h, 52h, D8h, C7h, 60h) are not
allowed during Erase Suspend. Erase Suspend is valid only during the Sector or Block erase operation. If
written during the Chip Erase or Program operation, the Erase Suspend instruction is ignored.
The Erase Suspend instruction “75h” will be accepted by the device only if the SUS bit in the Status
Register equals to 0 and the BUSY bit equals to 1 while a Sector or Block Erase is on-going. If the SUS
bit equals to 1 or the BUSY bit equals to 0, the Suspend instruction will be ignored by the device. A
maximum of time of “tSUS” (See AC Characteristics) is required to suspend the erase operation. The
BUSY bit in the Status Register will be cleared from 1 to 0 within “tSUS” and the SUS bit in the Status
Register will be set from 0 to 1 immediately after Erase Suspend. For a previously resumed Erase
operation, it is also required that the Suspend instruction “75h” is not issued earlier than a minimum of
time of “tSUS” following the preceding Resume instruction “7Ah”.
Unexpected power off during the Erase suspend state will reset the device and release the suspend
state. SUS bit in the Status Register will also reset to 0. The data within the sector or block that was being
suspended may become corrupted. It is recommended for the user to implement system design
techniques against the accidental power interruption and preserve data integrity during erase suspend
state.
Figure 21. Erase Suspend Instruction Sequence
相關PDF資料 |
PDF描述 |
|---|---|
| WE128K8-250CCA | EEPROM 5V MODULE, CDIP32 |
| W25Q16CVTCAG | 16M X 1 SPI BUS SERIAL EEPROM, PBGA24 |
| WF2M32S-100HM | 8M X 8 FLASH 5V PROM MODULE, 100 ns, CHIP66 |
| WF2M32S-100HC | 8M X 8 FLASH 5V PROM MODULE, 100 ns, CHIP66 |
| WF2M32S-120GTC | 8M X 8 FLASH 5V PROM MODULE, 120 ns, CQFP68 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W25Q64BVSSIGTR | 制造商:Winbond Electronics Corp 功能描述:SPIFLASH, 64M-BIT, 4KB UNIFORM |
| W25Q64BVSSIP | 制造商:WINBOND 制造商全稱:Winbond 功能描述:64M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI |
| W25Q64BVZEIG | 功能描述:IC SPI FLASH 64MBIT 8WSON RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:SpiFlash® 標準包裝:1,000 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:4K (512 x 8) 速度:400kHz 接口:I²C，2 線串口 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.173"，4.40mm 寬） 供應商設備封裝:8-MFP 包裝:帶卷 (TR) |
| W25Q64BVZEIP | 制造商:WINBOND 制造商全稱:Winbond 功能描述:64M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI |
| W25Q64CV | 制造商:WINBOND 制造商全稱:Winbond 功能描述:3V 64M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI |
發布緊急采購，3分鐘左右您將得到回復。