參數資料
型號: MC68HC05JB4DWR2
廠商: MOTOROLA INC
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 3 MHz, MICROCONTROLLER, PDSO28
封裝: SOIC-28
文件頁數: 110/134頁
文件大小: 1305K
代理商: MC68HC05JB4DWR2
February 24, 1999
GENERAL RELEASE SPECIFICATION
MC68HC05JB4
UNIVERSAL SERIAL BUS MODULE
MOTOROLA
REV 2
10-11
USB registers. The following will detail the function of the regulator, transceiver
and control logic. See Section 10.5 for the register discussion.
10.4.1 Voltage Regulator
The USB data lines are required by the USB Specication to have a maximum
output voltage between 2.8V and 3.6V. The data lines are also required to have an
external 1.5K
pullup resistor connected between a data line and a voltage
source between 3.0V and 3.6V. Since the power provided by the USB cable is
specied to be between 4.4V and 5.0V, an on-chip regulator is used to drop the
voltage to the appropriate level for sourcing the USB transceiver and external
pullup resistor. An output pin driven by the regulator voltage is provided to source
the 1.5K
external resistor. Figure 10-11 shows the worst case electrical
connection for the voltage regulator.
Figure 10-11. Regulator Electrical Connections
10.4.2 USB Transceiver
The USB transceiver provides the physical interface to the USB D+ and D– data
lines. The transceiver is composed of two parts: an output drive circuit and a
differential receiver.
10.4.2.1 Output Driver Characteristics
The USB transceiver uses a differential output driver to drive the USB data signal
onto the USB cable. The static output swing of the driver in its low state is below
the VOL of 0.3 V with a 1.5 k load to 3.6 V and in its high state is above the VOH
of 2.8 V with a 15 k
load to ground. The output swings between the differential
high and low state are well balanced to minimize signal skew. Slew rate control on
the driver is used to minimize the radiated noise and cross talk. The driver’s
outputs support three-state operation to achieve bi-directional half duplex
operation. The driver can tolerate a voltage on the signal pins of –0.5 V to 3.8 V
LS
Transceiver
3.3V
R2
R1
R1 = 1.5K
±5%
R2 = 15K
±5%
Regulator
USB Data Lines
Host
or
Hub
USB Cable
4.4V
相關PDF資料
PDF描述
MC68HC705JB4DWR2 8-BIT, OTPROM, 3 MHz, MICROCONTROLLER, PDSO28
MC68HC05L11PU 8-BIT, MROM, 3.69 MHz, MICROCONTROLLER, PQFP100
MC68HC05P7P 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP28
MC68HC05SB7 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO28
MC68HC705SB7 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PDSO28
相關代理商/技術參數
參數描述
MC68HC05JJ6 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification Microcontrollers
MC68HC05JJ6CDW 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification Microcontrollers
MC68HC05JJ6CDWE 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification Microcontrollers
MC68HC05JJ6CP 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification Microcontrollers
MC68HC05JJ6CPE 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification Microcontrollers